A practical Equivalent Electrical Circuit model for Proton Exchange Membrane Fuel Cell (PEMFC) systems

An alternative Equivalent Electrical Circuit for Proton Exchange Membrane Fuel Cells is modelled in this study. Both I–V characteristics and H₂ consumptions corresponding to generated power under load and no-load conditions are investigated. For this purpose, H₂ consumptions and I–V characteristics of three different sized PEMFCs are tested. There is a very good harmony between the model results and measured values (relative error %0.7, %6.4 and %2.5 for FC-A, FC-B and FC-C respectively). In the proposed model current passes only on parallel resistance and not on serial resistance at no-load condition. Thus, a FC with higher parallel resistance should be preferred. Another key output of this study is that based on the proposed model, performance comparison of FCs can be performed with the parameters defined in this work. Proposals made in this study can easily be used for performance analysis of FCs under for both steady state and transient analysis.     

Partitioning of predominant lipophilic bioactives (squalene, α-tocopherol and β-sitosterol) during olive oil processing

The partitioning of predominant lipophilic olive bioactives (squalene, β-sitosterol and α-tocopherol) in olive oil processing was studied for the first time using common integrated olive milling plant. 7% of the oil and 5% of the squalene present in the olives was lost in the last pomace. β-sitosterol and α-tocopherol, which are mainly concentrated in the seed of the olive fruit, was recovered in virgin olive oil to a lesser extent (66%, 67%) while 10% were lost in last pomace. Thus, the loss of β-sitosterol and α-tocopherol was higher than that of squalene and oil, due to nonrecovered bound forms. 19% of the α-tocopherol and 21% of the β-sitosterol loss was unaccounted for, which can be attributed to degradation of α-tocopherol and incomplete recovery of sterols from the olive and pomace matrices. This study provides a basis for process development studies.     

Replacement of beef fat in Frankfurters by interesterified palm,cottonseed and olive oils

Three interesterified vegetable oils (IVOs) prepared from palm, cottonseed, and olive oil, respectively, have been studied for application to Frankfurters. Beef fat (10%) was replaced by one of the IVOs at 20, 60 or 100%. Fatty acid composition of the lipid fraction in the Frankfurters and saturated/unsaturated ratios were established for all batches. We found that total or partial replacement of beef fat by IVOs did not lead to significant changes in appearance, colour, texture, flavour or sensory score. We conclude that IVOs may be successfully applied as beef fat substitutes in Frankfurters.     

Optimal design of elastic beams with segmentwise constant height in the case of dynamic loading

A shape optimization method for elastic beams with segmentwise constant height is proposed. The ends of the beam are simply supported, clamped or free. Two problems are discussed; (i) a beam is loaded by lateral pressure, (ii) a beam is struck by an attached mass. External loads and volume of the beam are prescribed and the deflection in a given cross-section is to be minimized. For solving this problem, the deflections are expanded into a Fourier series by eigenfunctions. Numerical results are given for two-, three- and four-stepped beams.     

Rectus abdominis muscle flap (RAMF) technique for the management of bladder exstrophies: late clinical outcome and urodynamic findings

OBJECTIVE: To investigate the efficacy of the rectus abdominis muscle flap (RAMF) technique for the closure and augmentation of small, non-compliant bladder exstrophies. PATIENTS AND METHODS: The RAMF technique was used in two girls and two boys (mean age at operation, 31.7 months, range 3-72) with bladder exstrophy. The clinical outcome and urodynamics were assessed during a follow-up of 29 months to 6 years (mean 49.2 months) and included imaging, cystoscopy, biochemical and microbiological studies. RESULTS: There were no urinary tract infections, metabolic problems or electrolyte disturbances and kidney function remained normal in all patients. Radiography confirmed intact function and anatomy of the urinary tract and cystoscopy showed complete coverage of the inner peritoneal layer of RAMF with uroepithelium. No stone formation or mucus production were detected. Currently, three patients void using clean intermittent catheterization through the native urethra and the fourth through an appendiceal Mitrofanoff valve. However, the bladder volume was insufficient at the late follow-up and three patients required bladder augmentation. CONCLUSIONS: The RAMF technique is a good alternative for closing bladder exstrophies and achieves an increase in bladder capacity; however, although there is a mild improvement in bladder capacity and compliance. RAMF should not be used as a bladder augmentation procedure. The technique is indicated in the closure of large bladder defects, bladder exstrophies with small, inelastic, non-compliant bladder remnants and failed primary closures.     

Synthesis and characterization of poly(N‐vinyl‐2‐pyrrolidone) grafted sodium alginate hydrogel beads for the controlled release of indomethacin

Graft copolymers of sodium alginate (NaAlg) with N‐vinyl‐2‐pyrrolidone were prepared using azobisisobutyronitrile as initiator. The graft copolymers (NaAlg‐g‐PVP) were characterized with Fourier transform infrared spectroscopy, elemental analysis, and differential scanning calorimetry. Polymeric hydrogel beads of NaAlg and NaAlg‐g‐PVP were prepared by crosslinking method using glutaraldehyde (GA) as a crosslinker in the hydrochloric acid catalyst (HCl) and these beads were used to deliver anti‐inflammatory drug, indomethacin (IM). Chemical stability of the IM after encapsulation into beads was confirmed by FTIR. Preparation conditions of the NaAlg‐g‐PVP beads were optimized by considering the percentage entrapment efficiency, particle size, swelling capacity and their release data. In vitro release studies were performed in simulated gastric fluid (pH 1.2) for the initial 2 h, followed by simulated intestinal fluid (pH 7.4) for 4 h. Effects of GA concentration, exposure time to GA, drug/polymer (d/p) ratio, and concentration of HCl on the release of IM were discussed. It was observed that IM release from the beads decreased with increasing GA concentration and exposure time. IM release also decreases with increasing d/p ratio and HCl concentration. The highest IM release was obtained to be 77% for beads crosslinked with 0.027M GA. Swelling experiments were also performed to compute molecular mass between crosslinks of the beads. © 2008 Wiley Periodicals, Inc. J Appl Polym Sci, 2008     

Synthesis and characterization of novel polyacrylate-clay sol-gel materials

Organo-functional silanes which were able to form chemical bonds with kaolinite and could also have an affinity to the materials of concern here, were studied by the sol-gel process. Polymethacrylate with trialkoxy silyl functional groups were prepared, hydrolysed and co-condensed with kaolinite. The progress of the hydrolysis, which proceeded very slowly, was followed by Karl-Fischer titration. Thermal behavior was investigated by differential thermal analysis. The extent of the reaction leading to network formation was qualitatively followed by Fourier transform-infrared spectroscopy and X-ray diffraction. Free-radical polymerization was carried out ultrasonically in the presence of a catalyst. Trimethoxy silane end-capped silane was found to be covalently bonded to kaolinite. The copolymers, with various amounts of kaolinite, were then hydrolysed and co-condensed in the presence of a catalyst to yield sol-gel materials which have a controllable combination of properties of both the polymer and kaolinite.     

工业项目的海绵城市建设标准与技术要点

工业用地是城市建设用地的主要类型之一,是海绵城市建设的重要区域。通过梳理工业项目硬化面积高、径流污染程度高等特征,针对性提出其海绵城市建设的实施路径、建设标准和技术应用等实施建议。工业项目的海绵城市设计应遵循因地制宜的原则,应合理布局绿地并建设海绵设施,通过精细化的标高设计进行径流组织设计;对于降雨径流污染严重的三类工业项目,其海绵措施应以雨水调蓄池(应急事故池)为主,严禁设置具有渗透功能的源头控制设施。对于三类工业项目,海绵城市所提出的年径流总量控制率的目标与事故池的环保要求基本一致,建议相关部门在制定(修订)的应急事故池设计标准时,其中的径流污染控制体积可与对应区域年径流总量控制率标准协同一致。     

Robust control of variable speed autonomous underwater vehicle

Set point tracking control of autonomous underwater vehicle (AUV) via robust model predictive control (RMPC) is considered. Input-constrained RMPC with integral action, which has been developed in our previous work, is used to control the AUV in this study. In order to derive a RMPC control rule, non-linear dynamics of AUV with six degree of freedom is linearized at certain operating points. So, horizontal and vertical plane dynamics of system are represented by linear models which have polytopic uncertainties. Since the derived control rule will be used in real time, the computation time should be reduced. To overcome this computational time problem and get rid of trial–error step of Algorithm 1, a new algorithm is proposed here. The simulations are carried out using the control rule based on this algorithm and these results are presented.