Method for Preparation of Semiconductor Quantum‐Rod Lasers in a Cylindrical Microcavity

An efficient method for preparation of semiconductor quantum rod films for robust lasing in a cylindrical microcavity is reported. A capillary tube, serving as the laser cavity, is filled with a solution of nanocrystals and irradiated with a series of intense nanosecond laser pulses to produce a nanocrystal film on the capillary surface. The films exhibit intense room‐temperature lasing in whispering‐gallery modes that develop at the film–capillary interface as corroborated from the spacing detected for the lasing modes. Good lasing stability is observed at moderate pump powers. The method was applied successfully to several quantum‐rod samples of various sizes.     

Viral dynamics of primary viremia and antiretroviral therapy in simian immunodeficiency virus infection

Mathematical modeling of viral replication dynamics, based on sequential measurements of levels of virion-associated RNA in plasma during antiretroviral treatment, has led to fundamental new insights into human immunodeficiency virus type 1 pathogenesis. We took advantage of the simian immunodeficiency virus (SIV)-infected macaque model to perform detailed measurements and mathematical modeling during primary infection and during treatment of established infection with the antiretroviral drug (R)-9-(2-phosphonylmethoxypropyl)adenine (PMPA). The calculated clearance half-life for productively infected cells during resolution of the peak viremia of primary infection was on the order of 1 day, with slightly shorter clearance half-lives calculated during PMPA treatment. Viral reproduction rates upon discontinuation of PMPA treatment after 2 weeks were approximately twofold greater than those obtained just prior to initiation of treatment in the same animals, likely reflecting accumulation of susceptible target cells during treatment. The basic reproductive ratio (R0) for the spread of SIV infection in vivo, which represents the number of productively infected cells derived from each productively infected cell at the beginning of infection, was also estimated. This parameter quantifies the extent to which antiviral therapy or vaccination must limit the initial spread of virus to prevent establishment of chronic disseminated infection. The results thus provide an important guide for efforts to develop vaccines against SIV and, by extension, human immunodeficiency virus.     

Peer consultation groups for psychologists in private practice: A national survey.

We report the results of the first national survey of psychologists in private practice regarding their participation in peer consultation groups. The sample (71% return) was drawn from 800 randomly selected psychologists listed in the National Register of Health Service Providers in Psychology. We found that 23% of the sample currently belonged to peer consultation groups, and 24% had belonged in the past. Of those not currently in groups, 61% expressed the desire to belong if one were available. There were virtually no significant demographic differences between current members and nonmembers. We examined the following group characteristics: formation, length of existence, size, membership, leadership, theoretical orientation, range of experience, time and place, content, and group process. Groups tended to be small, informal, and leaderless; however, we found great variation among groups on all dimensions. Findings also showed a high degree of satisfaction with membership. (PsycINFO Database Record (c) 2010 APA, all rights reserved)     

A diffusion model for tungsten powder carburization

A mathematical model describes the carburization kinetics of tungsten powders mixed with carbon and heated in hydrogen. It is based on diffusion of carbon through a shell of WC growing into particles which are modeled as spheres. The activation energy is 58 kcal/mole in the temperature range 1056 to 1833 °C. Hydrogen gas is important to transport carbon as methane or acetylene, but increased hydrogen pressure increases the rate of carburization so little that an adsorbed species such as CH probably controls the carbon concentration at the particle surface. Formerly with the Lamp Metals Laboratory, deceased, was Professor of Metallurgy at Case Western Reserve University Cleveland OH.     

On the learning control of a robot manipulator

This paper derives a learning control law to achieve trajectory following for a robot manipulator. The controller consists of two parts, a computed torque servo for the rigid body terms that can be modelled and a learning law for the unmodelled dynamics. An advantage of this method is that bounds can be assigned to the position and velocity tracking errors.     

Terahertz imaging: materials and methods

Terahertz (THz) imaging is rapidly developing. We present two new methods, based respectively on (a) a broadband thermal source (globar) and (b) a coherent, monochromatic source (optically-pumped THz laser). A room-temperature detector (Golay cell) is employed. Image quality is similar to that reported by others using more complex sources (quantum cascade lasers) and detectors (superconducting tunneling junctions).     

Influence of ion bombardment on the properties and microstructure of unbalanced magnetron deposited niobium coatings

The effect of the ion bombardment to unbalanced magnetron deposited, approximately 1.5 and 4.5 μm thick, Nb coatings have been investigated as the bias voltage was varied from U_B=−75 to −150 V. Increasing bias voltage increased the hardness of the coating from 4.5 to 8.0 GPa. This was associated with residual stress and Ar incorporation into the Nb lattice. Strong {110} texture developed in the samples deposited at low bias voltages, while beyond U_B=−100 V a {111} texture became dominant. However, strong {111} texture was observed only with the thicker 3Nb coatings. Secondary electron microscopy investigation of the coating topography showed fewer defects in the thicker coatings. All coatings exhibited good corrosion resistance, with the thicker coatings clearly outperforming the thinner ones. Excessive bias voltages (U_B=−150 V) was found to lead to poor adhesion and loss of corrosion resistance.