Unipolar plasma electrolytic oxidation: Waveform optimisation for corrosion resistance of commercially pure titanium

This study deals with the anodisation of titanium grade 2 in 0.5-M sulphuric acid using a pulsed signal in a unipolar regime. The electrical parameters investigated are voltage, frequency and duty cycle. The use of duty cycles with a high percentage of anodic polarisation (90%), combined with high frequencies (1000 Hz) and the higher voltage tested (220 V), favoured the establishment of a plasma regime involving strong dielectric discharges, allowing the growth of thicker oxides but with rough architecture. The corrosion resistance of the formed film has been characterised by potentiodynamic tests in 0.5-M NaBr for localised corrosion resistance and by immersion tests in 10% v/v sulphuric acid solution for a uniform corrosion assessment. Current–time curves, visual observations and electron microscope analysis (scanning electron microscopy, energy-dispersive X-ray spectroscopy) were the tools selected to provide a correlation between technological parameters and oxide growth mechanism. For localised and uniform corrosion, anodisation at 220 V with a high level of anodic polarisation (90%) and frequency (1000 Hz) was verified to be particularly advantageous.     

Characterization of Rev function using subgenomic and genomic constructs in T and COS cells

The effects of extracellular Ca2+ on cytotoxicity induced by cardiotoxin (CTX), isolated from Chinese cobra venom, were investigated in cultured rabbit aortic endothelial cells (RAECs). In Hank's buffered saline solution (HBSS) containing 1.2 mM Ca2+, CTX (1-30 microM) caused cell necrosis and cell death in a concentration-dependent manner, as determined by trypan blue exclusion test performed after a 20-min CTX treatment. The concentration of CTX that caused 50% cell death was about 6.5 microM. CTX (10 microM)-induced RAEC damage was also evident but less prominent in Ca2+-free medium and almost completely prevented in medium containing 7-10 mM Ca2+. Therefore, Ca2+ appears to provoke CTX-induced injury at physiological concentrations, but protects against it at high concentrations. The protection of RAECs from CTX-induced injury could also be achieved by high concentrations of Ni2+ and Mg2+. Using the fura-2 fluorescence technique to measure the cytosolic free Ca2+ concentration ([Ca2+]i) of single RAEC, it was shown that in 1.2 mM Ca2+-containing HBSS, treatment of RAECs with 10 microM CTX for 7-35 min resulted in a tremendous and irreversible [Ca2+]i elevation, suggestive of cell membrane damage and extracellular Ca2+ entry. Ni2+ could also enter the cytosol of these damaged RAECs. However, there was no [Ca2+]i elevation or Ni2+ entry in RAECs that were preincubated in HBSS containing 7 mM Ca2+ or Ni2+ before CTX exposure. In RAECs protected with 7 mM Ca2+, the intracellular Ca2+ signals triggered by 100 microM extracellular ATP or 10 microM bradykinin in CTX-treated groups were similar to those in the untreated control groups. Taken together, the results indicate that high extracellular Ca2+ concentrations protected RAECs from CTX-induced injury, and preserved the ability of CTX-treated RAECs to generate Ca2+ signals in response to physiological stimuli.     

Proton nuclear magnetic resonance rapid and structure-specific determination ofω-3 polyunsaturated fatty acids in fish lipids

Based on proton nuclear magnetic resonance (¹H-NMR) spectroscopy, a rapid and structure-specific method for the determination of ω-3 polyunsaturated fatty acids (PUFAs) in fish lipids is presented. The different chemical shift observed for the methyl resonance of ω-3 PUFAs (δ=0.95 ppm) with respect to the methyl resonance of all other fatty acids (δ=0.86 ppm) has provided the possibility of proposing a new and rapid method for the determination of ω-3 PUFA content. Twenty-four fish lipid samples (raw, cooked and canned albacore tuna) produced results that showed good agreement between¹H-NMR analysis and gas chromatographic determination. Raw and cooked samples showed significantly higher levels of ω-3 PUFA than canned tuna.     

Shape from defocus via diffusion

Defocus can be modeled as a diffusion process and represented mathematically using the heat equation, where image blur corresponds to the diffusion of heat. This analogy can be extended to non-planar scenes by allowing a space-varying diffusion coefficient. The inverse problem of reconstructing 3-D structure from blurred images corresponds to an "inverse diffusion" that is notoriously ill-posed. We show how to bypass this problem by using the notion of relative blur. Given two images, within each neighborhood, the amount of diffusion necessary to transform the sharper image into the blurrier one depends on the depth of the scene. This can be used to devise a global algorithm to estimate the depth profile of the scene without recovering the deblurred image, using only forward diffusion.     

Guest Editor's Introduction: Renewing the Software Project Management Life Cycle

The software project management body of knowledge is gradually being renewed across the entire lifecycle. In the conception phase, the focus is on fostering innovation through new approaches such as business analysis and crowdsourcing techniques. In the construction phase, the rise of global software development has shrunk the world and led to new approaches to risk management that take into account factors such as cultural diversity. In the project conclusion phase, new approaches to the evaluation of project success are being introduced, such as project retrospectives and intellectual capital reporting. Conversely, long accepted approaches to measurement and evaluation such as those promoted in the Chaos reports of the Standish Group are being called into question.     

Nanocrystalline diamond growth on different substrates

Nanocomposite films consisting of diamond nanoparticles of 3-5 nm diameter embedded in an amorphous carbon matrix have been deposited by means of microwave plasma chemical vapour deposition (MWCVD) from CH₄/N₂ gas mixtures. Si wafers, Si coated with TiN, polycrystalline diamond (PCD) and cubic boron nitride films, and Ti-6Al-4V alloy have been used as substrates. Some of the substrates have been pretreated ultrasonically with diamond powder in order to enhance the nucleation density n_nuc. It turned out that n_nuc depends critically on the chemical nature of the substrate, its smoothness and the pretreatment applied. No differences to the nucleation behaviour of CVD PCD films were observed. On the other hand, the growth process seems to be not affected by the substrate material. The crystallinity (studied by X-ray diffraction) and the bonding environment (investigated by Raman spectroscopy) show no significant differences for the various substrates. The mechanical and tribological properties, finally, reflect again the influence of the substrate material: on TiN, a lower hardness was measured as compared to Si, PCD and c-BN, whereas the adhesion of c-BN/nanocrystalline diamond (NCD) system was determined by that of the c-BN film on the underlying Si substrate.     

Vocal production in postpartum dairy cows: Temporal organization and association with maternal and stress behaviors

Mammalian vocalizations can encode contextual information in both the spectrographic components of their individual vocal units and in their temporal organization. Here we observed 23 Holstein-Friesian dairy cows immediately after birth during interactions with their calf and when their calf was separated to the other side of a fence line. We investigated whether the vocalizations emitted in these postpartum contexts would vary temporally. We also described the maternal and stress behaviors preceding and following postpartum vocal production using kinematic diagrams and characterized call sequence structure. The kinematic diagrams highlight the disruption of maternal responses caused by calf separation and show that behavioral and vocal patterns varied according to the cows' emotional states and proximity to the calf in both contexts. During calf interactions, cows mainly produced closed-mouth calls simultaneous to licking their calf, whereas an escalation of stress responses was observed during calf separation, with the cows approaching the fence line, becoming alert to the calf, and emitting more mixed and open-mouth calls. Call sequences were similarly structured across contexts, mostly containing repetitions of a single call type, with a mean interval of 0.57 s between calls and a greater cumulative vocalization duration, attributed to an increased number of vocal units per sequence. Overall, calf separation was associated with a greater proportion of calls emitted as a sequence (inverse of single isolated calls), a shorter interval between separate call sequences, and a greater number of vocal units per sequence, compared with calf interactions. These temporal vocal features varied predictably with the high stress expression from cows during calf separation and may represent temporal modulations of emotional expression. Despite the noisy farm soundscape, empirical call type and temporal vocal features were easy to measure; thus, findings could be applied to future cattle studies wishing to analyze vocalizations for on-farm welfare assessments.     

On the Cooling Rate-Microstructure Relationship in Molten Metal Gas Atomization

Metallurgical and Materials Transactions A - Gas atomization is the most used powder production technique since it provides good control on particles shape, surface oxidation and dimension. It is a...     

First data from the EGLE experiment onboard the ISS

EGLE is a wide frequency band search- coil magnetometer designed and built at the Roma Tre University. It has been installed onboard the ISS by the Italian astronaut Roberto Vittori on April 25, 2005 within the LAZIO- EGLE experiment carried out during the ENEIDE Soyuz mission. The scope of the experiment is to test EGLE in space and to investigate geomagnetic field variations. The main applications of EGLE are the study of electromagnetic environment inside the ISS, the correlation of magnetic field data with particle fluxes detected by LAZIO particle detector, and the monitoring of ionospheric perturbations possibly caused by Earth seismic activity. Since continuous electromagnetic field measurements on board the ISS are important for diverse space applications, a magnetometer with a suitable design is requested. Appropriate solutions for these applications, which have been adopted by EGLE, are in particular the use of 1- Wire technology and the possibility to detect by means of a search- coil magnetometer a large portion of the ULF frequency band, usually measured by flux- gate probes. To investigate the topside ionosphere electromagnetic environment and stability of Van Allen radiation belts in relation with seismic and anthropogenic electromagnetic emissions, a specific satellite mission (the ESPERIA project) has been designed for the Italian Space Agency (ASI), and up to now a few instruments of its payload have been built and tested in space. One of them is exactly the EGLE search- coil magnetometer. The first magnetic observations performed by this instrument reveal to be promising and demand for a further and deeper analysis based on a longer time series of data.     

The importance of landscape in wine quality perception: An integrated approach using choice-based conjoint analysis and combination-based permutation tests

This work’s aim is to evaluate the importance of landscape in wine quality perception using a novel integrated approach based on two statistical techniques, i.e. choice-based conjoint analysis (Gustafsson et al., 2001) and combination-based permutation tests (Corain and Salmaso, 2004, Pesarin and Salmaso, 2009a). To this end we developed a preference choice experiment which was submitted to a sample of respondents during blind wine tasting meetings. The obtained results allow us to weigh up and emphasise the importance of an attractive landscape to the perception of a finer quality of wine. Indeed, we noticed that associating wine to an image of greater visual impact, i.e. an evocative landscape, induces a significantly higher preference for the tasted wine. Moreover, the integrated application of choice-based conjoint analysis and combination-based permutation tests allows us to identify the specific relationship each market segment has with landscape, price and wine quality.