Characterization and electrochemical properties of CF4 plasma-treated boron-doped diamond surfaces

The effect of CF₄ plasma etching on diamond surfaces, with respect to treatment time, was investigated using scanning electron microscopy (SEM), Raman spectroscopy, X-ray photoelectron spectroscopy (XPS), and electrochemical measurements. SEM observations and Raman spectra indicated an increase in surface roughening on a scale of 10–20 nm, and an increase in crystal defect density was apparent with treatment time in the range of 10 s to 30 min. In contrast, alteration of the diamond surface terminations from oxygen to fluorine was found to be rather rapid, with saturation of the F/C atomic ratio estimated from XPS analysis after treatment durations of 1 min and more. The redox kinetics of Fe(CN)₆^3−/4− was also found to be significantly modified after 10 s of CF₄ plasma treatment. This behavior shows that C–F terminations predominantly affect the redox kinetics compared to the effect on the surface roughness and crystal defects. The double-layer capacitance (C_dl) of the electrolyte/CF₄ plasma-treated boron-doped diamond interface was found to show a minimum value at 1 min of treatment. These results indicate that a short-duration CF₄ plasma treatment is effective for the fabrication of fluorine-terminated diamond surfaces without undesirable surface damage.     

Pool boiling on a superhydrophilic surface

Titanium Dioxide, TiO₂, is a photocatalyst with a unique characteristic. A surface coated with TiO₂ exhibits an extremely high affinity for water when exposed to UV light and the contact angle decreases nearly to zero. Inversely, the contact angle increases when the surface is shielded from UV. This superhydrophilic nature gives a self-cleaning effect to the coated surface and has already been applied to some construction materials, car coatings and so on. We applied this property to the enhancement of boiling heat transfer. An experiment involving the pool boiling of pure water has been performed to make clear the effect of high wettability on heat transfer characteristics. The heat transfer surface is a vertical copper cylinder of 17 mm in diameter and the measurement has been done at saturated temperature and in a steady state. Both TiO₂-coated and non-coated surfaces were used for comparison. In the case of the TiO₂-coated surface, it is exposed to UV light for a few hours before experiment and it is found that the maximum heat flux (CHF) is about two times larger than that of the uncoated surface. The temperature at minimum heat flux (MHF) for the superhydrophilic surface is higher by 100 K than that for the normal one. The superhydrophilic surface can be an ideal heat transfer surface. Copyright © 2002 John Wiley & Sons, Ltd.     

Flashover voltage characteristics of contaminated station insulators under temporary ac overvoltages in the ac system connected with a frequency converter station

According to the recent analysis results of temporary ac overvoltage in the ac system connected with a frequency converter station, large-magnitude over-voltages were confirmed to occur under some special system conditions. Most of the station insulators currently used cannot withstand such overvoltages according to an evaluation based on the data obtained earlier. The necessity of tests to be done to evaluate such performance more accurately was recognized. Both power frequency and switching impulse overvoltage flashover tests were made on contaminated insulators by the method well simulating the natural wetting condition. Switching impulse flashover voltage with the waveshape having a long wavefront time of 2 ms can be well correlated with the flashover voltage characteristics of temporary ac overvoltage. Higher flashover voltage characteristics were obtained by a clean fog test method compared with those obtained by equivalent fog test method.     

Progressive bronchial obstruction during the acute stage of respiratory tract infection in asthmatic children

To study the time-course of infectious asthma, we retrospectively examined FEV1 from 5 days before to 10 days after the onset of illness in 31 asthmatic children (20 boys and 11 girls), aged 8 to 12 years. Infections were confirmed by a rise of at least fourfold in serum compliment fixation titers (respiratory syncytial virus, adenovirus, and Mycoplasma pneumoniae) and hemoagglutination inhibition titers (parainfluenza virus types 1, 2, and 3). All the patients had 20 percent or more fall in FEV1 from baseline value during acute phase, but were clinically tolerable and required minimum or no bronchodilators. Regardless of infectious agent, FEV1 began to fall on the first disease day or the previous day, and deteriorate for the first few days. Mean(SD) maximum fall in FEV1 ranged from 39(12) percent to 45(20) percent. Thereafter, FEV1 began to improve and returned to the preillness level by the seventh to tenth day. These results suggest that progressive bronchial obstruction may be inevitable during the acute stage of any infectious asthma.     

Primary biliary cirrhosis: symptoms, laboratory data and diagnosis

The most frequent and important symptoms in primary biliary cirrhosis (PBC) are pruritus and jaundice. In the majority, jaundice appears within one half to two years of onset of pruritus. Xanthoma, bone change and sicca syndrome are often observed. The recent increase in number of asymptomatic PBC is the result of progagation of medical examination. In the biochemical tests, elevation of the biliary enzymes, such as ALP and gamma-GTP, is characteristic, as well as, a high level of serum IgM. Serum bilirubin values are gradually raised along with the clinical course of the disease. Positive antimitochondrial antibody (AMA) is the most valuable immunological finding for the diagnosis of PBC. Anti-pyruvate dehydrogenase complex E2 component E2 has the same significance as AMA. Diagnostic criteria si shown in this paper.     

An over 2200-km coherent transmission experiment at 2.5 Gb/s usingerbium-doped-fiber in-line amplifiers

A 2223 km transmission distance was achieved with a 2.5-Gb/s heterodyne detection system that used erbium-doped-fiber in-line amplifiers and dispersion-shifted single-mode fibers. Twenty-five amplifiers, placed at approximately 80-km intervals, offered a total gain of more than 440 dB. Receiver sensitivity was -42.0 dBm, with only a 4.2-dB penalty from the initial sensitivity achieved by the back-to-back configuration     

A new voltage control equipment using fuzzy inference

Power system control equipment needs higher sensitivity and operational reliability. Advanced voltage control equipment is needed for reducing the frequency of tap changes and improving the characteristics (the relationship between the actual voltage and reference voltage) of the voltage to meet today's power system requirements. However, these objectives are in a trade-off relationship. Studies of voltage control derived from a knowledge base suitable for electric power systems can satisfy these objectives using fuzzy inference. Compared with corresponding conventional equipment, the new equipment improved the deviation of 30 min average voltage of 30 percent. This paper describes the design concept of new voltage control equipment using fuzzy inference. In addition, field test results are described along with rules of fuzzy inference, membership functions, and the deviation of 30 min average voltage through detailed simulation.     

Free volume and permeabilities of O2 and H2 in Nafion membranes for polymer electrolyte fuel cells

The mechanism of gas permeation in Nafion membranes for polymer electrolyte fuel cells has been investigated from the viewpoint of free volume. Three different samples, a membrane with ionic exchange capacity (IEC) = 0.92 meq/g, and recast samples with IEC = 0.92 and 1.00 meq/g were used after drying. Free volume was quantified using the positron annihilation lifetime (PAL) technique and gas permeabilities were measured for O₂ and H₂ as functions of temperature and relative humidity. Good linear correlations between the logarithm of the permeabilities at different temperatures and reciprocal free volume indicate that gas permeation in dry Nafion is governed by the free volume. Nevertheless permeabilities are much smaller than the corresponding flexible chain polymer with a similar free volume size due to stiff chains of the perfluoroethylene backbone. In highly hydrated Nafion above 60% relative humidity, where the O₂ permeability varies oppositely to the free volume, gas permeation proved to be controlled by the gradual increase in overall flexibility of the Nafion–water system.     

Use of external conduit impairs liver function in patients with biliary atresia

An external conduit (stoma) for patients with biliary atresia has been used to prevent postoperative cholangitis. Thirty-two patients with biliary atresia who had hepatic portoenterostomies with external conduits were studied retrospectively with respect to frequency and severity of postoperative cholangitis or stoma bleeding. Changes in their liver enzyme levels, and total bilirubin (TB) levels were measured before and after closure of the stoma. Cholangitis was observed in 20 patients (62.5%), and major hemorrhage from the stoma site was seen in 14 patients (43.8%) prior to closure. Levels of liver enzymes such as glutamic oxaloacetic transaminase (SGOT), glutamic pyruvic transaminase (SGPT), gamma-glutamyl transpeptidase (gamma-GTP), and alkaline phosphatase (ALP) improved significantly within 1 month after closure of the stoma, and remained low thereafter. The TB concentration was the only liver function that did not change significantly following closure. In summary, the authors do not recommend an external conduit in patients with biliary atresia because it is not an effective way of reducing the incidence of postoperative cholangitis, and it may be deleterious to liver function.     

Patients with ultrasonic coarse-nodular cirrhosis who are anti-hepatitis C virus-positive are at high risk for hepatocellular carcinoma

BACKGROUND: The relationship between echosonographic patterns of patients with cirrhosis who are antihepatitis C virus (HCV)-positive, the DNA synthesis of hepatocytes, and the risk for HCC were studied. METHODS: Thirty-eight patients with anti-C-100 antibody-positive and Child's grade A posthepatitic cirrhosis were studied. DNA synthesis activity was measured by a bromodeoxyuridine (BrdU, a thymidine analogue)-labeling index (LI), using the BrdU-anti-BrdU in vitro method, and the patients were followed prospectively by frequent liver ultrasonography for 3 years. The ultrasound patterns were classified into fine, coarse, and coarse-nodular (CN) patterns, and the reproducibility of the classification in practical use also was confirmed. RESULTS: Of the 21 patients with high DNA synthesizing cirrhosis (BrdU LI > or = 1.5%), 10 (48%) showed coarse-nodular, 5 (24%) coarse, and 6 (29%) fine pattern in ultrasonography. Conversely, of the 17 patients with low DNA synthesizing LC (BrdU LI < 1.5%), only 1 (6%) showed coarse-nodular, 2 (12%) coarse, and 14 (82%) fine pattern. A significant relationship was found between the two groups of BrdU LI and ultrasound imaging patterns (P < 0.05). The incidence of CN pattern was significantly higher (P < 0.01) in the high DNA synthesizing group than in low DNA synthesizing group. Of the 11 patients with CN pattern by ultrasound imaging, 10 (91%) were in the high DNA synthesizing group, and 9 (82%) developed HCC during the follow-up period, compared with 3 of 7 (43%) with coarse, and only one of 20 (5%) with fine pattern developed HCC. The incidence of HCC was significantly higher (P < 0.01) in patients with a CN cirrhosis pattern than in those with a fine pattern. CONCLUSIONS: In patients with cirrhosis who are anti-HCV-positive, the CN pattern by ultrasound imaging indicates increased DNA synthesis of hepatocytes and a high risk for developing HCC.