Preparation of Mn2+-Cu+ co-doped P2O5–ZnO–Al2O3 glasses and their red fluorescence properties

To make a Mn²⁺-doped red glass phosphor that can be excited with ultraviolet (UV) light of light-emitting diodes (LEDs), 60P₂O₅-35ZnO-5Al₂O₃-8MnO-xCu₂O glasses (x = 0-1.00) were prepared by a melt-quenching method at 1200-1400°C for 30-180 minutes in atmospheric air, and the redox of Mn and Cu as well as fluorescence properties were investigated. The Mn²⁺ ion was not reduced and oxidized in the melting, quenching, and annealing processes. The valence of Cu in the glasses changed in the order of 0, 1+, and 2+ with the increase in the amount of Cu₂O and in the melting temperature and time. In this study, a 60P₂O₅-35ZnO-5Al₂O₃-8MnO-0.10Cu₂O glass melted at 1250°C for 90 minutes, having the highest Cu⁺ concentration, showed the strongest Mn²⁺ red fluorescence under the UV light at 275 nm. This strong Mn²⁺ red fluorescence has been caused by the energy transfer from excited Cu⁺ ions to Mn²⁺ ions.     

Unperturbed dimension of poly(4-acetoxystyrene) measured in good and theta solvents

In order to obtain the additional data concerning the unperturbed dimension of poly-4-substituted styrene, light scattering measurements are performed on the twenty-two fractions with molecular weight of (0.91–352)·10⁴ of poly(4-acetoxystyrene) in dioxan at 25°C, from which the molecular weight obtained was found easily to be evaluated with the gel permeation chromatography using THF. Phase separation experiments for this polymer indicate that the theta state is attained in isopropyl acetate at 19.7°C and butyl acetate at 26.8°C. By making viscosity measurements at that state, the value of K_Θ is directly evaluated as 5.4·10^?4 dl g^?1. The limiting viscosity number is also obtained in good solvents, THF and dioxan, at 25°C and constants of the Mark-Houwink-Sakurada equation in each solvent are determined. Further, approximately the same K_Θ as above is obtained from these data with the Stockmayer-Fixman plot. The calculated value of steric factor, 2.37, on this polymer may be plausible, compared with those of polyvinylaromatic derivatives.     

Prevention of neutrophil apoptosis by monosodium urate crystals

The effects of monosodium urate (MSU) crystals on apoptosis of cultured peripheral blood neutrophils were investigated. MSU crystals at low concentrations decreased the rate of spontaneous apoptosis of neutrophils in a dose- and time-dependent manner. The culture supernatant of MSU crystal stimulated neutrophils also promoted a delay in neutrophil apoptosis. MSU crystals at higher concentrations rapidly caused cell lysis. These findings indicated that MSU crystals are capable of amplifying the inflammatory responses of gouty arthritis by decreasing the rates of neutrophil apoptosis at lower concentrations and inducing cell lysis at higher concentrations.     

A CMOS integrated circuit for multichannel multiple-subjectbiotelemetry using bidirectional optical transmissions [weightlessnessin space effects application]

A CMOS integrated circuit for a noninvasive biological-signal telemetry system specified for use in medical and physiological studies of the influence of weightlessness in space is presented. The system can monitor multichannel (4 channels maximum) biological signals from multiple subjects (4 subjects maximum) in real time by using time multiplexing. A key technique so-called synchronized multiple-subject telemetry, to achieve multiple-subject telemetry has been proposed. This technique utilizes bidirectional optical transmissions with direct and scattered infrared lights between an observer and each of the subjects. An experimental CMOS IC to give a small light-weight low-power, and smart telemetry instrument for use on animals has been developed. This IC is for evaluating circuit blocks of the implantable monolithic telemetry instrument. The major circuit blocks include CMOS digital circuits for synchronization, subject selection and time multiplexing, analog circuits for pulse interval modulation, and other blocks such as a CMOS optical pulse receiver and an LED driver. A preliminary experimental multichannel telemetry from two subjects has been performed with the implemented IC chips, and the principal operation of the multiple-subject optical biotelemetry has been demonstrated     

Analytical studies of four-inch pipe whip tests under BWR LOCA conditions

The purpose of pipe rupture studies in JAERI is to perform model tests on pipe whip, restraint behavior, jet impingement and jet thrust force, and to establish a computational method for analyzing these phenomena. This report presents the analytical results of 4-inch pipe whip tests under BWR LOCA conditions.Dynamic response analyses were performed using the general-purpose finite element program ADINA. The test pipe was modelled by straight beam elements and the four restraints were modelled by a single truss element. The analytical results were compared with the experimental results. Impact time and maximum total restraint force showed good agreement with experimental results. On the other hand, pipe strain and pipe deflection could not be predicted so well. The reason for this is that the sliding of the restraint during the pipe whip movement cannot be considered in the analyses.     

A reconfigurable VLSI-based double-lens tracking camera

Watching and tracking an object while seeing a much wider view is one of advantages of the eye system. We proposed and developed a tracking camera system that mimics the eyes by using double-lens modules. In the system, a wide view is captured through the wide-lens module, while the target in it is tracked and magnified through the telescopic lens module. Electronic circuits for tracking control are implemented onto the reconfigurable VLSI or FPGA in order to embed the parallelism in the tracking algorithm into the hardware. A successfully developed FPGA-based prototype performs high-speed tracking at the video-rate. This work was present in part at the 12th International Symposium on Artificial Life and Robotics, Oita, Japan, January 25–27, 2007     

A self-aligned gate GaAs MESFET with p-pocket layers forhigh-efficiency linear power amplifiers

This paper describes a newly developed GaAs metal semiconductor field-effect transistor (MESFET)-termed p-pocket MESFET-for use as a linear power amplifier in personal handy-phone systems. Conventional buried p-layer technology, the primary technology for microwave GaAs power MESFET's, has a drawback of low power efficiency for linear power applications. The low power efficiency of the buried p-layer MESFET is ascribed to the I-V kink which is caused by holes collected in the buried p-layer under the channel. In order to overcome this problem, we have developed the self-aligned gate p-pocket MESFET which incorporates p-layers not under the channel but under the source and drain regions. This new MESFET exhibited high transconductance and uniform threshold voltage. The problematic I-V kink was successfully removed and an improved power efficiency of 48% was achieved under bias conditions, which resulted in adjacent channel leakage power at 600-kHz offset as low as -59 dBc for 1.9-GHz π/4-shift QPSK modulated input     

Intracoronary infusion of E6010 has more potent thrombolytic activity than tissue plasminogen activator (t-PA) in dogs: a higher plasma level of E6010 than t-PA causes potent thrombolytic activity

We examined the thrombolytic properties of a novel modified human tissue plasminogen activator (PA) (E6010), in which cysteine 84 is replaced by serine, and which has a prolonged biologic half-life (t1/2). We compared the thrombolytic efficacy of continuous intracoronary (i.c.) infusion of E6010 with that of recombinant human tissue PA (rt-PA) in a canine model with copper coil-induced 1-h-old coronary artery thrombi and also compared the relation between thrombolytic efficacy and plasma clearance represented by pharmacokinetic parameters of i.c.-infused E6010 and rt-PA. Sixty-minute E6010 and rt-PA i.c. infusions were compared. The thrombolytic effects of i.c.-infused E6010 and rt-PA, represented by time to reperfusion (TR), reperfusion rate at 60 min (RR), and reocclusion rates at 60 min after reperfusion (OR) were as follows. E6010: Dose 0.06, 0.15, 0.3 (mg/kg/h); TR 25 +/- 10, 15 +/- 10, 13 +/- 5 (min); RR 100, 100, 100 (%); and OR 0, 0, 17 (%), respectively. Recombinant t-PA: Dose 0.06, 0.15, 0.3 (mg/kg/h); TR 47 +/- 12, 18 +/- 17, 14 +/- 4 (min); RR 50, 75, 100 (%); and OR 100, 33, 33 (%), respectively. These findings indicate that E6010 has more potent thrombolytic activity than rt-PA.(ABSTRACT TRUNCATED AT 250 WORDS)