AH-64D main transmission accessory drive spur gear installation fault detections

The US Army has launched an aggressive program to implement condition based maintenance on its rotary wing assets. Condition Based Maintenance takes advantage of technology developments in the areas of machinery monitoring, signal processing and fault modeling to reduce the cost of ownership through improved maintenance procedures. Documenting the reduction in maintenance burden, cost savings and increased safety through early detection of helicopter faults is an important step in justifying the program. This paper describes a novel technique used to detect a serious fault in the accessory section of the AH-64D Apache main transmission. The technique determines if the primary or secondary clutch system is driving the aircraft accessories through a tachometer speed ratio. The method has identified three aircraft operating on the secondary system allowing Army maintenance crews to replace the affected transmissions and quickly restore the aircraft to operational status.     

Wind Velocity Sensorless Maximum Power Point Tracking Algorithm in Grid-connected Wind Energy Conversion System

This article proposes a wind velocity sensorless hill-climb searching algorithm in the grid-connected field-oriented controlled permanent magnet synchronous generator based wind energy conversion system. The proposed method improves the speed and accuracy of initial tracking. Pseudo-optimum points are used to track the exact optimum points using the power versus speed characteristics of a wind turbine for various wind velocities. This research emphasizes that the pseudo-optimum points using the power versus speed characteristics are always less than and much nearer to the exact optimum points. The small-step forward tracking after pseudo-optimum points improves the accuracy of this algorithm. Moreover, this method improves the tracking speed for various wind velocities. The system used for this research consists of a back-to-back sinusoidal pulse-width modulation converter between the generator and the grid. The performance of the proposed method is analyzed mathematically and verified by simulation using MATLAB/Simulink software (The Mathworks, Natick; Massachusetts, USA).     

Antifungal activity of five different essential oils in vapour phase for the control of Colletotrichum gloeosporioides and Lasiodiplodia theobromae in vitro and on mango

Mango fruit has high commercial value; however, major postharvest losses are encountered throughout the supply chain due to postharvest diseases. These results lead to the search for natural fungicide for postharvest diseases control. The antifungal effects of five essential oils (thyme, clove, cinnamon, anise and vitex) were assessed by disc volatilisation method. Thyme oil vapours at 5 μL per Petriplate, and clove and cinnamon oil at 8 μL per Petriplate showed 100% growth inhibition of mango pathogens in vitro. GC/MS analysis of essential oil showed thymol (23.88), o‐cymol (23.88) and terpinolene (23.88) as the major constituents of thyme oil. Clove and cinnamon oils contain 3‐allyl‐2‐methoxyphenol (37.42%) and benzofuran 3‐methyl (17.97%), respectively. Thyme oil as a fumigant at 66.7 μL L^?1 showed a significant (P < 0.05) inhibition on postharvest pathogens of mango fruits stored at 25 °C for 6 days. Results of our study suggest the possibility of using thyme oil as an alternate natural fungicide to manage postharvest diseases in mango.     

Enhancing the efficiency of alternating current driven organic light-emitting devices by optimizing the operation frequency

We report efficient and bright organic light-emitting devices operated by capacitive energy coupling. In this approach, the organic layers are enclosed between sputter-deposited hafnium dioxide layers to prevent charge carrier injection. When a sinusoidal voltage signal is applied to the electrodes, the devices emit bright green light whereas no detectable emission is generated upon application of a constant voltage. The efficiency of the process depends heavily on the frequency of the applied voltage signal. By optimizing the driving scheme, a record luminous efficacy for AC driven OLEDs of 2.7 lm/W at 500 cd/m² is achieved.     

Application of Proteomics in Pancreatic Ductal Adenocarcinoma Biomarker Investigations: A Review

Pancreatic ductal adenocarcinoma (PDAC), a highly aggressive malignancy with a poor prognosis is usually detected at the advanced stage of the disease. The only US Food and Drug Administration-approved biomarker that is available for PDAC, CA 19-9, is most useful in monitoring treatment response among PDAC patients rather than for early detection. Moreover, when CA 19-9 is solely used for diagnostic purposes, it has only a recorded sensitivity of 79% and specificity of 82% in symptomatic individuals. Therefore, there is an urgent need to identify reliable biomarkers for diagnosis (specifically for the early diagnosis), ascertain prognosis as well as to monitor treatment response and tumour recurrence of PDAC. In recent years, proteomic technologies are growing exponentially at an accelerated rate for a wide range of applications in cancer research. In this review, we discussed the current status of biomarker research for PDAC using various proteomic technologies. This review will explore the potential perspective for understanding and identifying the unique alterations in protein expressions that could prove beneficial in discovering new robust biomarkers to detect PDAC at an early stage, ascertain prognosis of patients with the disease in addition to monitoring treatment response and tumour recurrence of patients.     

A Flower-like In2O3 Catalyst Derived via Metal–Organic Frameworks for Photocatalytic Applications

The most pressing concerns in environmental remediation are the design and development of catalysts with benign, low-cost, and efficient photocatalytic activity. The present study effectively generated a flower-like indium oxide (In₂O₃-MF) catalyst employing a convenient MOF-based solvothermal self-assembly technique. The In₂O₃-MF photocatalyst exhibits a flower-like structure, according to morphology and structural analysis. The enhanced photocatalytic activity of the In₂O₃-MF catalyst for 4-nitrophenol (4-NP) and methylene blue (MB) is likely due to its unique 3D structure, which includes a large surface area (486.95 m² g⁻¹), a wide spectrum response, and the prevention of electron–hole recombination compared to In₂O₃-MR (indium oxide-micro rod) and In₂O₃-MD (indium oxide-micro disc). In the presence of NaBH₄ and visible light, the catalytic performances of the In₂O₃-MF, In₂O₃-MR, and In₂O₃-MD catalysts for the reduction of 4-NP and MB degradation were investigated. Using In₂O₃-MF as a catalyst, we were able to achieve a 99.32 percent reduction of 4-NP in 20 min and 99.2 percent degradation of MB in 3 min. Interestingly, the conversion rates of catalytic 4-NP and MB were still larger than 95 and 96 percent after five consecutive cycles of catalytic tests, suggesting that the In₂O₃-MF catalyst has outstanding catalytic performance and a high reutilization rate.     

Lattice Boltzmann Simulation of Two- and Three-Dimensional Incompressible Thermal Flows

This work is concerned with the application of the thermal lattice Boltzmann method (TLBM) to compute incompressible two- and three-dimensional flows in cavities. Two convection test cases, namely, the laminar flow in a differentially heated square cavity and a cubic cavity, are numerically analyzed through TLBM. The internal energy density distribution function approach with two three-dimensional particle velocity models, namely, the 15-velocity and the 19-velocity, and a two-dimensional model, namely, the nine-velocity, have been used in the present work. Computations are carried out for laminar flows in a differentially heated square cavity and a cubical cavity (Rayleigh numbers = 10³ to 10⁵). The boundary conditions used are stable and of good accuracy. To lend credibility to the thermal lattice Boltzmann model square cavity results, they are further compared with those obtained from a finite-difference-based code developed for this purpose.     

Studies on antioxidant activities of mucuna seed (Mucuna pruriens var utilis) extract and various non‐protein amino/imino acids through in vitro models

The antioxidant activities of a methanolic extract of mucuna beans (Mucuna pruriens var utilis) and several non‐protein amino/imino acids, namely L ‐3,4‐dihydroxyphenylalanine (L ‐dopa), L ‐3‐carboxy‐6,7‐dihydroxy‐1,2,3,4‐tetrahydroisoquinoline (compound I), (?)‐1‐methyl‐3‐carboxy‐6,7‐dihydroxy‐1,2,3,4‐tetrahydroisoquinoline (compound II) and 5‐hydroxytryptophan (5‐HTP), were evaluated. By virtue of their hydrogen‐donating ability, all the tested compounds and the mucuna seed extract showed excellent reducing power, with the highest values being recorded for L ‐dopa in a dose‐dependent manner. Similarly, as compared with synthetic antioxidants (BHT and BHA) and quercetin, all the tested compounds and the seed extract were found to be more potent in free radical‐scavenging activity (P < 0.05) against α,α‐diphenyl‐β‐picrylhydrazyl (DPPH^?) radicals. Hydroxyl radicals (OH^?) and superoxide anion radicals (O₂^??) were effectively scavenged by the tested compounds, with the exception that no scavenging activity of 5‐HTP was observed on (O₂^??) up to a concentration of 2 mg ml^?1, as was also the case for BHA. Among the tested non‐protein amino/imino acids and seed extract the highest peroxidation‐inhibiting activity (95%) was recorded for 5‐HTP. On the other hand, in the linoleic acid/β‐carotene‐bleaching system, L ‐dopa, compound I and compound II acted as pro‐oxidants, whereas the seed extract showed only weak antioxidant activity as in the linoleic acid emulsion system. Copyright © 2003 Society of Chemical Industry     

Selenium dioxide reaction of substituted diphenacyl sulfides: generation of α -ketoacids

The attempted selenium dioxide oxidation of substituted diphenacyl sulfides in anticipation of further functionalization led to a series of α -ketoacids 3 via oxidation followed by C?S bond cleavage. Two minor products, 5 and 6, have also been isolated and a mechanistic pathway for the formation of 3, 5 and 6 has been proposed.     

Structure‐Guided Design of Thiazolidine Derivatives as Mycobacterium tuberculosis Pantothenate Synthetase Inhibitors

The pantothenate biosynthetic pathway is essential for the persistent growth and virulence of Mycobacterium tuberculosis (Mtb) and one of the enzymes in the pathway, pantothenate synthetase (PS, EC: 6.3.2.1), encoded by the panC gene, has become an appropriate target for new therapeutics to treat tuberculosis. Herein, we report nanomolar thiazolidine inhibitors of Mtb PS developed by a rational inhibitor design approach. The thiazolidine compounds were discovered by using energy‐based pharmacophore modelling and subsequent in vitro screening, which resulted in compounds with a half maximal inhibitory concentration (IC₅₀) value of (1.12±0.12) μM . These compounds were subsequently optimised by a combination of modelling and synthetic chemistry. Hit expansion of the lead by chemical synthesis led to an improved inhibitor with an IC₅₀ value of 350 nM and an Mtb minimum inhibitory concentration (MIC) of 1.55 μM . Some of these compounds also showed good activity against dormant Mtb cells.