Decreasing the number of test specimens by utilizing both fracture stress and fracture location for the estimation of Weibull parameter

In a bending load test for brittle materials, such as ceramics for spacecraft and aircraft, decreasing the number of test specimens required is a crucial problem. This paper discusses the effectiveness of using the information of both fracture stress and fracture location to decrease the number of specimens required to obtain the same precision as the Weibull estimator. The following results were obtained: It was found that by adding the fracture location information, the precision of the Weibull parameter estimation under the optimal design became 1.5–1.9 times better compared with the case of using only the fracture stresses. This means the number of samples necessary to attain the same precision becomes 1/1.5–1/1.9. Tables and figures which give information on the number of samples necessary to attain the required precision are given.     

Volumetric properties of mixtures of 1,4-dioxane and water at high pressures

Densities of aqueous of 1,4-dioxane have been measured at temperatures from 298 to 348 K and at pressures up to 40 MPa by a vibrating-tube method. Molar volumes obtained with an estimated uncertainty of ±0.2°,% are correlated with pressure by the Tait equation within the experimental uncertainty. Pressure and composition dependences of the excess molar volume, partial molar volume, and isothermal compressibility are determined and they are compared with those of other aqueous solutions.     

An expert system for XPLE cable deterioration diagnosis and life forecasting

The recent increase in the demand for power in urban areas has caused changes in the way power is supplied. Underground distribution systems have been introduced for convenience in urban areas and to prevent injuries in case of a crisis. As a result, many new types of power cables are being used. One type, XPLE cables (also called CV cables) have been rapidly taking the place of conventional cables such as OF or SL cables since the 1960s because of their relatively easy installation and maintainability. However, distribution cables used under severe environmental conditions deteriorate rapidly (due mainly to water treeing), and some cables experience insulation breakdown. Therefore, many diagnostic methods have been developed, though they have not been very effective. By combining methods, a high reliability can be achieved in comparison to the use of a single method. However, processing the data is difficult for on-site personnel, so many experts are required. But there is a lack of qualified experts, hence we have turned to the development of expert systems.     

Is it possible to differentiate between choledochal cyst and congenital biliary atresia (type I cyst) by antenatal ultrasonography?

Both choledochal cyst and congenital biliary atresia (type I cyst) may share the same ultrasonographic pattern. We report 2 cases which were shown to have cystic structures on the upper abdomen by antenatal ultrasonography. The size of the choledochal cyst found at 24 weeks' gestation increased steadily as gestational age advanced. But the size of the cyst in congenital biliary atresia found at 29 weeks' gestation remained unchanged throughout the remaining pregnancy. Cyst enlargement, therefore, may suggest the possibility of a choledochal cyst.     

Forming mental models in learning operating procedures for terminalequipment

People faced with an unfamiliar product or service tend to fall back on mental models based on analogical relationships with familiar products or services. Two experiments on the analogical relationships or metaphors that people might use when operating a communications terminal are described. In the first experiment, the role previously acquired operating knowledge has in determining the mental models people use when directory dialing with novel equipment is examined. In a second experiment, it is shown that an explicit appeal to an analogy between conventional mail and electronic mail can help users learn to use an electronic mail system, and make it easier for them to remember how to use the system as long as 90 days after initial exposure. It is concluded that the mental model is constructed only from the user's operating knowledge acquired as a result of past experiences, and the metaphor method is effective when the instructions are metaphorically taught     

A 64-Mb DRAM with meshed power line

A 64-Mb dynamic RAM (DRAM) has been developed with a meshed power line (MPL) and a quasi-distributed sense-amplifier driver (qDSAD) scheme. It realizes high speed, t_RAS=50 ns (typical) at V_cc=3.3 V, and 16-b input/output (I/O). This MPL+qDSAD scheme can reduce sensing delay caused by the metal layer resistance. Furthermore, to suppress crosstalk noise, a V_SS shield peripheral layout scheme has been introduced, which also widens power line widths. This 64-Mb DRAM was fabricated with 0.4-μm CMOS technology using KrF excimer laser lithography. A newly developed memory cell structure, the tunnel-shaped stacked-capacitor cell (TSSC), was adapted to this 64-Mb DRAM     

Thermal Shock Behavior of Porous Silicon Carbide Ceramics

Using the water-quenching technique, the thermal shock behavior of porous silicon carbide (SiC) ceramics was evaluated as a function of quenching temperature, quenching cycles, and specimen thickness. It is shown that the residual strength of the quenched specimens decreases gradually with increases in the quenching temperature and specimen thickness. Moreover, it was found that the fracture strength of the quenched specimens was not affected by the increase of quenching cycles. This suggests a potential advantage of porous SiC ceramics for cyclic thermal-shock applications.     

Preparation of heterotactic-rich poly(methyl methacrylate) with narrow molecular weight distribution bytert-butyllithium/bis(2,6-di-tert-butylphenoxy)methylaluminum

Summary Polymerization of methyl methacrylate (MMA) withtert-butyllithium (t-C₄H₉Li) in toluene in the presence of aluminum alkoxides such as ethoxide,tert-butoxide and 2,6-di-tert-butylphenoxide, were examined at various Al/Li ratios. In the cases of ethoxide andtert-butoxide, predominantly isotactic polymers with broad molecular weight distribution were obtained. Combinations oft-C₄H₉Li and bis(2,6-ditert-butylphenoxy)methylaluminum [MeAl(ODBP)₂] were found to be an efficient initiating system for heterotactic polymerization of MMA, which gives PMMA rich in heterotactic triads up to 68% with narrow molecular weight distribution (Mw/Mn=1.09–1.17). End group analysis by¹H NMR indicated thatt-C₄H₉Li initiates the polymerization and MeAl(ODBP)₂ works as a stereospecific modifier. From stereosequence analysis of the heterotactic PMMA by¹³C NMR, it was found that the calculated pentad fractions from the first-order Markovian statistics (Pm/r=0.742, Pr/m=0.627) fitted the observed ones better than those from Bernoullian statistics. The glass transition temperature of the heterotactic PMMA was 13°C lower than that of syndiotactic PMMA, and the intrinsic viscosity in tetrahydrofuran was close to that of isotactic PMMA with a similar molecular weight but higher than that of syndiotactic PMMA.     

Regional bond strengths of self-etching/self-priming adhesive systems

Within the context of an extensive study of electroconvulsive therapy at the Psychiatric Clinic of the University of Bonn 15 patients suffering from therapy-resistant Major depression (DSM III-R) were examined with a detailed psychometric test battery, containing memory- and nonmemory tests. The test battery had been applied short time before, during and after the treatment with 10 ECT applied unilateral over the nondominant hemisphere. Comparing the test performances before and 1-2 days after the end of the series there were only few remarkable changes: a significant decrease was diagnosed exclusively in 30 min delayed recall of verbal items, while visual short-term memory and visual-constructive performance showed a significant improvement (in spite of unilateral stimulation on the right side). None of the other cognitive functions inclusively speed of performances and reaction time was detracted short time after the end of the ECT-treatment, instead all the measures improved albeit not significantly. Between responders to treatment (50% improvement in HAMD) and non-responders no significant differences neither before nor after the treatment were detected. The non-responders had in nearly all of the tests some better (but not significantly) results despite being older than the group of responders.