The investigation of 32P wire for catheter-based endovascular irradiation

The dose distribution from a 32P source has been measured and calculated in order to evaluate its application in endovascular irradiation. The source dimension was 27 mm in length and 0.3 mm in diameter and was embedded in the end of a Ni-Ti wire. Dose measurements were performed using radiochromic film in several specially designed tissue equivalent phantoms. Loevinger's point dose kernel was used for the calculation. The approximate dose rate at a radial distance of 1.5 mm from the center of the source was found to be 6.75 cGy/s per GBq (0.25 cGy/s per mCi), which allows the delivery of a therapeutic dose in a short time interval with a satisfactory homogeneity without stepping the source. However, the dose rate falls off almost exponentially along the radial distance. Therefore it may not be suitable for treating large diameter vessel from a centrally located source. The effect of a curved 32P wire source on the radial dose distribution was also investigated. The results showed that for a maximum bend of 180 degrees the dose rate was increased by as much as 20% along the inner radial distance but decreased by as much as 20% along the outer radial distance compared to the dose along a straight wire. However, for curvatures normally encountered in a clinical situation, the dose rate was changed less than 5%.     

Abdominal vagotomy alters the structure of the ingestive behavior of rats ingesting liquid diets.

A microstructural analysis of the licking behavior of the rat was used to investigate the effects of total abdominal vagotomy on ingestive behavior. Vagotomy decreased the meal size of milk and 3 concentrations of sucrose. The decrease was due to an increase in the decline in the rate of licking during the meal, suggesting that negative feedback from the gastrointestinal tract was enhanced by vagotomy, perhaps because of accelerated clearance of fluid from the stomach to the intestine. No evidence was found for motor dysfunction of licking or alterations in gustatory sensitivity to the test solution. The results suggest that vagotomy enhanced the strength of an extravagally mediated negative feedback signal from the intestine and that the vagus nerve normally prevents this from occurring by regulating gastric clearance. (PsycINFO Database Record (c) 2010 APA, all rights reserved)     

Evaluating an intelligent diagnosis system of historical text comprehension

This work aims to present and evaluate a Fuzzy-Case Based Reasoning Diagnosis system of Historical Text Comprehension. The synergism of fuzzy logic and case based reasoning techniques handles the uncertainty in the acquisition of human expert's knowledge regarding learner's observable behaviour and integrates the right balance between expert's knowledge described in the form of fuzzy sets and previous experiences documented in the form of cases. The formative evaluation focused on the comparison of the system's performance to the performance of human experts concerning the diagnosis accuracy. The system was also evaluated for its behaviour when using two different historical texts. Empirical evaluation conducted with human experts and real students indicated the need for revision of the diagnosis model. The evaluation results are encouraging for the system's educational impact on learners and for future work concerning an intelligent educational system for individualized learning.     

Maximizing learning without sacrificing the fun: Stealth assessment,adaptivity and learning supports in educational games

In this study, we investigated the validity of a stealth assessment of physics understanding in an educational game, as well as the effectiveness of different game-level delivery methods and various in-game supports on learning. Using a game called Physics Playground, we randomly assigned 263 ninth- to eleventh-grade students into four groups: adaptive, linear, free choice and no-treatment control. Each condition had access to the same in-game learning supports during gameplay. Results showed that: (a) the stealth assessment estimates of physics understanding were valid—significantly correlating with the external physics test scores; (b) there was no significant effect of game-level delivery method on students' learning; and (c) physics animations were the most effective (among eight supports tested) in predicting both learning outcome and in-game performance (e.g. number of game levels solved). We included student enjoyment, gender and ethnicity in our analyses as moderators to further investigate the research questions.     

The Free Fatty Acid Content of Fish Oil,Part II: The Effect of Anchovy Quality on the Free Fatty Acid Content of the Resulting Anchovy Oil and Meal

The free fatty acid (FFA) content of anchovy oil and the residual lipids in anchovy meal were studied as a function of the length and temperature of the delay between catching and processing the fish. It was found that there was a marked increase in the FFA content of the press oil and the residual meal lipids as a result of increased-delay between catching and processing. It was also found that — other things being equal — lean anchovy yielded oils with higher FFA values than fatty anchovy. Calculation showed that the phospholipid level of an anchovy meal may serve as a useful quality index.     

A Convenient Method for the Accurate Determination of Phosphorous in Fish Oils

The phosphorous content of fish oil was determined by acid hydrolysis for 168 h (one week) in 2 M hydrochloric acid at 120°C in glass tubes, followed by filtration and molybdenum blue colour development in an aliquot of the filtrate. The method is regarded as a convenient routine laboratory procedure, and the results obtained by the method are in good agreement with those obtained with the ashing procedure of the American Oil Chemists' Society. The determination has been satisfactorily applied to the analysis of many South African fish oils.     

Superparamagnetic polyvinylpyrrolidone/chitosan/Fe3O4 electrospun nanofibers as effective U(VI) adsorbents

Magnetoactive electrospun fibrous membranes consisting of polyvinylpyrrolidone (PVP), chitosan (CS) and pre-fabricated, double-layer oleic acid-coated magnetite nanoparticles (OA.OA.Fe₃O₄) were fabricated and evaluated as new adsorbent materials for the removal and recovery of uranium (U(VI)) from aqueous solutions. The adsorption has been investigated by batch-type experiments and the solid material has been characterized by X-ray diffraction spectroscopy (XRD), Fourier-transform infrared spectroscopy (FTIR), scanning electron microscopy (SEM), transmission electron microscopy/energy dispersive X-ray analysis (TEM/EDX) and vibration sample magnetometry (VSM) measurements prior and after uranium adsorption. The experimental adsorption data were found to be well fitted with the Langmuir isotherm and the pseudo-second order kinetic model. The results indicate that PVP/CS/OA.OA.Fe₃O₄ fibrous adsorbents exhibit good adsorption properties towards U(VI) in aqueous solutions, achieving a q_max value of 0.77 mol kg⁻¹ (183.3 mg g⁻¹) at pH 6.0. The experiments regarding the regeneration and reuse of the magnetoactive adsorbents were carried out using Na₂CO₃, at pH ~11. After four cycles, the percentage relative adsorption remained stable (~100%) whereas the desorption percentage decreased from 31.9% to 21.0%. Generally, the presented results demonstrate that the incorporation of the Fe₃O₄ NPs has a positive effect on the adsorption efficiency of U(VI) from aquatic environments.     

Structure and Magnetic Property Control of Copper Hydroxide Acetate by Non‐Classical Crystallization

Copper hydroxide acetate (CHA), one layered hydroxide compound with tunable magnetism, attracts great interest because of its potential applications in memory devices. However, ferromagnetism for CHA is only demonstrated by means of GPa pressure. Herein, a new method is reported, involving the combination of different crystallization pathways to control crystallization of amorphous CHA toward the formation of CHA/polymer composites with tunable magnetic properties and even a tunability that can be tested at room temperature. By using poly[(ethylene glycol)₆ methyl ether methacrylate]‐block‐poly[2‐(acetoacetoxy) ethyl methacrylate] (PEGMA‐b‐PAEMA) diblock copolymers as additives in combination with a post‐treatment process by ultracentrifugation, it is demonstrated that CHA and PEGMA‐b‐PAEMA form composites exhibiting different magnetic properties, depending on CHA in‐plane nanostructures. Analytical characterization reveals that crystallization of CHA is induced by ultracentrifugation, during which CHA nanostructures can be well controlled by changing the degrees of polymerization of the PEGMA and PAEMA blocks and their block length ratios. These findings not only present the first example of using crystallization from polymer stabilized amorphous precursors toward the generation of magnetic nanomaterials with tunable magnetism but also pave the way for the future design of functional composite materials.     

Processing and characterisation of precision microparts from nickel-based materials

The objective of this research was to study the influence of electroplating parameters on electrodeposit characteristics for the production of nickel (Ni) and nickel–iron (Ni–Fe) microparts by photoelectroforming. The research focused on the most relevant parameter for industry, which is the current density, because it determines the process time and the consumed energy. The results of the Ni and Ni–Fe characterisations can be divided into two aspects closely linked with each other: the morphology and the hardness.