Employment status passages and psychosocial well-being.

Medical students entering the labor market were studied to find out whether the improvement of psychosocial well-being depends on characteristics of their careers. Psychosocial well-being was described on the basis of psychosomatic stress symptoms, psychological distress (General Health Questionnaire), and strain resistance resources (Sense of Coherence). The 3-year follow-up showed that among women the improvement of strain resistance resources was delayed in the group with several entries into work. Among men the findings suggested associations between stress symptoms and career characteristics. Most of the results, however, did not support the hypothesis about the division of the participants into those with a stable career and improving well-being and those with a fragmented career and low well-being. (PsycINFO Database Record (c) 2010 APA, all rights reserved)     

Development of Cr and Al Pack Cementation Coatings on Co-Based γ/γ′ Superalloys

Metallurgical and Materials Transactions A - Co-based superalloys have been developed as candidate materials to replace Ni-based superalloys in hot sections of turbine engines, however, their...     

Passive and transpassive behaviour of CoCrMo in simulated biological solutions

In this work, the behaviour of a CoCrMo alloy under simulated body conditions was investigated. More specifically, the electrochemical properties of the alloy and the relevant mechanisms in the passive and transpassive states were studied in detail. Electrochemical techniques such as potentiodynamic and potentiostatic polarisation, cyclic voltammetry, rotating disc electrode and electrochemical impedance spectroscopy were employed. Further, ex situ X-ray photoelectron spectroscopy analysis of the passive films was carried out. A good correlation between the results obtained from all the experimental techniques was achieved. Overall, it was found that the passive film on CoCrMo changed in composition and thickness with both potential and time. The passive behaviour of the CrCrMo alloy is due to a formation an oxide film highly enriched with Cr (≈90% Cr oxides) on the alloy surface. The passive and transpassive behaviour of the alloy is hence dominated by the alloying element Cr. In the transpassive region, strong thickening of the oxide film takes place, combined with a change in the composition of the film, and strongly increased dissolution rate. In the transpassive region, all alloying elements dissolve according to the composition of the alloy. The metal ion release is also very strongly enhanced by cyclic variation of the potential between reducing and oxidizing conditions. In this case, during activation/repassivation cycles, cobalt dissolution is greater than expected from the composition of the alloy. Therefore, active dissolution behaviour is mainly dominated by the alloying element Co.     

Stress and strain state of concrete during freezing and thawing cycles

The objective of this work is to calculate the pressures, stresses, and strains induced into moist concrete during freezing and thawing. The applied theory is based on thermodynamics and the linear theory of elasticity. If no additional salts are dissolved in the pore water the inputs needed in the theory are relative humidity and temperature measured in the sample chamber and inside concrete and evaporable water amount in the pore structure. Theoretical results were compared with the test results made with two concretes cured under water or at 96% relative humidity. One of the concretes was air entrained and in the comparison concrete no air-entraining agents were used. In the test cylinders cured under water the largest tensional stresses in freezing occurred on the surface of the test cylinders both in the axial and tangential direction. The largest tensional stress was 2.2 MPa, both in air-entrained and in non air-entrained concretes. The largest tensional stresses in the warming phase took place at the end of the thawing period when the chamber temperature was around +5 °C. Then the maximum tension occurred in the middle of the concrete cylinder in the axial direction of the cylinder. This maximum tensional stress was over 2.5 MPa in the air-entrained concrete cured in the relative humidity of 96%. The thermodynamic pumping effect at the end of the thawing phase in every cycle can increase the pore water amount remarkably if free water or moisture is available on the surface of the structure or in the environment vapor. The thermodynamic pumping effect seems to be remarkably greater and more dangerous in air-entrained concretes.     

Reaction engineering studies in a polytropic fixed-bed reactor over a highly active and selective catalyst for oxidative methane coupling

The oxidative coupling of methane (OCM) was carried out in a polytropic fixed-bed reactor applying a Zr/La/Sr catalyst developed by the Neste company. Over this catalyst the OCM reaction follows a complex reaction scheme which includes primary parallel reaction steps to CO, CO₂ and C₂H₆ and consecutive reactions of ethane to ethylene or CO_x. Yield of higher hydrocarbons C₂₊ obtained with this catalyst strongly depended on reaction conditions, i.e. low partial pressures of methane and oxygen obtained by diluting the feed gas with nitrogen and high reaction temperatures promoted C₂₊ selectivity and yield. The maximum yield amounted to 21.4% (20 Vol.-% CH₄, 9 Vol.-% O₂, 71 Vol.-% N₂, T = 860°C; X_CH4 = 41.8%, S = 52.5%). This result belongs to the highest yields reported in the open literature.     

A new method for evaluating the subjective image quality of photographs: dynamic reference

The Dynamic Reference (DR) method has been developed for subjective image quality experiments in which original or undistorted images are unavailable. The DR method creates reference image series from test images. Reference images are presented to observers as a slide show prior to evaluating their quality. As the observers view the set of reference images, they determine the overall variation in quality within the set of test images. This study compared the performance of the DR method to that of the standardized absolute category rating (ACR) and paired comparison (PC) methods. We measured the performance of each method in terms of time effort and discriminability. The results showed that the DR method is faster than the PC method and more accurate than the ACR method. The DR method is especially suitable for experiments that require highly accurate results in a short time.     

On the human ability to discriminate audio ambiances from similar locations of an urban environment

When developing advanced location-based systems augmented with audio ambiances, it would be cost-effective to use a few representative samples from typical environments for describing a larger number of similar locations. The aim of this experiment was to study the human ability to discriminate audio ambiances recorded in similar locations of the same urban environment. A listening experiment consisting of material from three different environments and nine different locations was carried out with nineteen subjects to study the credibility of audio representations for certain environments which would diminish the need for collecting huge audio databases. The first goal was to study to what degree humans are able to recognize whether the recording has been made in an indicated location or in another similar location, when presented with the name of the place, location on a map, and the associated audio ambiance. The second goal was to study whether the ability to discriminate audio ambiances from different locations is affected by a visual cue, by presenting additional information in form of a photograph of the suggested location. The results indicate that audio ambiances from similar urban areas of the same city differ enough so that it is not acceptable to use a single recording as ambience to represent different yet similar locations. Including an image was found to increase the perceived credibility of all the audio samples in representing a certain location. The results suggest that developers of audio-augmented location-based systems should aim at using audio samples recorded on-site for each location in order to achieve a credible impression.     

Validation of the Climate-SAF surface broadband albedo product: Comparisons with in situ observations over Greenland and the ice-covered Arctic Ocean

This paper describes a validation study performed by comparing the Climate-SAF Surface Albedo Product (SAL) to ground truth observations over Greenland and the ice-covered Arctic Ocean. We compare Advanced Very High Resolution Radiometer (AVHRR)-based albedo retrievals to data from the Greenland Climate Network (GCN) weather stations and the floating ice station Tara for polar summer 2007. The AVHRR dataset consists of 2755 overpasses. The overpasses are matched to in situ observations spatially and temporally. The SAL algorithm presented here derives the surface broadband albedo from AVHRR channels 1 and 2 using an atmospheric correction, temporal sampling of an empirical Bidirectional Reflectance Distribution Function (BRDF), and a narrow-to-broadband conversion algorithm. The satellite product contains algorithms for snow, sea ice, vegetation, bare soil, and water albedo. At the Summit and DYE-2 stations on the Greenland ice sheet, instantaneous SAL RMSE is 0.073. The heterogeneous surface conditions at satellite pixel scale over the stations near the Greenland west coast increase RMSE to > 0.12. Over Tara, the instantaneous SAL RMSE is 0.069. The BRDF sampling approach reduces RMSE over the ice sheet to 0.053, and to 0.045 over Tara. Taking into account various sources of uncertainty for both satellite retrievals and in situ observations, we conclude that SAL agrees with in situ observations within their limits of accuracy and spatial representativeness.     

Overlap-freeness in infinite partial words

We prove that there exist infinitely many infinite overlap-free binary partial words containing at least one hole. Moreover, we show that these words cannot contain more than one hole and the only hole must occur either in the first or in the second position. We define that a partial word is $k$-overlap-free if it does not contain a factor of the form $xyxyx$ where the length of $x$ is at least $k$. We prove that there exist infinitely many 2-overlap-free binary partial words containing an infinite number of holes.     

Extension of the decidability of the marked PCP to instances with unique blocks

In the Post Correspondence Problem (PCP) an instance (h,g)$(h,g)$ consists of two morphisms h$h$ and g$g$, and the problem is to determine whether or not there exists a nonempty word w$w$ such that h(w)=g(w)$h\left(w\right)=g\left(w\right)$. Here we prove that the PCP is decidable for instances with unique blocks using the decidability of the marked PCP. Also, we show that it is decidable whether an instance satisfying the uniqueness condition for continuations has an infinite solution. These results establish a new and larger class of decidable instances of the PCP, including the class of marked instances.