Comparison of the GFFF and LALLS Methods for the Measurement of Starch Granule Size Distribution in Spring Barley Caryopses

A newly developed method GFFF (Gravitational Field‐Flow Fractionation) and the well known method LALLS (Low Angle Laser Light Scattering) were used to assess starch granule size distribution of ten varieties of spring barley. As a distribution criterion, the ratio of starch granule content larger than 8 μm (type A) and smaller than 8 μm (type B) was chosen. Both methods divided the observed set in a similar way. Varieties Akcent, Forum and Atribut formed a variety set with the highest ratio of large and small starch granules. Varieties Scarlet and Kompakt had intermediate ratios. The remaining five varieties Amulet, Novum, Olbram, Tolar and Krona had the lowest ratios of large and small starch granules. Statistical analysis showed that there was a highly significant correlation between the GFFF and LALLS methods.     

Dietary stearic acid and risk of cardiovascular disease: Intake,sources, digestion,and absorption

Individual FA have diverse biological effects, some of which affect the risk of cardiovascular disease (CVD). In the context of food-based dietary guidance designed to reduce CVD risk, fat and FA recommendations focus on reducing saturated FA (SFA) and trans FA (TFA), and ensuring an adequate intake of unsaturated FA. Because stearic acid shares many physical properties with the other long-chain SFA but has different physiological effects, it is being evaluated as a substitute for TFA in food manufacturing. For stearic acid to become the primary replacement for TFA, it is essential that its physical properties and biological effects be well understood.     

Calcium sulphide formation in fluidized bed boilers

Analyses of samples of bed ash from a stationary fluidized bed boiler show the presence of calcium sulphide. In some samples, half of the total sulphur was present as sulphide. The samples containing CaS were obtained under unstaged conditions and with a high excess air ratio, 1.3 to 1.4. The samples were taken after a stop in the limestone addition, i.e. at high SO₂ emissions of about 1000 mL/m³ (ppm). No CaS was found during limestone addition when the SO₂ emission was 300–400 mL/m³. This indicates that formation of large amounts of CaS may be initiated as the SO₂ concentration exceeds some critical level.     

Capillary Electrophoretic Analysis Reveals Subcellular Binding between Individual Mitochondria and Cytoskeleton

Interactions between the cytoskeleton and mitochondria are essential for normal cellular function. An assessment of such interactions is commonly based on bulk analysis of mitochondrial and cytoskeletal markers present in a given sample, which assumes complete binding between these two organelle types. Such measurements are biased because they rarely account for nonbound "free" subcellular species. Here we report on the use of capillary electrophoresis with dual laser induced fluorescence detection (CE-LIF) to identify, classify, count, and quantify properties of individual binding events of the mitochondria and cytoskeleton. Mitochondria were fluorescently labeled with DsRed2 while F-actin, a major cytoskeletal component, was fluorescently labeled with Alexa488-phalloidin. In a typical subcellular fraction of L6 myoblasts, 79% of mitochondrial events did not have detectable levels of F-actin, while the rest had on average ～2 zmol of F-actin, which theoretically represents a ～2.5 μm long network of actin filaments per event. Trypsin treatment of L6 subcellular fractions prior to analysis decreased the fraction of mitochondrial events with detectable levels of F-actin, which is expected from digestion of cytoskeletal proteins on the surface of mitochondria. The electrophoretic mobility distributions of the individual events were also used to further distinguish between cytoskeleton-bound from cytoskeleton-free mitochondrial events. The CE-LIF approach described here could be further developed to explore cytoskeleton interactions with other subcellular structures, the effects of cytoskeleton destabilizing drugs, and the progression of viral infections.     

Dielectric response and structure of amorphous hydrogenated carbon films with nitrogen admixture

The optical properties and structure of a-C:H films were modified by addition of nitrogen into the CH₄/H₂ deposition mixture. Three films prepared in capacitively coupled rf discharge were compared: (a) hydrogenated diamond like carbon film with hydrogen content of 34% and indentation hardness of 21.7 GPa, (b) hard a-C:H:N film with nitrogen content of 13% and indentation hardness of 18.5 GPa and (c) soft a-C:H:N film with nitrogen content of 10% and indentation hardness of 6.7 GPa. It is shown how the parametrized density of states model describing dielectric response of electronic interband transitions can be applied to modified a-C:H:N and how it can be combined with correct treatment of transmittance measured in infrared range using additional Gaussian peaks in joint density of phonon states. This analysis resulted in determination of film dielectric function in wide spectral range (0.045-30 eV) and provided also information about the density of states of valence and conduction bands and lattice vibrations.     

Effect of thiourea on thiuram-accelerated sulfur vulcanization and its significance for vulcanization mechanism

Tetramethylthiuram disulfide-accelerated sulfur vulcanization of natural rubber has been investigated at temperatures from 100°C to 140°C. Continuous measurements in a Vuremo curemeter were used to estimate the extent of crosslinking, which was plotted against cure time. The linearized forms of the cure curves clearly show that at lower cure temperatures, the course of vulcanization differs significantly from the first-order rate law. These digressions were removed by the addition of thiourea, which simultaneously speeds up the course of vulcanization and diminishes its activation energy on the one hand but, on the other hand, diminishes the ultimate extent of crosslinking. On the basis of the above results, the mechanism of thiuram-accelerated sulfur vulcanization, in which ionic and radical reactions take place, is discussed.     

50 Years of Progress in Quality of Malting Barley Grown in the Czech Republic

This paper summarizes the results of study of malting and agronomic characteristics of barley varieties grown in the territory of the Czech Republic over the period 1955–2005. Mean year‐on‐year increase in the grain yield was 53 kg/ha. Mean increase in TGW was 0.177 g/year over the studied period. Accumulation of protein in the studied varieties declined ca by 12%. Varieties from the beginning of the 21st century displayed a 4% higher extract content than those grown in the second half of the 1950s. Mean year‐on‐year increase in extract (d.m.) was a 0.0641 percentage point. By the end of the 1970s most of the varieties achieved values of diastatic power higher than 300°WK. In the 1970s to 1980s, diastatic power declined to under the level of 300°WK. In the 2nd half of the 1990s and at the beginning of this century, activity of amylolytic enzymes increased considerably in some modern varieties and values of diastatic power frequently moved over 350°WK. Activity of proteolytic enzymes increased by 6%. Mean year‐on‐year increase in Kolbach index was a 0.1456 percentage point. Value of relative extract at 45°C increased by 3%. Mean year‐on‐year increase in relative extract at 45°C was a 0.0645 percentage point over the studied period. Value of the apparent final attenuation, a trait characterizing quality of wort composition, increased by 3%. Mean inter‐year increase in apparent final attenuation was a 0.0756 percentage point.     

Effect of zinc oxide concentration on the course of thiuram-accelerated sulfur vulcanization

Tetramethylthiuram disulfide-accelerated sulfur vulcanization of natural rubber has been investigated. Continuous measurements in a Vuremo curemeter at 145°C were used to estimate the effects of zinc oxide concentration on the induction periods, on the first-order rate constants, and on the ultimate extents of crosslinking, on the extents of degradation reaction (reversion), and on the extents of relaxation of vulcanizates at the cure temperature. The concentration of zinc oxide has practically no influence on the rate of thiuram-accelerated sulfur cure. The values of the ultimate extents of crosslinking increase with increasing the zinc oxide content in the rubber compound up to a certain limit corresponding to the theoretical amount of zinc oxide which is necessary for the formation of zinc dimethyldithiocarbamate from tetramethylthiuram disulfide and zinc oxide during the vulcanization reaction. From the point of view of the reversion, however, this limit value of zinc oxide concentration is not sufficient. The relaxation measurements provide the same results. On the basis of these, for thiuram-accelerated sulfur vulcanizations, the optimum zinc oxide content in the rubber mix of 2.5 phr has been calculated. This value is in very good agreement with the optimum value of zinc oxide concentration found for both sulfenamides and thiazoles-accelerated sulfur cures.