Benchmark experiment of large-angle scattering reaction cross section of iron at 14 MeV using two shadow bars – Comparison of experimental results with ENDF/B-VIII –

ABSTRACT

It is important to perform neutron transport simulations with accurate nuclear data in the neutronics design of a fusion reactor. However, absolute values of large-angle scattering cross sections vary among nuclear data libraries even for well-examined nuclide of iron. Benchmark experiments focusing on large-angle scattering cross sections were thus performed to confirm the correctness of nuclear data libraries. The series benchmark experiments were performed at a DT neutron source facility, OKTAVIAN of Osaka University, Japan, by the unique experimental system established by the authors’ group, which can extract only the contribution of large-angle scattering reactions. This system consists of two shadow bars, target plate (iron), and neutron detector (niobium). Two types of shadow bars were used and four irradiations were conducted for one experiment, so that contribution of room-return neutrons was effectively removed and only large-angle scattering neutrons were extracted from the measured four Nb reaction rates. The obtained experimental results were compared with calculations for five nuclear data libraries including JENDL-4.0, JEFF.-3.3, FENDL-3.1, ENDF/B- VII, and recently released ENDF/B-VIII. It was found from the comparison that ENDF/B-VIII showed the best result, though ENDF/B-VII showed overestimation and others are in large underestimation at 14 MeV.     

Ammonia production using iron nitride and water as hydrogen source under mild temperature and pressure

Ammonia generation was studied in the reaction between water and nitrogen-containing iron at 323 K and atmospheric pressure. Similar to metallic Fe, the interstitial compound Fe₃N reduced water through Fe oxidation to produce hydrogen gas, while the N combined with atomic hydrogen to produce ammonia as a byproduct. The addition of carbon dioxide to this system accelerated the reaction with concomitant consumption of carbon dioxide. The promoted ammonia production upon addition of carbon dioxide can be attributed to the generation of atomic hydrogen from the redox reaction of carbonic acid and Fe, as well as removal of used Fe from the reaction system through the formation of a soluble carbonato complex. When carbonate was added to the reaction system, the production rates of ammonia and hydrogen increased further. The results here confirmed that ammonia can be synthesized from iron nitride under mild conditions by utilizing carbon dioxide.     

Molecular Targeted Therapy for the Bone Loss Secondary to Pyogenic Spondylodiscitis Using Medications for Osteoporosis: A Literature Review

Pyogenic spondylodiscitis can cause severe osteolytic and destructive lesions in the spine. Elderly or immunocompromised individuals are particularly susceptible to infectious diseases; specifically, infections in the spine can impair the ability of the spine to support the trunk, causing patients to be bedridden, which can also severely affect the physical condition of patients. Although treatments for osteoporosis have been well studied, treatments for bone loss secondary to infection remain to be elucidated because they have pathological manifestations that are similar to but distinct from those of osteoporosis. Recently, we encountered a patient with severely osteolytic pyogenic spondylodiscitis who was treated with romosozumab and exhibited enhanced bone formation. Romosozumab stimulated canonical Wnt/β-catenin signaling, causing robust bone formation and the inhibition of bone resorption, which exceeded the bone loss secondary to infection. Bone loss due to infections involves the suppression of osteoblastogenesis by osteoblast apoptosis, which is induced by the nuclear factor-κB and mitogen-activated protein kinase pathways, and osteoclastogenesis with the receptor activator of the nuclear factor-κB ligand-receptor combination and subsequent activation of the nuclear factor of activated T cells cytoplasmic 1 and c-Fos. In this study, we review and discuss the molecular mechanisms of bone loss secondary to infection and analyze the efficacy of the medications for osteoporosis, focusing on romosozumab, teriparatide, denosumab, and bisphosphonates, in treating this pathological condition.     

Erythroid potentiating activity of tissue inhibitor of metalloproteinases on the differentiation of erythropoietin-responsive mouse erythroleukemia cell line, ELM-I-1-3, is closely related to its cell growth potentiating activity

The erythroid-potentiating activity (EPA) of the tissue inhibitor of metalloproteinase-1 (TIMP-1) was re-examined using ELM-I-1-3, a mouse erythroleukemia cell line, which responded well to erythropoietin. Depletion of pre-existing TIMP-1 from fetal calf serum in culture medium using monoclonal antibody suppressed erythropoietin-induced differentiation as measured by the induction of hemoglobin, commitment assay and globin mRNAs. The removal of TIMP-1 also suppressed the proliferation of ELM-I-1-3 as measured by cell number and de novo DNA synthesis. These changes were reversed by the addition of purified TIMP-1 to the culture medium. Anti-TIMP-1 antibody also blocked both hexamethylene bisacetamide (HMBA)-induced erythroid differentiation and the proliferation of both ELM-I-1-3 and Friend erythroleukemia cells. Considering previous reports analyzing the chemical induction of Friend mouse erythroleukemia cell differentiation, our results suggest that erythropoietin- or HMBA-induced erythroid differentiation might also be coupled with cell proliferation. Our 3H thymidine-uptake experiment shows that TIMP-1 removal was also effective in the inhibition of cell growth of various other cell lines in addition to erythroleukemia cell lines. These results suggest that EPA action of TIMP-1 on erythroid leukemia cell lines is closely related to its activity to promote the cell growth of various cell lines and cells including erythroleukemia cell lines.     

The effect of additional albumin with optimal concentration on the reperfusion after preservation of isolated rat hearts

Glucagon has been demonstrated to stimulate the uptake of bile acid in isolated rat hepatocytes (Am. J. Physiol., 249, G427 (1985)). In the present study, we determined the influence of glucagon on the hepatic transport of a bile acid, taurocholate (TCA), in isolated rat livers. A single-pass perfusion and a rapid-injection, multiple indicator dilution method were employed. The hepatic availability at steady-state was 0.04. With the presence of glucagon in the perfusate (from 10(-9) to 10(-7) M), the bile flow rate was stimulated by 30%, while hepatic availability was decreased from 0.04 to 0.02 with a stepwise increase in glucagon concentration. Thirty min after the infusion of glucagon (300 nM), [3H]TCA and [14C]inulin were injected in a bolus state into the portal vein, and the outflow was collected at 1.0 s intervals over 30 s. Glucagon decreased the instantaneous hepatic availability by 50% compared to the control level, and was thus compatible with the steady-state experiments. In the control experiment, the influx clearance (PSinf) was 20 times higher than the efflux clearance (PSeff). Glucagon (300 nM) in the perfusate enhanced PSinf by 50% of the control, whereas sequestration clearance (CLseq) and the biliary excretion rate constant remained unchanged. PSeff was stimulated to 2 times the control, but still remained much smaller than CLseq. Based on the comparison of PSinf, PSeff and CLseq, the rate-determining process of TCA hepatic elimination was the influx process in both the presence and absence of glucagon. Taken together, the enhancement of the influx process was responsible for the decrease in TCA hepatic availability caused by glucagon.(ABSTRACT TRUNCATED AT 250 WORDS)     

Moisture migration in idealized bilayer systems: relationships among water-associated properties, structure, and texture

The effects of composition and thermal treatment on the water sorption and diffusional properties of idealized protein gels arranged in bilayer configurations were determined; these water binding/migration properties were related to the mechanical characteristics of the gels. Samples were prepared from whey protein concentrate (WPC), they consisted of water:WPC ratios of 1.5 to 5.67, and were thermally set for 20–60 min. Moisture migration rates from samples interfaced with filters were determined, as were moisture sorption capacities of samples immersed in water. The physical properties of the gels were assessed by uniaxial compression and microscopy. Results showed that gel strength and consequent extent of protein interaction—as affected by thermal treatment—controlled the ability of the gel structure to absorb water. Sorption was exponentially correlated with gel modulus and linearly correlated with a function of protein content, heating time, and immersion time. Rates of diffusion from interfaced gels were dependent solely on water content. It was concluded that the degree of protein interaction, whether influenced by concentration or thermal treatment, affected network extensibility and thus the capacity of the gels to act as receptors of moisture. Results have implications for the functionality of shelf-stable sandwiches and other multicomponent foods.     

Improvement of levitation characteristics in a magnetic bearing system using HTSC‐permanent magnet hybrid structure

Magnetic bearing using pinning force of a permanent magnet and a high‐temperature superconductor has been developed. Additional permanent magnet is introduced to increase the levitation force of the magnetic bearing. In this hybrid magnetic bearing system, levitation force is mainly given by the repulsive force of the permanent magnets, and stability for the lateral direction is given by pinning force of the superconductor. The experimental device is developed. A ring‐type superconductor and a bulk one are examined. Levitation characteristics of the hybrid magnetic bearing are measured. The bulk superconductor shows better characteristics of both levitation and lateral stability than the ring one. Levitation force of the hybrid system becomes about twice as large as that of the nonhybrid one. Although, the repulsive force of the permanent magnet decreases the lateral stability of the system, its influence becomes small by choosing an adequate position of the permanent magnets and the superconductor. © 2004 Wiley Periodicals, Inc. Electr Eng Jpn, 150(1): 71–77, 2005; Published online in Wiley InterScience ( www.interscience.wiley.com ). DOI 10.1002/eej.10350     

Effect of Pressure on Intermediate Valence States in Cerium Kondo Compounds

Electrical resistance, thermal expansion, lattice constants of the intermediate valence materials, α-Ce and CeBe13, were measured at high pressure. It is found that the Grttneisen parameters of Kondo temperature TK are 13 and 42 for α-Ce and CeBe13, respectively, and it decreases with increasing pressure. The magnetoresistance of α-Ce shows H^2 dependence and its coefficient increases with pressure below 1 GPa, but becomes nearly constant above 1 GPa. The results indicate that the intermediate valence states are enhanced at high pressure indicating the enhancement of hybridization between the 4f electron and conduction band.     

Sensors for the food industry

This article presents an overview of the results of a five-year research project on sensors for the food industry in Japan. This project was a government-sponsered research programme involving the food industry and the instrumentation industry, coordinated by the Japanese Ministry of Agriculture, Forestry and Fisheries. The programme focussed on 17 food processing operations and quality control tasks, where the need for an on-line (or rapid at-line) measurement had been established. The instrument development work employed biosensors pH and gas sensors, optical-imaging devices, as well as near-infrared, microwave, ultrasound and mechanical resonance techniques, together with robotics and advanced data-processing techniques.     

Antimicrobial and antifungal agents derived from clay minerals

A silver chelate of 2-(4-thiazolyl)-benzimidazole, dodecyltrimethylammonium cation and hexadecylpyridinium cation have been intercalated between montmorillonite, and the resulting samples were subjected to examination of their thermostabilities by thermogravimetry and carbon dioxide evolution analysis up to 500 °C in air. The degradation behaviour of the intercalant was significantly changed by intercalating between the montmorillonite layers. Two quaternary ammonium cations were released from the montmorillonite both at the same temperature, which was higher than those for the quaternary ammonium cations themselves. This relation was also observed in the case of 2-(4-thiazolyl)-benzimidazole. The improvement of the thermostability after intercalation can be attributed to the bonding between the intercalant and the host montmorillonite layers.