Grain Boundary Sliding in Fatigue of Pure Aluminum

The distributions of plastic strain near grain boundaries induced by fatigue loading were investigatedby the fiducial grid method in pure aluminum specimens, and the resulted grain boundary sliding(GBS) was systematically analysed. The results show that the strain field near a grain boundary isnonuniform. GBS is restricted by the junction of grain boundaries and causes discontinuities of bothdisplacement and strain. A peak value of shear strain was created in short-range area across the grainboundary. GBS plays an important role in cyclic softening and secondary hardening. The control fac-tor of GBS is the relative orientation between two grains and the macro orientation of the grainboundary rather than the ∑ value of the boundary.     

注射成形粘结NdFeB磁体:工艺·性能·应用

综合介绍了几种适于注射成形粘结NdFeB磁体的磁粉制备方法及特点；讨论了粘结剂、改性剂及磁场取向对注射成形NdFeB磁体最终磁性能的影响及其应用市场。在此基础上，指出了今后开展研究工作的方向。     

WC对Cu/WC_P复合材料性能及组织的影响

通过ＷＣ含量对ＷＣ／Ｃｕ复合材料性能的影响，确定了冷压－烧结法制备Ｃｕ／ＷＣ材料的适宜ＷＣ含量为１０ｖｏｌ％左右。并就ＷＣ对该材料组织和再结晶行为的影响进行了有益的探讨。     

The Effect of the Charge Fluctuation of Dust Parti-cles on Ion-acoustic Wave Excited Through Ionization Instability

The effect of the charge fluctuation of dust particles on ion acoustic wave (IAW) excited through ionization instability was investigated. The hydrodynamic equations and linear time-dependent perturbation theory served as the starting point of theory, by which the dispersion relation and growth rate of the IAW were given. By comparing the results with the case of constant dust charges, it was found that the charge fluctuation of dust particles reduces the instability of the wave mode.     

化学镀镍合金在电子工业中的应用

对化学镀镍合金铁工艺和性能特性及其在电子工业中的应有委展现状作了评述。化学镀镍合金具有镀层均匀，适用基材广，结合力高，硬度高，优良的耐磨、耐蚀性，可焊性好和特殊的电磁性能等特性，在电子工业中获得了广泛的应用。文中着重介绍了化学镀镍合金在磁盘、电磁屏蔽、微电路、半导体、连接器及薄膜电阻上的应用情况。这些案例说明，合理应用化学镀镍合金技术，有利于提高电子元器件的质量，降低成本，促进技术进步。     

反应烧结法制备MgAlON的合成机理及烧结行为的研究

通过对以Al2 O3、MgO和AlN为起始原料 ,在氮气气氛中反应烧结合成MgAlON材料合成机理的研究发现 :在 12 0 0℃以前 ,MgO与Al2 O3反应生成镁铝尖晶石 ,此后 ,随着温度的升高 ,Al2O3不断向所形成的尖晶石中固溶 ;在 130 0℃以前 ,AlN基本上不参与反应 ,而在更高的温度下 ,AlN开始向尖晶石中固溶形成MgAlON ,约在 15 5 0℃时形成单一的MgAlON相。用热膨胀仪检测了试样的线变化率随温度和时间的变化 ,用最小二乘法回归分析了试样线变化率的实验数据 ,并根据烧结理论对MgAlON材料烧结初期的动力学进行了探讨。结果表明 ,MgAlON材料烧结初期的烧结机理以体积扩散为主     

PbS-Sb2S3-FeS三元系在水蒸气气氛下的铅锑分离

在1073K下通过测定三硫化锑和硫化铅的挥发速度,研究了PbS-Sb_2S_3-FeS三元系在水蒸气气氛下的铅锑分离规律。X-射线衍射结果表明,焙砂由PbS、Fe_3O_4、FePb_4Sb_6S_(14)、Pb_5Sb_4S_(11)和FeSb_2O_4组成。当试样中FeS含量在5％～7％时,铅锑分离效果最好。当试样中FeS的含量≥10％时,铅锑分离效果较差,这时过量的FeS会与Sb_2S_3和PbS形成复杂的硫化物(FePb_4Sb_6S_(14)、Pb_5Sb_4S_(11))或被氧化成F4Sb_2O_4,使锑的挥发变得困难,导致残留在焙砂中的锑含量升高。     

ZT3钛合金标准物质均匀性的检验

本文采用方差分析法和平均值一致性检验法来检验钛合金标准物质的均匀性,通过铝和硅两个元素的计算,证明该标准物质均匀度良好,数理统计在分析化学中逐步在应用,这将为今后标准物质的研制开辟新的途径。     

The Stability of Rare Earth-Iron-Nitrides Sm_2(Fe,M)_(17)N_y,Permanent Magnets

The effects of the partial substitution of element M(M=Cr,V,Mn,x=0.05;Zr,Ga,x=0.017;Si,x=0.15;Co,x=0.10)for Fe in samarium-iron-nitride Sm_2(Fe_(1-x)M_x)_(17)N_y compounds on their stabilitiesand Curie temperatures have been studied.It is found that Co,Ga can raise the Curie temperature of thecompounds.The initial decomposition temperatures cannot be raised significantly by all the studied elementsexcept Co.The result contradicts the formation enthalpy consideration.The final decomposition tempera-tures can be raised by all of the substitution elements.The effects of atmospheres on their decomposition be-havior were also studied.The results show that oxidation is the major reason for magnetic deterioration ofthe powder heated in air.Compared with nitrogen atmosphere,argon or vacuum helps to delay the decompo-sition of the compounds.     

快速凝固Al—Li—Mg—Zr合金粉末粒度对组织和性能影响

研究超音雾化快速凝固Al—Li—Mg—Zr合金粉末粒度对组织和性能的影响中发现,粉末粒度越细,组织越细,合金强度越大;但粒度太细,又会导致塑性变差。试验合金粒度范围选用40—100μm为佳。