Heat Transfer Analysis for Gas-to-Liquids Transportation Through Trans Alaska Pipeline

Gas-to-liquids (GTL) technology involves the conversion of natural gas to liquid hydrocarbons. In this article, theoretical studies have been presented to determine the feasibility of transporting GTL products through the Trans-Alaska Pipeline System (TAPS). To successfully transport GTL through TAPS, heat loss along the route must be carefully determined. This study presents heat transfer and fluid dynamic calculations to evaluate this feasibility. Because of heat loss, the fluid temperature decreases in the direction of flow and this affects the fluid properties, which in turn influence convection coefficient and pumping power requirements. The temperature and heat loss distribution along the pipeline at different locations have been calculated. Fairly good agreement with measured oil temperatures is observed. The powers required to pump crude oil and GTL individually, against various losses have been calculated. Two GTL transportation modes have been considered; one as a pure stream of GTL and the second as a commingled mixture with crude oil. These results show that the pumping power and heat loss for GTL are less than that of the crude oil for the same volumetric flow rate. Therefore, GTL can be transported through TAPS using existing equipment at pump stations.     

BRCA1 mutations in women attending clinics that evaluate the risk of breast cancer

BACKGROUND: To define the incidence of BRCA1 mutations among patients seen in clinics that evaluate the risk of breast cancer, we analyzed DNA samples from women seen in this setting and constructed probability tables to provide estimates of the likelihood of finding a BRCA1 mutation in individual families. METHODS: Clinical information, family histories, and blood for DNA analysis were obtained from 263 women with breast cancer. Conformation-sensitive gel electrophoresis and DNA sequencing were used to identify BRCA1 mutations. RESULTS: BRCA1 mutations were identified in 16 percent of women with a family history of breast cancer. Only 7 percent of women from families with a history of breast cancer but not ovarian cancer had BRCA1 mutations. The rates were higher among women from families with a history of both breast and ovarian cancer. Among family members, an average age of less than 55 years at the diagnosis of breast cancer, the presence of ovarian cancer, the presence of breast and ovarian cancer in the same woman, and Ashkenazi Jewish ancestry were all associated with an increased risk of detecting a BRCA1 mutation. No association was found between the presence of bilateral breast cancer or the number of breast cancers in a family and the detection of a BRCA1 mutation, or between the position of the mutation in the BRCA1 gene and the presence of ovarian cancer in a family. CONCLUSIONS: Among women with breast cancer and a family history of the disease, the percentage with BRCA1 coding-region mutations is less than the 45 percent predicted by genetic-linkage analysis. These results suggest that even in a referral clinic specializing in screening women from high-risk families, the majority of tests for BRCA1 mutations will be negative and therefore uninformative.     

Response level crossing rate of a linear system excited by a partially specified Gaussian load process

The problem of determining the maximum mean response level crossing rate of a linear system driven by a partially specified Gaussian load process has been considered. The partial specification of the load is given only in terms of its total average energy. The critical input power spectral (PSD) function, which maximizes the mean response level crossing rate, is obtained. The critical input PSD turns out to be highly narrow-banded which fails to capture the erratic nature of the excitation. Consequently, the trade-off curve between the maximum mean response level crossing rate and the maximum disorder in the input process, quantified in terms of its entropy rate, has been generated. The method of Pareto optimization is used to tackle the conflicting objectives of the simultaneous maximization of the mean response level crossing rate and the input entropy rate. The non-linear multi-objective optimization has been carried out using a recently developed multi-criteria genetic algorithm scheme. Illustrative example of determining the critical input of an axially vibrating rod, excited by a partially specified stationary Gaussian load process, has been considered.     

Pad effects on material-removal rate in chemical-mechanical planarization

The role of a porous pad in controlling material-removal rate (MRR) during the chemical-mechanical planarization (CMP) process has been studied numerically. The numerical results are used to develop a phenomenological model that correlates the forces on each individual abrasive particle to the applied nominal pressure. The model provides a physical explanation for the experimentally observed domains of pressure-dependent MRR, where the pad deformation controls the load sharing between active-abrasive particles and direct pad-wafer contact. The predicted correlations between MRR and slurry characteristics, i.e., particle size and concentration, are in agreement with experimentally measured trends reported by Ouma¹ and Izumitani.²     

Performance Optimizations for Deploying VoIP Services in Mesh Networks

In the recent past, there has been a tremendous increase in the popularity of VoIP services as a result of huge growth in broadband access. The same voice-over-Internet protocol (VoIP) service poses new challenges when deployed over a wireless mesh network, while enabling users to make voice calls using WiFi phones. Packet losses and delay due to interference in a multiple-hop mesh network with limited capacity can significantly degrade the end-to-end VoIP call quality. In this work, we discuss the basic requirements for efficient deployment of VoIP services over a mesh network. We present and evaluate practical optimizing techniques that can enhance the network capacity, maintain the VoIP quality and handle user mobility efficiently. Extensive experiments conducted on a real testbed and ns-2 provide insights into the performance issues and demonstrate the level of improvement that can be obtained by the proposed techniques. Specifically, we find that packet aggregation along with header compression can increase the number of supported VoIP calls in a multihop network by 2-3 times. The proposed fast path switching is highly effective in maintaining the VoIP quality. Our fast handoff scheme achieves almost negligible disruption during calls to roaming clients     

Characteristics of microstrip transmission lines withhigh-dielectric-constant substrates

An efficient numerical code is developed from a full-wave analysis in the Fourier transform domain to determine the characteristics of a single-strip or multistrip coplanar transmission line. Modes of both even and odd symmetries are included. The impedance of the transmission line is calculated using the power-current equivalent model. Coupling constants between the even and the odd modes are also calculated. Results are provided for a shielded two-strip coupled microstrip transmission line on high-dielectric-constant substrate such as lanthanum aluminate with applications to superconducting transmission lines     

Evaluation of hot hardness and creep of a 350 grade commercial maraging steel

The hardening response and the indentation creep of a 350 grade commercial maraging steel were evaluated using a hot hardness tester. The hardness versus temperature plot exhibited three distinct regions. Hardness response was noted between 500–800 K. The unusually high values of activation energy and stress exponent obtained during the creep experiment could be rationalized by a novel concept of introducing a back stress term in the indentation creep relation. The corrected value of the activation energy was found to be reasonably in agreement with the activation energy for diffusion of Ni in iron. Results are supplemented with microstructural observation.     

Decentralizing India's urban development

Early in 1983 the Indian Planning Commission appointed four Task Forces on Housing and Urban Development to review existing urban policies and to recommend appropriate action starting from the Seventh Plan (1985–1989). The Task Forces covered four areas of major concern: (1) urban planning, (2) urban finance, (3) urban organizations, and (4) urban shelter. They submitted their reports by the end of 1983, and taken together these constitute the most significant review of urban policy ever undertaken in India. ¹ The Task Forces had distinguished urban experts, both officials and academics, as members, with a common Member-Secretary from the Planning Commission. The common theme in all four reports is a plea for a decentralized and equitable approach towards urban development in the country.     

III–V super-lattice SPST/SPMT pin switches for THz communication: theoretical reliability and experimental feasibility studies

Microsystem Technologies - A physics-based Quantum-Modified CLassical Drift–Diffusion (QMCLDD) non-linear mathematical model has been developed for design and characterisation of GaN/AlGaN...     

Design and characterization of asymetrical super-lattice Si/4H-SiC pin photo diode array: a potential opto-sensor for future applications in bio-medical domain

Microsystem Technologies - Photo-sensors are integral part of different bio-medical diagnostic equipment. Each type of bio-molecules possess unique spectral fingerprint in visible wavelength region...