Molecular cloning of a canine metallothionein cDNA

A canine metallothionein cDNA obtained from the liver of a cadmium-treated beagle was cloned and sequenced. Asn at position 4 conserved among all mammalian metallothionein-1 and metallothionein-2 is replaced by Asp in the canine metallothionein cDNA clone. Because the acidic amino acid doesn't exist at either position 10 or 11 in the deduced amino acid sequence, it is supposed that this cDNA is derived from canine metallothionein-1 mRNA. Northern blot analysis using the cDNA as a probe revealed the induction of the canine metallothionein mRNA expression in the liver and kidney of a cadmium-treated beagle. Thus, the canine metallothionein cDNA obtained in the present study should provide an useful tool for the molecular investigation of metallothionein in dog.     

An early phase II trial combining cisplatin and carboplatin in advanced non-small cell lung cancer

We conducted an early phase II trial in advanced non-small cell lung cancer (NSCLC) to evaluate response efficacy of a combination of Cisplatin (CDDP) and Carboplatin (CBDCA). The twenty-six patients in the study had had no previous treatment. They received a sequential administration of 300 mg/m2 CBDCA and 80 mg/m2 CDDP with approximately 3,500 ml of hydration on day 1 every 4 weeks. All patients were evaluable for response and toxicity. Ten (38.5%) of all assessable patients achieved a partial response (95% confidence interval, 19.8-57.2%). Response rates for patients with stage III A, III B and IV- disease were 40.0 (2/5), 70.0 (7/10) and 9.1% (1/11), respectively. Response rates for patients with squamous cell carcinoma, adenocarcinoma and large cell carcinoma were 35.7 (5/14), 45.5 (5/11) and 0.0% (0/1), respectively. The median survival time (MST) of all patients was 11 months. The MST for patients with stage III disease was 14 months; for those with stage IV disease it was 7 months. The MST for responding patients was 15 months and for not responding patients 5 months. Major toxicities were hematologic and gastrointestinal, and the dose-limiting factor was thrombocytopenia. This combination chemotherapy was effective against NSCLC with tolerable toxicities. Further trials are warranted to determine the efficacy of the combination chemotherapy.     

Swelling of hydrophilic polymers. III

The total volume change included gel and surrounded water with the swelling of five types of speherical cross-linked dextran (Sephadex) that are either nonionic (G) or possess one of four different ionic groups in the same molecular skeleton: CM: sodium carboxymethyl, SP: sodium sulphopropyl, DEAE: diethylaminoethyl chloride, and QAE: diethyl-(2-hydroxypropyl) aminoethyl chloride. All have been studied by dilatometry. The total volume decreased with the swelling of all Sephadexes. The maximum changes of total volume with the swelling in water were all negatives of CM, G, SP, (DEAE, QAE), which decrease in that order. These values did not depend on the concentration of sodium chloride and were closely related to the maximum heats of swelling. Total volume changes occurred by the dissociation of the ionic group of dextran derivatives that subtracted the total volume change due to hydration of Sephadex skeleton from the total volume change: ?21.6 ± 3.1 μL mmol^?1 for CM, ?2.8 ± 8.0 μL mmol^?1 for SP, +13.2 ± 4.4 μL mmol^?1 for DEAE, and +15.4 ± 4.6 μL mmol^?1 for QAE. These values are assumed to be reflected in the quantities of ions-water interaction of Sephadexes. © 1994 John Wiley & Sons, Inc.     

Macromolecular recognition by cyclodextrins. Interaction of cyclodextrins with polymethacrylamides bearing hydrophobic amino acid residues

The interaction of cyclodextrins (CDs) with poly(N-methacryloyltryptophan) (pMTrp) and with poly(N-methacryloylphenylalanine) (pMPhe) was investigated as a simple model system of macromolecular recognition of proteins. The association constants (K) for the model compounds, sodium salts of tryptophan and phenylalanine, are not so different (i.e. 43 and 16 M⁻¹ for α-CD, 59 and 69 M⁻¹ for β-CD, and 12 and 3 M⁻¹ for γ-CD, respectively). On the other hand, there is a significant difference in the apparent K values for pMTrp and pMPhe (i.e. the K values for pMPhe are considerably smaller than ca. 10 M⁻¹, whereas those for pMTrp are 30, 83, and 11 M⁻¹ for α-, β-, and γ-CDs, respectively). These observations indicate that a subtle difference in polymer side chains can be critical in macromolecular recognition.     

Secondary electron emission and surface charging evaluation of alumina ceramics and sapphire

The breakdown of alumina rf windows is mostly caused by multipactor, as well as by material defects and contamination. Since multipator induces localized surface heating, leading to surface melting, it is necessary to observe secondary electron emission (SEE) coefficients of alumina ceramics under high temperature conditions. The SEE coefficients of commercial alumina ceramics and sapphire were measured by a scanning electron microscopy (SEM) with a single short-pulsed electron beam (100 pA, 1 ms) at room temperature and at 650degC. Additive materials used for sintering alumina, such as SiO ₂ and MgO, were also investigated. Surface charging evaluations have also become important because the accumulated charges are discharged at the threshold Held, resulting in surface discharge. The surface charging evaluations were carried out by multi-pulse measurements with the injection of successive pulses on the sample. As a result, reductions in the SEE coefficients with temperature were confirmed, except for sapphire. The multi-pulse measurement results indicated that surface charging of the sapphire was higher than that of other samples. This may be one of the factors that causes sapphire not to be durable for rf window applications, compared with alumina ceramics. Although there are few exceptions, it was found that the SEE coefficients of alumina ceramics increased with the purity and the average grain size     

Improvement in thermal endurance of D-mannitol as phase-change material by impregnation into nanosized pores

This paper describes the control of the melting point and improvement of the thermal endurance of D-mannitol (melting point T_m = 440 K) as a phase-change material (PCM) by vacuum impregnation of the PCM into nanosized pores of porous SiO₂ grains. First, we examined the effects of the average pore size (D_P) of porous SiO₂ on T_m and latent heat (L) of PCM/SiO₂ composites. Second, we investigated the thermal endurance of the composites using constant temperature kinetics based on L of the PCM and composites. Third, we performed cyclic tests of melting and freezing on the composite to evaluate leakage of the PCM. Thermophysical properties of the samples were measured by differential scanning calorimetry, and the following results were obtained: (1) The impregnation ratio of the composites was 0.91–0.99; therefore, almost all pores were completely filled with the PCM. (2) T_m shifted to lower temperature with smaller D_P, reaching 413 K in case of the PCM/SiO₂ composite with a D_P of 11.6 nm (3) T_m was derived as a function of D_P from the Gibbs–Thomson equation taking into account the existence of a nonfreezing layer on the surface of the pore wall. (4) The duration of thermal degradation of the PCM/SiO₂ composite with D_P = 11.6 nm was three times longer than that of the pure PCM at a temperature that is 10 K more than each melting point. (5) The PCM/SiO₂ composite with D_P = 11.6 nm can use as a shape-stable PCM composite without leakage of PCM.     

Measurement invariance of the Gifted Rating Scales—School Form across five cultural groups.

This study examined measurement invariance of the Gifted Rating Scales—School Form (GRS–S) across the United States, Puerto Rico, China, South Korea, and Turkey, using multigroup confirmatory factor analysis. A total of 1,817 students were rated by 287 teachers using either translated versions of GRS–S or the original English GRS–S. Results indicate a similar factor structure for the GRS–S across the five locations; six factors with each of the 72 items equivalently loaded to the same latent variable across groups. The metric invariance test and the factor variance and covariance invariance tests reveal that the patterns of factor loadings and the factor variances and covariances are invariant across the five groups. Moreover, the scalar invariance test indicates that item means are equivalent across the groups. These results suggest that the GRS–S has intercultural utility and can be similarly interpreted. Implications and limitations of the present research for gifted identification are discussed. (PsycINFO Database Record (c) 2010 APA, all rights reserved)     

Strong Surface‐Termination Effect on Electroresistance in Ferroelectric Tunnel Junctions

Tunnel electroresistance in ferroelectric tunnel junctions (FTJs) has attracted considerable interest, because of a promising application to nonvolatile memories. Development of ferroelectric thin‐film devices requires atomic‐scale band‐structure engineering based on depolarization‐field effects at interfaces. By using FTJs consisting of ultrathin layers of the prototypical ferroelectric BaTiO₃, it is demonstrated that the surface termination of the ferroelectric in contact with a simple‐metal electrode critically affects properties of electroresistance. BaTiO₃ barrier‐layers with TiO₂ or BaO terminations show opposing relationships between the polarization direction and the resistance state. The resistance‐switching ratio in the junctions can be remarkably enhanced up to 10⁵% at room temperature, by artificially controlling the fraction of BaO termination. These results are explained in terms of the termination dependence of the depolarization field that is generated by a dead layer and imperfect charge screening. The findings on the mechanism of tunnel electroresistance should lead to performance improvements in the devices based on nanoscale ferroelectrics.     

Synthesis,properties, and biodegradability of three-branched copolyamide (4/6)

Previous studies on polyamide 4, excellent properties, functionalities, and biodegradation in natural condition have been shown. In this study, three-branched (star-shaped) copolyamides constituted of polyamide 4 and polyamide 6 constitutional unit were synthesized by anionic ring-opening copolymerization of 2-pyrrolidone with ε-caprolactam. The thermal and mechanical properties and the biodegradability of the obtained copolyamides have been systematically investigated. The weight-average molecular weight of the copolyamides was as high as tens of thousands (M_w 10–80 × 10³ g/mol). The composition of the copolyamides was approximately in accord with the monomer feed ratio, thereby being controllable. The thermal and mechanical properties changed readily as the composition was varied (T_m 146–266°C, ΔH_m 10–70 J/g, T_d 278–369°C, tensile strength 28–64 MPa, elongation at break 80–750%). The copolyamide having 2-pyrrolidone unit of 96–51 mol% exhibited biodegradability by an activated sludge. The biodegradation of the copolyamide proceeded uniformly without disproportion in constitutional unit.     

Current Pumping from Spin Dynamics

We show theoretically that charge and spin currents arise from spin dynamics in the presence of the spin–orbit interaction. The dominant calculation is the inverse spin Hall effect, namely the spin current pumped from precession of local spins is converted into the charge current by the spin–orbit interaction. The conversion mechanism is explained based on the conservation laws of charge and spin.