The dose distribution from a 32P source has been measured and calculated in order to evaluate its application in endovascular irradiation. The source dimension was 27 mm in length and 0.3 mm in diameter and was embedded in the end of a Ni-Ti wire. Dose measurements were performed using radiochromic film in several specially designed tissue equivalent phantoms. Loevinger's point dose kernel was used for the calculation. The approximate dose rate at a radial distance of 1.5 mm from the center of the source was found to be 6.75 cGy/s per GBq (0.25 cGy/s per mCi), which allows the delivery of a therapeutic dose in a short time interval with a satisfactory homogeneity without stepping the source. However, the dose rate falls off almost exponentially along the radial distance. Therefore it may not be suitable for treating large diameter vessel from a centrally located source. The effect of a curved 32P wire source on the radial dose distribution was also investigated. The results showed that for a maximum bend of 180 degrees the dose rate was increased by as much as 20% along the inner radial distance but decreased by as much as 20% along the outer radial distance compared to the dose along a straight wire. However, for curvatures normally encountered in a clinical situation, the dose rate was changed less than 5%. 相似文献
In this study, we investigated the validity of a stealth assessment of physics understanding in an educational game, as well as the effectiveness of different game-level delivery methods and various in-game supports on learning. Using a game called Physics Playground, we randomly assigned 263 ninth- to eleventh-grade students into four groups: adaptive, linear, free choice and no-treatment control. Each condition had access to the same in-game learning supports during gameplay. Results showed that: (a) the stealth assessment estimates of physics understanding were valid—significantly correlating with the external physics test scores; (b) there was no significant effect of game-level delivery method on students' learning; and (c) physics animations were the most effective (among eight supports tested) in predicting both learning outcome and in-game performance (e.g. number of game levels solved). We included student enjoyment, gender and ethnicity in our analyses as moderators to further investigate the research questions. 相似文献
The objective of this research was to study the influence of electroplating parameters on electrodeposit characteristics for
the production of nickel (Ni) and nickel–iron (Ni–Fe) microparts by photoelectroforming. The research focused on the most
relevant parameter for industry, which is the current density, because it determines the process time and the consumed energy.
The results of the Ni and Ni–Fe characterisations can be divided into two aspects closely linked with each other: the morphology
and the hardness. 相似文献
Over a wide range of frequencies, the a.c. conductivity of ionic materials shows two regions of frequency-dependent conductivity. These are each characterized by a term Kp1–nn where K, n are constants,
p is a fundamental frequency identified with the hopping rate and is the measuring frequency. This behaviour is an example of Jonscher's Law of Dielectric Response for ionic conductors. In many cases, the region of low-frequency dispersion approximates to a frequency-independent plateau which may be taken as the d.c. conductivity. In others, a significant low-frequency dispersion is present and cannot be ignored in determining the effective d.c. conductivity. A method for the extraction of d.c. conductivities, hopping rates and for estimating carrier concentration effects is described. Data for three different types of material, single-crystal LiGaO2, -alumina and Na/Ag -alumina are used to illustrate the method. 相似文献
Bayesian networks offer an attractive framework for describing the relationship between latent proficiency variables and observable outcomes. In educational applications, it is useful to restrict the conditional probability tables of the Bayesian network to be monotonic—increasing skill implies a high chance of a good performance. This paper describes the DiBello family of models for Bayesian networks, which enforce monotonicity, and introduces an augmented EM algorithm for estimating the parameters of these models. In a calibration experiment using simulated data, the algorithm did a good job recovering the model parameters and the conditional probability tables with sample sizes as low as 400.
With the development and operation of high speed trains, condition based maintenance becomes an important approach for the improvement of reliability and safety of rail transportation. This paper reports a feasibility study using pulsed eddy current thermography for imaging multiple cracks caused by rolling contact fatigue (RCF). After reviewing rail track inspection and RCF cracks, a PEC thermography system is introduced and applied to the imaging of multiple rolling contact fatigue cracks. Potential on-line inspection for rail track is also discussed. 相似文献
Recently, it has been discovered that carba-closo-dodecaborates can be used as cation exchangers in neutral carrier-based ion-selective chemical sensors. Because of their inherent chemical stability and versatile functionalization chemistries, they offer many advantages that may potentially be exploited for ion analyses that require nontraditional sample conditions, including strongly acidic media. In this work, trimethylammonium salts of undecachlorinated (UCC), undecabrominated (UBC), hexabrominated (HBC), and undecaiodinated (UIC) carborane anions were prepared and evaluated for their potential use in solvent polymeric membrane-based sensors. Computational methods including Natural population analysis and electrostatic mapping were used to predict the ion-exchanging ability of each lipophilic anion. In addition, the sandwich membrane technique was used to evaluate the ion-pairing ability of each carborane anion in situ (i.e., within bis(2-ethylhexyl) sebacate (DOS)- and 2-nitrophenyl octyl ether (o-NPOE)-plasticized ISE membranes). The results of the computational and potentiometric studies found that binding affinity of the anions followed the generalized trend HBC > UCC > UBC > UIC. PVC-DOS bulk optode thin films containing the chromoionophore ETH 5315 and a respective anion were used to determine the chemical stability/lipophilicity of the carboranes and tetrakis[3,5-bis(trifluoromethyl)phenyl] borate (TFPB) in acidic media (0.2 M HOAc) under flowing conditions. The studies found that in terms of stability/lipophilicity UIC > UBC > TFPB approximately UCC > HBC. Electrodes containing a Pb(2+)-selective ionophore, tert-butylcalix[4]arene-tetrakis(N,N-dimethylthioacetamide)(lead IV), were used to evaluate the functionality of each cation exchanger. An evaluation of response characteristics such as slope and selectivity found that UIC and UBC were quite comparable to the behavior of TFPB. Interestingly, both UIC and UBC showed a marked selectivity improvement over cadmium, with log K(pot)(pb),(Cd) values of -7.19 and -7.29, respectively, with TFPB giving a value of -5.89. Demonstrating excellent stability and suitable electrostatic properties, the carboranes, UIC in particular, are a very promising alternative to the tetraphenylborates and should find widespread application in the field of chemical sensors. 相似文献
Given the close association between climate change and vegetation response, there is a pressing requirement to monitor the phenology of vegetation and understand further how its metrics vary over space and time. This article explores the use of the Envisat MERIS terrestrial chlorophyll index (MTCI) data set for monitoring vegetation phenology, via its estimates of chlorophyll content. The MTCI was used to construct the phenological profile of and extract key phenological event dates from woodland and grass/heath land in Southern England as these represented a range of chlorophyll contents and different phenological cycles. The period 2003–2008 was selected as this was known to be a period with temperature and phenological anomalies. Comparisons of the MTCI-derived phenology data were made with ground indicators and climatic proxy of phenology and with other vegetation indices: MERIS global vegetation index (MGVI), MODIS normalized difference vegetation index (NDVI) and MODIS enhanced vegetation index (EVI). Close correspondence between MTCI and canopy phenology as indicated by ground observations and climatic proxy was evident. Also observed was a difference between MTCI-derived phenological profile curves and key event dates (e.g. green-up, season length) and those derived from MERIS MGVI, MODIS NDVI and MODIS EVI. The research presented in this article supports the use of the Envisat MTCI for monitoring vegetation phenology, principally due to its sensitivity to canopy chlorophyll content, a vegetation property that is a useful proxy for the canopy physical and chemical alterations associated with phenological change. 相似文献