Improvements in the silver-staining technique for nucleolar organizer regions (AgNOR)

The silver-staining technique for nucleolar organizer regions (AgNOR) of Ploton et al., as popularized by Crocker, is being widely used for evaluation of nucleolar function, especially in neoplasia. It suffers from limited reliability, background staining, precipitates, and fading of the sections. Factors were identified that affect these problems. The oxidation-reduction level and gelatin used are particularly important. An improved procedure is presented which incorporates pre-reduction of the sections, selection of an optimal gelatin, and post-treatment of the sections to produce a permanent preparation. It is compatible with many fixatives and with other stains used before or after the silver stain.     

Intercomparison of scanning probe microscopes

Comparison measurements on reference standards are reported in which 13 partners with different instruments took part. A set of prototype standards which had been produced and calibrated within a European project were used for the measurements. Here, results of measurements on a 240 nm step height standard and a two-dimensional lateral standard with a nominal pitch of 1 μm are reported.     

Dehydrogenation of Light Alkanes Over Rhenium Catalysts on Conventional and Mesoporous MFI Supports

Recently, Re/HZSM-5 (Si/Al = 15) was shown to be an efficient catalyst for ethane dehydrogenation and aromatization at 823 K and atmospheric pressure. In this reaction, the major initial products were benzene, toluene and xylene (BTX), but increasing amounts of ethene were produced with time on stream due to deactivation of the catalyst. We show that by use of rhenium impregnated MFI supports with very few or no acidic sites (Si/Al > 500), highly selective ethane dehydrogenation catalysts are obtained with ethene selectivities of 98%. By use of mesoporous MFI supports (Si/Al >500) the lifetime of the catalyst appears to be slightly improved compared to conventional MFI crystals. The beneficial effect of a mesoporous MFI support is convincingly demonstrated in propane dehydrogenation, where both conversion and selectivities on the mesoporous MFI (Si/Al > 500) impregnated with Re are significantly higher than on Re supported on a comparable conventional MFI support.     

A New $H_{{bm infty}}$ Stabilization Criterion for Networked Control Systems

This note is concerned with robust H_infin control of linear networked control systems with time-varying network-induced delay and data packet dropout. A new Lyapunov-Krasovskii functional, which makes use of the information of both the lower and upper bounds of the time-varying network-induced delay, is proposed to drive a new delay-dependent H_infin stabilization criterion. The criterion is formulated in the form of a non-convex matrix inequality, of which a feasible solution can be obtained by solving a minimization problem in terms of linear matrix inequalities. In order to obtain much less conservative results, a tighter bounding for some term is estimated. Moreover, no slack variable is introduced. Finally, two numerical examples are given to show the effectiveness of the proposed design method.     

Insights into the assessment of myocardial perfusion offered by different cardiac imaging modalities

Myocardial perfusion may be very broadly defined as the tightly regulated nutrient delivery to cardiac tissue. The different components of perfusion are myocardial blood flow, oxygen delivery, myocardial oxygen consumption, and myocardial blood volume. Historically, focus has been placed mostly on the assessment of blood flow. In many instances, knowledge of flow without information about these other aspects is inadequate. This review discusses the various cardiac imaging techniques used for the assessment of myocardial perfusion that represent diverse physiologic measures of "perfusion." Their strengths and limitations are discussed as is their relevance to specific clinicopathologic conditions. Significant work still needs to be performed before all the aspects of myocardial perfusion can be precisely measured in human beings.     

Ultra-dense planar metallic nanowire arrays with extremely large anisotropic optical and magnetic properties

A nanofabrication method for the production of ultra-dense planar metallic nanowire arrays scalable to wafer-size is presented. The method is based on an efficient template deposition process to grow diverse metallic nanowire arrays with extreme regularity in only two steps. First, III–V semiconductor substrates are irradiated by a low-energy ion beam at an elevated temperature, forming a highly ordered nanogroove pattern by a “reverse epitaxy” process due to self-assembly of surface vacancies. Second, diverse metallic nanowire arrays (Au, Fe, Ni, Co, FeAl alloy) are fabricated on these III–V templates by deposition at a glancing incidence angle. This method allows for the fabrication of metallic nanowire arrays with periodicities down to 45 nm scaled up to wafer-size fabrication. As typical noble and magnetic metals, the Au and Fe nanowire arrays produced here exhibited large anisotropic optical and magnetic properties, respectively. The excitation of localized surface plasmon resonances (LSPRs) of the Au nanowire arrays resulted in a high electric field enhancement, which was used to detect phthalocyanine (CoPc) in surface-enhanced Raman scattering (SERS). Furthermore, the Fe nanowire arrays showed a very high in-plane magnetic anisotropy of approximately 412 mT, which may be the largest in-plane magnetic anisotropy field yet reported that is solely induced via shape anisotropy within the plane of a thin film.

Open image in new window

     

Robust exponential stability conditions for retarded systems with Lipschitz nonlinear stochastic perturbations

This paper investigates robust mean‐square exponential stability of a class of uncertain stochastic state‐delayed systems with Lipschitz nonlinear stochastic perturbation. Based on Lyapunov–Krasovskii functional (LKF) method and free‐weighting matrix technique, some new delay‐dependent stability conditions are established in terms of linear matrix inequalities (LMIs). In order to reduce the conservatism, (1) the delay is divided into several segments, i.e. the delay decomposition method is applied; (2) cross terms estimation is avoided; (3) some information of the cross terms relationships which has not been involved in Reference (IET Control Theory Appl. 2008; 2(11):966–973) is considered. Moreover, from the mathematical point of view, the results obtained by free‐weighting matrix technique can be equivalently re‐formulated by simpler ones without involving any additional free matrix variables. The effectiveness of the method is demonstrated by numerical examples. Copyright © 2010 John Wiley & Sons, Ltd.     

Effects of auditory,haptic and visual feedback on performing gestures by gaze or by hand

Modern interaction techniques like non-intrusive gestures provide means for interacting with distant displays and smart objects without touching them. We were interested in the effects of feedback modality (auditory, haptic or visual) and its combined effect with input modality on user performance and experience in such interactions. Therefore, we conducted two exploratory experiments where numbers were entered, either by gaze or hand, using gestures composed of four stroke elements (up, down, left and right). In Experiment 1, a simple feedback was given on each stroke during the motor action of gesturing: an audible click, a haptic tap or a visual flash. In Experiment 2, a semantic feedback was given on the final gesture: the executed number was spoken, coded by haptic taps or shown as text. With simultaneous simple feedback in Experiment 1, performance with hand input was slower but more accurate than with gaze input. With semantic feedback in Experiment 2, however, hand input was only slower. Effects of feedback modality were of minor importance; nevertheless, semantic haptic feedback in Experiment 2 showed to be useless at least without extensive training. Error patterns differed between both input modes, but again not dependent on feedback modality. Taken together, the results show that in designing gestural systems, choosing a feedback modality can be given a low priority; it can be chosen according to the task, context and user preferences.     

Linear programming based approximation algorithms for feedback set problems in bipartite tournaments

We consider the feedback vertex set and feedback arc set problems on bipartite tournaments. We improve on recent results by giving a 2-approximation algorithm for the feedback vertex set problem. We show that this result is the best that we can attain when using optimal solutions to a certain linear program as a lower bound on the optimal value. For the feedback arc set problem on bipartite tournaments, we show that a recent 4-approximation algorithm proposed by Gupta (2008) [8] is incorrect. We give an alternative 4-approximation algorithm based on an algorithm for the feedback arc set on (non-bipartite) tournaments given by van Zuylen and Williamson (2009) [14].