Feasibility of fishmeal replacement by shrimp head silage protein hydrolysate in Nile tilapia (Oreochromis niloticus L) diets

This study provides information on the use of shrimp head silage protein hydrolysate (SPH) as an alternative protein source for tilapia feeding. Six diets (28% protein, 12% lipid) were prepared where fishmeal protein was replaced at levels of 0 (control), 10, 15, 20, 25 and 30% with the hydrolysate. The diets were supplied to Nile tilapia fry (338 mg initial weight) stocked in plastic recirculating 20 l tanks (10 animals per tank), with three replicates per treatment. After an 8 week experimental period, fish fed the diets containing 10 and 15% SPH showed significantly better performance in terms of final body weight, weight gain (%), mean daily weight gain (mg day^?1), specific growth ratio and feed conversion ratio than those fed the control diet (fishmeal as protein source) and higher‐SPH diets. It is concluded that shrimp head hydrolysate is a promising alternative protein source for tilapia feeding, improving growth ratio at dietary inclusion levels as high as 15%. In addition, the diets with added shrimp silage protein were well accepted by the fish, which avidly consumed the feed during the experiment. © 2002 Society of Chemical Industry     

Numerical analysis of two-dimensional steady-state and transient heat transfer in a parallel duct filled with pressurized He II

Analysis on steady-state and transient heat transfer on a flat plate at the middle of a parallel duct immersed in He II was performed for bath temperatures from 1.8 to 2.1 K at 101.3 kPa. Two-dimensional computer code named SUPER-2D developed by the authors based on the two-fluid model and the theory of mutual friction was used. Steady-state critical heat flux (CHF) and the time lag from the application of a step heat input to λ transition, that is called a lifetime, were obtained numerically for various step heat fluxes and for the channel gaps from 2 to 20 mm. Effect of the gap restriction on the CHF and the lifetime were clarified. The solutions were compared with the experimental data for the ducts with the same structures and the corresponding conditions. They agreed well with the experimental data. The heat transport mechanism in the parallel duct was clarified.     

On the Limitation of Net Algorithm for Enumerating Isomeric Structures of Giant Fullerenes

Application of our net algorithm to the generation of all possible IPR isomers for giant fullerenes C_n, n=102 to 120, missed nine out of 39,621 possible structures. Analysis revealed that the omission of too small and too large cap triangles was the reason. Within the range of fullerenes studied, the missed structures are of high-energy and do not affect the distribution of significantly low-energy isomers.     

Immunohistochemical demonstration of 3,2''-dimethyl-4-aminobiphenyl DNA adduct formation in various organs of Syrian golden hamsters

We attempted to purify endogenous growth factors of chick embryonal retinal pigment epithelial cells from bovine neural retina. Ammonium sulfate precipitation, gel filtration, and anion exchange column chromatography were used. Though only partially purification, bovine retinal extract had two effects, growth and transformation, on chick embryonal pigment epithelial cells. We think that these purified factors may be novel from the estimation of their molecular weight by gel filtration.     

Doubly Bonded C60 Dimers and Congeners: Computational Studies of Structures, Bond Energies and Transformations

Initial steps of thermal transformation from doubly bonded [2+2] (1) and [4+4] (2) dimers of C₆₀ have been analyzed on the basis of computed structural features and Pople's energy partition scheme. Completely conjugated C₁₂₀ structures 3 and 4 are found to be considerably stable and proposed to be important intermediates. The linkage patterns in 3 and 4 are also likely to appear in the repeating units of the metastable dimer and polymer phases of A₁ crystals.     

Hot-carrier effects in scaled MOS devices

A universal guideline and state-of-the-art hot-carrier effects in scaled MOSFETs are reviewed and discussed from the viewpoints of 1) DC and AC hot-carrier effects, 2) hot-carrier detrapping phenomena, 3) mechanical stress effects on hot-carrier phenomena, and 4) hot-carrier resistant device structures.In the deep-submicron region, the hot-carrier applicable voltage is less than 3 V, so AC hot-carrier effects from the dynamic operation of actual circuits should be taken into account. Despite much experimentation and analysis, there is still no universally accepted theory that explain the AC degradation mechanism. This is because the noise caused by the wiring inductance in ULSI circuits and in measurement systems screens the intrinsic AC hot-carrier effects.Here, AC hot-carrier degradation enhanced by gate pulse-induced-noise is analyzed experimentally and theoretically. After eliminating the noise problem, it is found that AC hot-carrier degradation in LDD (Lightly doped drain) and GOLD (gate-drain overlapped device) structures can be estimated based on DC degradation in terms of the effective stress time which takes the duty ratio into account. In addition, it is found that the noise is negligible when the wiring inductance is smaller that 80 nH (250 mω), which is important for future circuit design.Furthermore, hot-carrier detrapping effects, especially in p-channel MOS devices, and hot-carrier phenomena under mechanical stress are investigated experimentally to better understand the underlying hot-carrier physics. Finally, future hot-carrier resistant device structures are discussed.     

A light-transmitting two-dimensional photodetector array using a-Sipin photodiodes and poly-Si TFT's integrated on a transparent substrate

A light-transmitting two-dimensional photodetector array (32×32 cells) using amorphous silicon (a-Si) pin photodiodes and polysilicon (poly-Si) thin film transistors (TFT's) integrated on a transparent substrate has been developed for use in a free-space optical switching network. The fabrication and the characteristics of the photodetector array are discussed. With driving circuits and sensing amplifiers, this photodetector array shows a minimum detectable power of -25 dBm and an insertion loss of 0.4 dB for an incident optical beam with a diameter of 550 μm. By monitoring the positions and the states of input optical beams, this photodetector array can be used to control the optical paths in photonic switching systems, such as a 1024-input-port optical concentrator     

Numerical analysis of wave-type heat transfer propagating in a thin foil irradiated by short-pulsed laser

This paper presents a numerical simulation of wave-type heat transfer phenomena propagating in an aluminum thin foil irradiated by a pulsed laser using the cubic interpolated propagation method coupled with a thermo-convective model. We did not use the two-step model and dual-phase lag model, which are generally known as the non-Fourier heat conduction law, but wave-type heat transfer phenomena could be observed by our method. The main characteristic of the method is to solve the governing equation including the equation of continuity, the equation of motion, the equation of energy and the equation of state. It is found that when the pulse duration is under the order of picosecond, the pure heat conduction is hardly observed and heat transfer toward the inside of materials occurs only by a thermal shock wave. The heat conduction mode after pulse laser irradiation is strongly dependent upon the value of total incident laser energy density E_in and the threshold value for pure heat conduction is 5.0 × 10⁴ J/m² for an aluminum.     

Multiple pathways are involved in the extracellular processing of MHC class I-restricted peptides

T cell stimulation by certain class I-restricted antigenic peptides, such as the HIV 1 gp160-derived peptide, P18, requires peptide processing by angiotensin-1 converting enzyme (ACE) in FCS. We observed that longer versions of P18 and the murine cytomegalovirus pp89-derived core peptide, pMCMV, which could stimulate T cell hybridomas in FCS, were not as sensitive to the ACE inhibitor captopril as P18. Using cell-free soluble murine class I MHC molecules and protease inhibitors, we found that there are pathways of differing efficiency that use enzymes other than ACE for the proteolytic processing of peptides in serum. The kinetics of the generation of T cell stimulatory activity among P18 variant peptides in serum differed with peptide length, and with the nature of amino and COOH-terminal extensions. Such processing occurs in human plasma as well as in FCS. The understanding of this processing, its kinetics, and its inhibitors can lead to better design of peptide-based therapies, including vaccines.