Large purely refractive nonlinear index of single crystal P-toluenesulphonate (PTS) at 1600 nm

Z-scan measurements at 1600 nm on single-crystal PTS (p-toluene sulfonate) with single, 65 ps pulses gave a complex nonlinear refractive index coefficient of n₂=2.2(±0.3)×10^-12 cm²/W at 1 GW/cm² and α₂<0.5 cm/GW. This is the first highly nonlinear, organic material to satisfy the conditions imposed by the figures of merit     

Catalytic combustion over platinum group catalysts: fuel-lean versus fuel-rich operation

Performance data are presented for methane oxidation on alumina-supported Pd, Pt, and Rh catalysts under both fuel-rich and fuel-lean conditions. Catalyst activity was measured in a micro-scale isothermal reactor at temperatures between 300 and 800 °C. Non-isothermal (near adiabatic) temperature and reaction data were obtained in a full-length (non-differential) sub-scale reactor operating at high pressure (0.9 MPa) and constant inlet temperature, simulating actual reactor operation in catalytic combustion applications.

Under fuel-lean conditions, Pd catalyst was the most active, although deactivation occurred above 650 °C, with reactivation upon cooling. Rh catalyst also deactivated above 750 °C, but did not reactivate. Pt catalyst was active above 600 °C. Fuel-lean reaction products were CO₂ and H₂O for all three catalysts.

The same catalysts tested under fuel-rich conditions demonstrated much higher activity. In addition, a ‘lightoff’ temperature was found (between 450 and 600 °C), where a stepwise increase in reaction rate was observed. Following ‘lightoff’ partial oxidation products (CO, H₂) appeared in the mixture, and their concentration increased with increasing temperature. All three catalysts exhibited this behavior.

High-pressure (0.9 MPa) sub-scale reactor and combustor data are shown, demonstrating the benefits of fuel-rich operation over the catalyst for ultra-low emissions combustion.     

Tunable dispersion compensation by an angular conserved grating-pair system

To our knowledge the concept of an angular conserved grating-pair dispersion compensation system is proposed for the first time, and furthermore a model of such a system is developed and applied to the study of two- and three-lens special cases. A set of easy-to-use dispersion compensation formulas based on geometric optics has been derived and confirmed by our experimental results. Tunability and a compensation ratio as high as 27,600 have been achieved with two- and three-lens systems, respectively.     

Capture‐Tag‐Release: A Strategy for Small Molecule Labeling of Native Enzymes

A strategy for labeling native enzymes in a manner that preserves their activity is reported: capture–tag–release (CTR). Key to this approach is the small molecule CTR probe that contains an enzyme inhibitor, benzophenone crosslinker, and aryl phosphine ester. After UV‐derived capture of the enzyme, addition of an azide‐containing tag triggers a Staudinger ligation that labels the enzyme. A further consequence of the Staudinger ligation is fragmentation of the CTR probe, thus releasing the inhibitor and restoring enzymatic activity. As a proof‐of‐principle, the CTR strategy was applied to the hydrolase β‐galactosidase. The enzyme was efficiently labeled with biotin, and the kinetic data for the biotinylated enzyme were comparable to those for unlabeled β‐galactosidase. The CTR probe exhibits excellent targeting specificity, as it selectively labeled β‐galactosidase in a complex protein mixture.     

Analysis of MTHFR and MTRR Gene Polymorphisms in Iranian Ventricular Septal Defect Subjects

Ventricular septal defect (VSD) is one of the most common types of congenital heart defects (CHD). There are vivid multifactorial causes for VSD in which both genetic and environmental risk factors are consequential in the development of CHD. Methionine synthase reductase (MTRR) and methylenetetrahydrofolate reductase (MTHFR) are two of the key regulatory enzymes involved in the metabolic pathway of homocysteine. Genes involved in homocysteine/folate metabolism may play an important role in CHDs. In this study; we determined the association of A66G and C524T polymorphisms of the MTRR gene and C677T polymorphism of the MTHFR gene in Iranian VSD subjects. A total of 123 children with VSDs and 125 healthy children were included in this study. Genomic DNA was extracted from the buccal cells of all the subjects. The restriction fragment length polymorphism polymerase chain reaction (PCR-RFLP) method was carried out to amplify the A66G and C524T polymorphism of MTRR and C677T polymorphism of MTHFR genes digested with Hinf1, Xho1 and Nde1 enzymes, respectively. The genotype frequencies of CC, CT and TT of MTRR gene among the studied cases were 43.1%, 40.7% and 16.3%, respectively, compared to 52.8%, 43.2% and 4.0%, respectively among the controls. For the MTRR A66G gene polymorphism, the genotypes frequencies of AA, AG and GG among the cases were 33.3%, 43.9% and 22.8%, respectively, while the frequencies were 49.6%, 42.4% and 8.0%, respectively, among control subjects. The frequencies for CC and CT genotypes of the MTHFR gene were 51.2% and 48.8%, respectively, in VSD patients compared to 56.8% and 43.2% respectively, in control subjects. Apart from MTHFR C677T polymorphism, significant differences were noticed (p < 0.05) in C524T and A66G polymorphisms of the MTRR gene between cases and control subjects.     

Control of semiconductor manufacturing equipment: real-timefeedback control of a reactive ion etcher

This paper describes the development of real-time control technology for the improvement of manufacturing characteristics of reactive ion etchers. A general control strategy is presented. The principal ideas are to sense key plasma parameters, develop a dynamic input-output model for the subsystem connecting the equipment inputs to the key plasma variables, and design and implement a multivariable control system to control these variables. Experimental results show that this approach to closed-loop control leads to a much more stable etch rate in the presence of a variety of disturbances as compared to current industrial practice