全文获取类型
收费全文 | 331篇 |
免费 | 3篇 |
专业分类
电工技术 | 10篇 |
化学工业 | 57篇 |
金属工艺 | 6篇 |
机械仪表 | 1篇 |
建筑科学 | 5篇 |
能源动力 | 15篇 |
轻工业 | 8篇 |
水利工程 | 2篇 |
无线电 | 109篇 |
一般工业技术 | 49篇 |
冶金工业 | 32篇 |
自动化技术 | 40篇 |
出版年
2022年 | 3篇 |
2021年 | 3篇 |
2020年 | 3篇 |
2019年 | 2篇 |
2018年 | 4篇 |
2017年 | 2篇 |
2016年 | 5篇 |
2015年 | 5篇 |
2014年 | 9篇 |
2013年 | 23篇 |
2012年 | 12篇 |
2011年 | 13篇 |
2010年 | 16篇 |
2009年 | 13篇 |
2008年 | 21篇 |
2007年 | 11篇 |
2006年 | 11篇 |
2005年 | 8篇 |
2004年 | 8篇 |
2003年 | 10篇 |
2002年 | 10篇 |
2001年 | 12篇 |
2000年 | 11篇 |
1999年 | 16篇 |
1998年 | 20篇 |
1997年 | 13篇 |
1996年 | 11篇 |
1995年 | 16篇 |
1994年 | 2篇 |
1993年 | 7篇 |
1992年 | 3篇 |
1991年 | 4篇 |
1990年 | 7篇 |
1989年 | 2篇 |
1988年 | 3篇 |
1986年 | 5篇 |
1985年 | 2篇 |
1983年 | 2篇 |
1982年 | 1篇 |
1981年 | 2篇 |
1980年 | 1篇 |
1976年 | 1篇 |
1975年 | 1篇 |
排序方式: 共有334条查询结果,搜索用时 7 毫秒
1.
2.
3.
Efficiency improvement of near-ultraviolet InGaN LEDs using patterned sapphire substrates 总被引:1,自引:0,他引:1
Woei-Kai Wang Dong-Sing Wuu Lin S.-H. Han P. Horng R.-H. Ta-Cheng Hsu Huo D.T.-C. Ming-Jiunn Jou Yuan-Hsin Yu Lin A. 《Quantum Electronics, IEEE Journal of》2005,41(11):1403-1409
The use of conventional and patterned sapphire substrates (PSSs) to fabricate InGaN-based near-ultraviolet (410 nm) light-emitting diodes (LEDs) was demonstrated. The PSS was prepared using a periodic hole pattern (diameter: 3 /spl mu/m; spacing: 3 /spl mu/m) on the (0001) sapphire with different etching depths. From transmission-electron-microscopy and etch-pit-density studies, the PSS with an optimum pattern depth (D/sub h/=1.5 /spl mu/m) was confirmed to be an efficient way to reduce the thread dislocations in the GaN microstructure. It was found that the output power increased from 8.6 to 10.4 mW, corresponding to about 29% increases in the external quantum efficiency. However, the internal quantum efficiency (@ 20 mA) was about 36% and 38% for the conventional and PSS LEDs, respectively. The achieved improvement of the output power is not only due to the improvement of the internal quantum efficiency upon decreasing the dislocation density, but also due to the enhancement of the extraction efficiency using the PSS. Finally, better long-time reliability of the PSS LED performance was observed. 相似文献
4.
5.
A general formula correlating the bending curvature variation ratio of a layered structure caused by solvent-induced swelling in its polymer overcoat with diffusion time under case II diffusion has been presented. In the event of case II diffusion, the diffusion front velocity, v, can be calculated by using this formula and measured by a bending-beam apparatus. At room temperature, the diffusion of n-methyl-pyrrolidone (NMP) solvent in the film of pyromellitic phenylene diamine (PMDA-PDA) is case II. While in PMDA-B (-benzidine) and benzophenone tetracarboxylic dianhydride (BPDA-PDA), no diffusion progress can be observed. But, the diffusion in 6F-dianhydride- (6FDA-PDA) is case I with D = 0.85 × 10?9 cm2/s. It becomes anomalous when mixing with 25% PMDA-B, but becomes case II diffusion with more PMDA-B. The preabsorbed moisture in the films does not affect the v value. In PMDA-PDA, v = 7.3 × 10?8 cm/s. In the 25/75 and 50/50 6FDA-PDA/PMDA-B blends, v = 6.3 and 11.3 × 10?8 cm/s. 相似文献
6.
Lennart P.J. Teunissen Li-Chu Wang Shih-Nung Chou Chin-hsien Huang Gwo-Tsuen Jou Hein A.M. Daanen 《Applied ergonomics》2014
Firemen often suffer from heat strain. This study investigated two chest cooling systems for use under a firefighting suit. In nine male subjects, a vest with water soaked cooling pads and a vest with water perfused tubes were compared to a control condition. Subjects performed 30 min walking and 10 min recovery in hot conditions, while physiological and perceptual parameters were measured. No differences were observed in heart rate and rectal temperature, but scapular skin temperature and fluid loss were lower using the perfused vest. Thermal sensation was cooler for the perfused vest than for the other conditions, while the cool pad vest felt initially cooler than control. However, comfort and RPE scores were similar. We conclude that the cooling effect of both tested systems, mainly providing a (temporally) cooler thermal sensation, was limited and did not meet the expectations. 相似文献
7.
The solubility of propane in sulpholane has been determined at temperatures in the range 298‐403 K at pressures up to 17.6 MPa. The experimental results were correlated by the Peng‐Robinson equation of state, and binary interaction parameters have been obtained for this system. The parameters in the Krichevsky‐Ilinskaya equation were calculated from these interaction parameters. 相似文献
8.
Ping-Hui Hsu Hui-Ming Teng Yung-Tsan Jou Hui Ming Wee 《Computers & Industrial Engineering》2008,54(3):602-612
The supplier–buyer coordination is an important policy in the supply chain management. The buyer in the two-echelon inventory system with regular selling season has to face the uncertainty of customer demand, supplier’s delivery time and variable price change. At the same time, the supplier has to consider the inventory holding and delay cost. The objective of this study is to develop an integrated supply chain strategy for products with short lifecycle and variable selling price to entice cooperation. The strategy must provide a win–win situation for both the supplier and the buyer. A numerical case example, sensitivity analysis and compensation mechanism are given to illustrate the model. 相似文献
9.
Pei-Yin Chen Jer Min Jou 《IEEE transactions on systems, man, and cybernetics. Part B, Cybernetics》2001,31(2):253-259
Due to the temporal and spatial correlation of image sequence, the motion vector of a reference block is highly related to the motion vectors of its adjacent blocks in the same image frame. By using that idea, we propose a novel efficient fuzzy search (EFS) algorithm for block motion estimation. The experimental results show that the EFS performs better than other fast search algorithms, such as TSS, CS, NTSS, FSS, BBGDS, SES, and PSA in terms of picture quality, accuracy, computational complexity, and coding efficiency. 相似文献
10.
Chorng-Shyan Lin Tachung Yang Yeong-Chau Jou Lih-Chang Lin 《Journal of Intelligent and Robotic Systems》2003,38(2):213-235
This paper considers the nonlinear system identification and control for flexible servomechanisms. A multi-step-ahead recurrent neuro-fuzzy model consisting of local linear ARMA (autoregressive moving average) models with bias terms is suggested for approximating the dynamic behavior of a servomechanism including the effects of flexibility and friction. The RLS (recursive least squares) algorithm is adopted for obtaining the optimal consequent parameters of the rules. Within each fuzzy operating region, a local MDPP (minimum degree pole placement) control law with integral action can be constructed based on the estimated local model. Then a fuzzy controller composed of these local MDPP controls can be easily constructed for the servomechanism. The techniques are illustrated using computer simulations. 相似文献