Prediction of Flooding in Packed Liquid-Liquid and High-Pressure Extraction Columns Using a Gaussian Process

Reliable prediction of flooding conditions is needed for sizing and operating packed extraction columns. Due to the complex interplay of physicochemical properties, operational parameters and the packing-specific properties, it is challenging to develop accurate semi-empirical or rigorous models with a high validity range. State of the art models may therefore fail to predict flooding accurately. To overcome this problem, a data-driven model based on Gaussian processes is developed to predict flooding for packed liquid-liquid and high-pressure extraction columns. The optimized Gaussian process for the liquid-liquid extraction column results in an average absolute relative error (AARE) of 15.23 %, whereas the algorithm for the high-pressure extraction column results in an AARE of 13.68 %. Both algorithms can predict flooding curves for different packing geometries and chemical systems precisely.     

Investigation of the action of flame retardants in cellulose. I. Investigation of the flame retardant action of 2,2′-oxybis(5,5-dimethyl-1,3,2-dioxaphosphorinane-2,2′-disulfide) in cellulose

Pyrolysis experiments were performed in high vacuum and under reduced air pressure (100 Pa). The volatile products of pure cellulose and cellulose containing various amounts of flame retardant 2,2′-oxybis (5,5-dimethyl-1,3,2-dioxaphosphorinane-2,2′-disulfide), i.e., Sandoflam 5060 of Sandoz AG, were studied by means of gas chromatography in combination with mass spectroscopy. The volatile products were characterized with infrared spectroscopy. The studied revealed that the incorporation of the flame retardant enhanced the water release and shifted the onset of this reaction to lower temperature. On the basis of these findings an explanation for the mechanism of flame retardancy in generated cellulose fibers modified with this particular flame retardant is attempted. From experiments with different residual air pressure the influence of oxygen on the primary processes of the pyrolytic degradation of cellulose is being discussed.     

4-bit adder-accumulator at 41-GHz clock frequency in InP DHBT technology

A 41-GHz 4-b adder-accumulator test circuit implemented in InP double heterojunction bipolar transistor (DHBT) technology using 624 transistors is reported. High clock rates are obtained by combining the logic functions into pipelined latches. The adder-accumulator contains a single-level parallel-gated carry circuit that is used as a step toward reduced power consumption. The carry circuit has a maximum clock frequency of 55 GHz. The accumulator architecture employs modular, pipelined 2-b adders and is cascadable to 2 N-bits. The test circuit includes a 4-b digital to analog converter (DAC) that facilitates demonstration of high-speed operation.     

Influence of Reaction Parameters on the Hydrogenolysis of Hydroxymatairesinol Over Carbon Nanofibre Supported Palladium Catalysts

The density functional theory (DFT/B3LYP) calculations were applied to investigate the interaction of a Pt₆ particle with the ZSM-5 zeolite framework. The electronic structure of the metal particle is strongly affected by the interaction with basic framework oxygens and acid sites of the zeolite support. Adsorption on basic sites (E_ads = 6 kcal/mol) favors the formation of the electron enriched metal cluster. Interaction of the platinum cluster with the acid site characterized by stabilization energy of 47 kcal/mol results in oxidation of the metal particle and suppression of Brønsted acidity of the support. The hypothesis is put forward that the oxidized platinum particle can function as an active site for the alkane isomerisation on platinum supported high silica zeolites.     

Disc filtration for separation of flocs from a moving bed bio-film reactor.

A Discfilter with 10 and 18 microm filter openings, respectively, was placed in parallel to a flotation plant for separation of biological flocs from a post-denitrifying Kaldnes Moving Bed Process, the last treatment step at the municipal wastewater treatment plant at Sj?unda, Malm?, Sweden. The effluent concentrations from the 10 and 18 microm filter were 2-5 and 2-8 mg SS L(-1), respectively, which is comparable to, or better than, the flotation plant. Comparison with experiences from activated sludge plants shows that the Discfilter works especially well after the Kaldnes process. Particle size distribution (PSD) studies show that particles larger than the filter openings of 10 and 18 microm are separated with approximately 90% efficiency, whereas most of the smaller particles pass the filter. This fact indicates that the major particle separation mechanism is physical blocking. These findings point to the possibility of improving the prediction of the separation efficiency by combining measurements of turbidity and suspended solids with particle size analysis.     

Pruning Algorithms for Rule Learning

Pre-pruning and Post-pruning are two standard techniques for handling noise in decision tree learning. Pre-pruning deals with noise during learning, while post-pruning addresses this problem after an overfitting theory has been learned. We first review several adaptations of pre- and post-pruning techniques for separate-and-conquer rule learning algorithms and discuss some fundamental problems. The primary goal of this paper is to show how to solve these problems with two new algorithms that combine and integrate pre- and post-pruning.     

The value of long tendons in design of tunnel layout and support

A project was initiated from hypotheses that the use of longer and different types of tendon support could lead to improved control of tunnel deformation in changing stress fields. An extensive literature study was conducted. Subsequently a tunnel was supported with various lengths and types of cable tendons. The tunnel was subjected to mining-induced stress changes. Tunnel deformations were measured using instrumentation. Results from the literature study and tunnel deformation measurements indicated within context that: (1) long tendons or other support systems cannot substitute for good tunnel layout; (2) long tendons effect a retain-and-hold function while shorter tendons strengthen and reinforce highly fractured tunnel walls; (3) larger boreholes or weakergrout reduce support system stiffness; (4) cable tendons have high shear resistance and debonding tendency; (5) long tendons are beneficial in sidewalls but not the hangingwall, (6) long tendons induce a more stable sidewall deformation distribution; (7) the updip sidewall deformed less than downdip; (8) more deformation occurred with stress decrease than with stress increase.     

Autocoro最新技术: e-save

能源成本上涨速度高于纱线价格上涨速度,Autocoro纺纱厂每年的能耗成本约占每年营业额的5％,主要能耗是电能.     

Isolation and Spectroscopic Characterization of Eu@C72

A new Eu-endohedral fullerene cage, namely, Eu@C₇₂, was synthesized, separated, and a single isomer, Eu@C₇₂-I, has been isolated by multi-step HPLC for the first time and characterized by LDI-TOF mass spectrometry, UV-Vis and EPR spectroscopy. Additionally, a second isomer, Eu@C₇₂-II, has been separated by HPLC and identified by LDI-TOF mass spectrometry.