Solutions to a combined problem of excessive hydrogen sulfide in biogas and struvite scaling.

The Woodman Point Wastewater Treatment Plant (WWTP) in Western Australia has experienced two separate problems causing avoidable maintenance costs: the build-up of massive struvite (MgNH4PO4. 6H2O) scaling downstream of the anaerobic digester and the formation of hydrogen sulfide (H2S) levels in the digester gas to levels that compromised gas engine operation and caused high operating costs on the gas scrubber. As both problems hang together with a chemical imbalance in the anaerobic digester, we decided to investigate whether both problems could be (feasibly and economically) addressed by a common solution (such as dosing of iron solutions to precipitate both sulfide and phosphate), or by using separate approaches. Laboratory results showed that, the hydrogen sulfide emission in digesters could be effectively and economically controlled by the addition of iron dosing. Slightly higher than the theoretical value of 1.5 mol of FeCl3 was required to precipitate 1 mol of dissolved sulfide inside the digester. Due to the high concentration of PO4(3-) in the digested sludge liquor, significantly higher iron is required for struvite precipitation. Iron dosing did not appear an economic solution for struvite control via iron phosphate formation. By taking advantage of the natural tendency of struvite formation in the digester liquid, it is possible to reduce the risk of struvite precipitation in and around the sludge-dewatering centrifuge by increasing the pH to precipitate struvite out before passing through the centrifuge. However, as the Mg2+/PO4(3-) molar ratio in digested sludge was low, by increasing the pH alone (using NaOH) the precipitation of PO4(3-) was limited by the amount of cations (Ca2+ and Mg2+) available in the sludge. Although this would reduce struvite precipitation in the centrifuge, it could not significantly reduce PO4(3-) recycling back to the plant. For long-term operation, maximum PO4(3-) reduction should be the ultimate aim to minimise PO4(3-) accumulation in the plant. Magnesium hydroxide liquid (MHL) was found to be the most cost-effective chemical to achieve this goal. It enhanced struvite precipitation from both, digested sludge and centrate to the point where more than 95% PO4(3-) reduction in the digested sludge was achieved.     

Online and Offline Rotary Regression Analysis of Torque Estimator for Switched Reluctance Motor Drives

A new torque estimator for switched reluctance motor (SRM) drives based on 2-D rotary regression analysis is presented in this paper. The proposed torque estimator is composed of a bicubic regressive polynomial as a function of rotor position and input current. The regressive coefficients can be computed offline or online from the torque characteristics acquired either experimentally or from numerical computation. Furthermore, a torque estimation method by taking mutual coupling into consideration is proposed. It can be seen that the estimated and experimentally obtained self-coupling and mutual-coupling torque characteristics are in good agreement with each other. In addition, the dynamic torque waveforms with and without the mutual coupling, estimated by the proposed estimator, are found to be virtually the same as those obtained from the bicubic spline interpolation for SRM drives with single-pulse voltage, hysteresis current chopping, as well as with voltage pulse width modulation control. The success of all the case studies being reported is a good validation of the usefulness and accuracy of the proposed real-time torque estimator that, as described in this paper, can be used to quickly estimate the instantaneous output torque of SRM drives.     

Synthesis and characterization of poly(siloxane-urethane)s

A series of polyurethane block copolymers based on hydroxy-terminated polydimethylsiloxane and poly(propylene glycol) soft segments of molecular weights 1818 and 2000, respectively, were synthesized. The hard segments consisted of 4,4′-diphenylnethane diisocyanate and 1,4-butanediol as the chain extender. Samples with different molar ratios were prepared. We tried to synthesize polydimethylsiloxane-based polyurethanes (PDMS-PU) containing a hard block as major fraction and a soft block as minor fraction for preparing toughened rigid systems. After a study of the pure polydimethylsiloxane-based polyurethane and poly(propylene glycol)-based polyurethane (PPG-PU), (mixed polyol)-based block copolymers and blends of PDMS-PU and PPG-PU were synthesized, and characterized by means of differential scanning calorimetry, tensile testing and scanning electron microscopy. In (mixed polyol)-based copolymers and lower hard-segment content blends, macro-phase separation occurred, but blends with higher hard-segment contents showed significant reduction in amounts of phase separation.     

Enhancement of oxide break-up by implantation of fluorine inpoly-Si emitter contacted p+-n shallow junctionformation

In this study, it is demonstrated that the incorporation of fluorine can enhance poly-Si/Si interfacial oxide break-up in the poly-Si emitter contacted p⁺-n shallow junction formation. The annealing temperature for breaking up the poly-Si/Si interfacial oxide has been found to be as low as 900°C. As a result, the junction depth of the BF₂-implanted device is much larger than that of the boron-implanted device     

A solenoid-derived wiggler

A novel wiggler design for use in free-electron lasers (FELs) is proposed, consisting of a staggered array of magnetic poles situated inside the bore of a solenoid. The resultant field pattern consists of a periodic transverse magnetic field on axis, as well as a longitudinal guide field. Such a wiggler has several advantages: the longitudinal field acts to confine the electrons near the FEL axis, high fields can be attained at short wiggler periods, the field strength is easily varied, and fabrication and testing of the wiggler are relatively easy. It is planned to use this wiggler design in a far infrared FEL to be built at Stanford University     

Neue Entwicklungen beim Hohlkatoden‐Gasflusssputtern. New Developments in Hollow Cathode Gas Flow Sputtering

The gas flow sputter technique was invented a few years ago particularly for the inexpensive fabrication of sophisticated ceramic layers. Meanwhile, it has matured and become increasingly powerful. Today it is on the verge of being applied in industrial fabrication processes. The present article gives an overview over the method, its characteristics and the numerous applications.     

Effect of storage temperature on phenolics stability in hawthorn (Crataegus pinnatifida var. major) fruits and a hawthorn drink

The stability of five major phenolics, namely (−)-epicatechin (EC), procyanidin B₂ (PC-B₂), chlorogenic acid (ChA), hyperoside (HP) and isoquercitrin (IQ), in hawthorn fruits and a canned hawthorn drink were evaluated during 6 months of storage in the dark at three different temperatures (4, 23 and 40 °C). HPLC with a diode-array detector was used to determine the contents of the individual compounds. The results showed that the studied phenolics in the hawthorn fruits and the drink were both stable at 4 °C and relatively unstable at 23 and 40 °C with varied extents of degradation. At room temperature (23 °C), marked degradations of EC and PC-B₂ were observed in both the fruits and the drink with around 50% and 30% decrease after a 6-month storage, respectively. A more significant decrease of the phenolics was observed at 40 °C, especially for EC and PC-B₂, which were almost completely degraded after a 6-month storage. HP, IQ and ChA were relatively stable at 23 °C, but unstable at 40 °C. Therefore, low-temperature storage is recommended for maintaining the quality and efficacy of hawthorn fruits and its preparations.     

Cross-Border Migration of Hong Kong Residents Under the 'One Country, Two Systems' Policy

Hong Kong is known as a migrant city because its population was sourced from mainland China, and because there has always been outflows of people to overseas countries, especially from the mid-1980s to mid-1990s. Emigration to mainland China has become a significant recent trend. This article discusses this phenomenon in the theoretical contexts of migration and trans-border residential development. It contends that the trend will intensify more quickly than other cross-border movements because the two systems are separated by a political border within one country, and because there are common cultural ties and rapid economic integration.     

An interactive multiple-response simulation optimization method

This study proposes a new interactive multicriteria method for determining the best levels of the decision variables needed to optimize a stochastic computer simulation with multiple response variables. The method, called the Pairwise Comparison Stochastic Cutting Plane (PCSCP) method, combines good features from interactive multiple objective mathematical programming and response surface methodology. The major characteristics of the PCSCP method are: (1) it interacts progressively with the decision-maker (DM) to obtain her preferences, (2) it uses experimental design to explore the decision space adequately while reducing the burden on the DM, and (3) it uses the preference information provided by the DM and the sampling error in the responses to reduce the decision space. The mechanics of the method are illustrated with a numerical example. Some computational studies evaluating the method are also reported.