Photon and vibration synergism on planar defects induced 2D-graphitic carbon nitride for ultrafast remediation of dyes and antibiotic ampicillin

Journal of Materials Science - Hybrid oxidation methodologies (HOMs) and active site enrichment of 2D nanocatalyst through defects induction are ubiquitously used for generating adequate reactive...     

An investigation of the drivers,barriers, and incentives for environmental management systems in the Malaysian food and beverage industry

Clean Technologies and Environmental Policy - Food production and consumption is one of the major causes of global environmental degradation. One way to address environmental impacts in the food...     

A dual-mode bandpass filter with enhanced capacitive perturbation

A dual-mode ring bandpass filter with two pairs of capacitors has been designed. The capacitors are used to control the location of the even- and odd-mode frequencies independently, allowing weak coupling for narrow-band filter design with realizable capacitance values. Theoretical expressions have been derived for these frequencies. A 4% bandwidth bandpass filter centered at 1.9 GHz was designed and tested with good agreement between theoretical and measured results.     

Binding free energy calculations of galectin-3-ligand interactions

Galectins show remarkable binding specificity towards ß-galactosides.A recently developed method for calculating binding free energiesbetween a protein and its substrates has been used to evaluatethe binding specificity of galectin-3. Five disaccharides anda tetrasaccharide were used as the substrates. The calculatedbinding free energies agree quite well with the experimentaldata and the ranking of binding affinities is well reproduced.For all the six protein–ligand complexes it was observedthat electrostatic interactions oppose binding whereas the non-polarcontributions drive complex formation. The observed bindingspecificity of galectin-3 for galactosides rather than glucosidesis discussed in light of our results.     

Applying the critical path method to manufacturing routing

Traditionally the critical path method (CPM) has been used primarily as an a'priori planning and scheduling device. Its applications have typically been limited to one-shot projects, usually with a long period of completion time. This paper proposes taking these ideas to continuous production systems, and to implement the CPM not just at the outset but throughout the process. The algorithm calls for repeatedly calculating the critical path through the production process and routing parts so as to remain off this path. Before the model is presented, some basic ideas are introduced from group technology (GT) and CPM. After the presentation of the model, two potential implementations with the usage of computer are proposed.     

Metastatic parathyroid carcinoma in the MEN2A syndrome

We report a patient with a metastatic parathyroid carcinoma and medullary carcinoma of the thyroid. This patient represents a variation of the multiple endocrine neoplasia syndrome (MEN) type 2A. There was no evidence of a phaeochromocytoma. The case illustrates the difficulties that may be encountered in localising the source of PTH secretion; the patient underwent four unsuccessful exploratory operations of the neck and mediastinum before further investigations revealed a single metastatic deposit of parathyroid carcinoma involving the first thoracic vertebra. PCR amplification and sequencing of the RET oncogene from the metastatic parathyroid carcinoma and genomic DNA revealed a heterozygous mutation (Cys634Tyr) in exon 11, as has previously been described to occur in MEN 2A. In addition, loss of tumour heterozygosity was demonstrated at loci from chromosomes 1, 2, 3p, 13q and 16p. This represents the first report of a parathyroid carcinoma in a MEN2A patient, in which the multiple allelic deletions are consistent with the generalised losses observed in aggressive tumours.     

Control of calcium hexaluminate grain morphology in in-situ toughened ceramic composites

The influence of processing conditions on the morphology of calcium hexaluminate (CA₆) grains in Al₂O₃: 30 vol% CaO·6Al₂O₃ (CA₆) ceramic composites was investigated. Specimens were prepared by in-situ reaction sintering using precursor powders of alumina, and either calcium carbonate or calcium oxide. In some samples, 1 vol% anorthite glass was added as a sintering aid. X-ray diffraction was used to study the phase development in the as-calcined and sintered states. The resultant microstructures were characterized using both scanning electron microscopy (SEM), and imaging secondary ion mass spectrometry (SIMS). It was found that the CA₆ grains developed a platelike morphology when CaCO₃ was used as the starting calcium-rich powder. In contrast, samples prepared using CaO resulted in equiaxed CA₆ grains. This result was observed to be independent of the anorthite glass addition. The findings are rationalized in terms of distinct CA₆ reaction mechanisms, resulting from differences in the reactivity of the powders during the early stages of calcining.Cement Nomenclature C CaO - A Al₂O₃     

Cervicovaginal foetal fibronectin in the prediction of preterm labour in a low-risk population

Ten groups of 14 immunosuppressed NMRI-mice (nu/nu) were raised and kept under germ-reduced conditions. The control animals were fed a germ-reduced diet, nine other groups received the same diet with selegiline (CAS 14611-51-9, Deprenyl) or lipoic acid (thioctic acid, CAS 62-46-4) admixed at various amounts. The 50% survival rate, the total life span of each group and the areas under the curves were determined to evaluate life expectancy as compared to the controls. The racemate of lipoic acid at high dosage (350 mg/kg body weight) reduced the life span significantly. The S(-)-enantiomer of lipoic acid (75 mg/kg body weight) increased the 50% survival rate, whereas the physiologic R(+)-enantiomer (9 mg/kg body weight) expanded the total life span of its group. Alteration of only one out of three parameters was not considered significant. All other groups except for one did not differ from controls: only animals which obtained 75 micrograms selegiline per kg of body weight and per day exerted increased life expectancies by all three parameters. This group exhibited also in statistical evaluation a significantly (p < 0.05) prolongated survival time up to about 200% as compared to the control animals.     

Decreased levels of a soluble form of the human adhesion receptor CD58 (LFA-3) in sera and synovial fluids of patients with rheumatoid arthritis

The mode of interaction between muramyl dipeptide (MDP), a compound with immunopharmacological activities, and 5-hydroxtryptamine (5-HT, serotonin) was studied in isolated nerve-smooth muscle preparations of the carp stomach. Application of exogenous 5-HT evoked direct smooth muscle contractions; electric neurogenic stimulation evoked twitches due to release of 5-HT from nerve endings. Contractions evoked by a high concentration of 5-HT (3-30 microM) were resistant to atropine and potentiated in the presence of MDP. Isamoltan (5-HTID antagonist) decreased the amplitude of contractions, whereas ketanserin (5-HT2 antagonist) and MDL 72,222 (5-HT3 antagonist) had no effect. The addition of low concentrations (0.1-1.5 microM) of 5-HT did not contract the preparation but caused a decrease in the amplitude of neurogenic twitches, which might be due to the presynaptic inhibition of serotonin release. This effect of 5-HT was not changed by isamoltan or ketanserin, but it was largely reduced in the presence of 5-HT3 antagonists tropisetron and MDL 72,222. This inhibitory effect of 5-HT on twitch amplitude was potentiated by MDP. The interaction of MDP with the serotonergic system thus involved not only potentiation of the postsynaptic effect of higher 5-HT concentrations, which might have been mediated via the 5-HT1 subsystem, but also presynaptic inhibition. MDP enhancement of 5-HT's inhibitory effect, mediated via 5-HT3 receptors, might represent a new feature in mutual 5-HT-MDP interactions.