Symbol rate and modulation level-controlled adaptivemodulation/TDMA/TDD system for high-bit-rate wireless data transmission

This paper proposes a time-division multiple-access/time-division duplex (TDMA/TDD)-based symbol rate and modulation level-controlled adaptive modulation system for high-bit-rate data transmission. The proposed system controls both the symbol rate and modulation level for the next transmission time slot according to the estimated carrier power to noise spectral density ratio (C/N₀) and delay spread for the time slot to achieve higher bit rate and higher transmission quality as well as higher delay-spread immunity. It is demonstrated by computer simulation and laboratory experiments that the proposed system can achieve a higher average bit rate with higher transmission quality in comparison with the fixed-rate quaternary phase-shift keying (QPSK) system and modulation level-controlled adaptive modulation system in both flat Rayleigh and frequency-selective fading environments. The simulated and experimental results also show that the proposed adaptive modulation techniques can be applied to 1-2-Mb/s indoor and outdoor microcellular systems with its delay spread of up to 250 ns and its terminal mobility of up to pedestrian speed without employing any special antifrequency-selective fading techniques, such as the adaptive equalizer and space diversity     

Heavy arsenic doping of silicon grown by atmospheric pressure selective epitaxial chemical vapor deposition

Selective epitaxial Si with a high arsenic concentration of 2.2×10¹⁹ atoms/cm³ was deposited at a high growth rate of 3.3 nm/min under atmospheric pressure. It was confirmed that this method had excellent selectivity and produced films having good crystalline quality, abrupt dopant profiles at the interfaces, and smooth surfaces. The growth mechanism is discussed in terms of the relationship between the effects of arsenic surface segregation and etching by hydrogen chloride.     

An abnormally shortened fatigue life of steels caused by anelasticity

Some abnormal fatigue life shortenings dependent upon load frequency for several steels are discussed. A possible relation between anelasticity caused by interstitial atoms and the abnormal fatigue life drop is presented. Normally, interstitial atoms are in a position which minimizes the energy around a dislocation, the Snoek ordering sites. We consider the Snoek effect as a typical example of anelasticity, and the possibility on atoms moving from attractive sites to repulsive ones when repeated stresses are applied and discuss a theory to explain the reduction of the fatigue life using Snoek ordered atoms moving out by fatigue stress at the frequency of Snoek effect. Bending fatigue tests were conducted to obtain the relationship between fatigue life and load frequency at two different temperatures (298 K and 333 K) for an iron nitrided steel. A sharp fatigue life drop was observed at a load frequency corresponding to the resonant frequency of the Snoek effect for nitrogen atoms. The frequency was about 3 Hz and 298 K and shifted to a higher frequency — about 6 Hz — at 333 K. Results reveal that the possible explanation to those abnormal phenomena may be anelasticity.Work partially conducted at Laboratorio E and Departamento de Ciencias de Materiales, Universidad Simón Bolívar, Venezuela.     

Ion exchange of intercalation compounds from WOP2O7 and intercalation ofn-alkylamines

Ion exchange of Na _x WOP₂O₇ ·nH₂O (x 1.4) prepared from WOP₂O₇ was attempted, using alkaline and alkaline earth ions. The degree of exchange was observed to be >50% at 90° C except for Mg²⁺. The basal spacing of ion-exchanged materials for the hydrated phase were dependent on the number of water molecules in the interlayer spaces, while those for the dehydrated phase increased with the size of ions in the interlayer spaces. The network of water molecules linked by the hydrogen bond in the interlayer spaces seems to determine the basal spacing. By the ion-exchange reaction,n-alkylammonium ions were intercalated into the interlayer spaces of Na _x WOP₂O₇ ·nH₂O (x 1.4) and Sn _x H _y WOP₂O₇ ·nH₂O (2x +y 0.5). In spite of the difference in the charge density of the host layer, a similar arrangement of alkyl chains in the interlayer spaces resulted, and neutral amines were considered to be intercalated as well as ammonium ions. Direct reaction ofn-alkylamine with WOP₂O₇ produced an intercalation compound without reduction of tungsten. The arrangement of the amines in the interlayer spaces is similar to that supposed to the ion-exchanged derivatives when heated at 140° Cin vacuo.     

Principle and operation of a new type motor consisting of piezoelectric device and strain wave gearing

The authors have developed a new type of motor consisting of a piezoelectric device and strain wave gearing, and is called a piezoelectric motor. This is a first step in realizing a low-speed, small-size and lightweight motor. The principle of the motor is that the traveling wave is produced by piezoelectric devices and displacement conversion devices without mechanical resonance, and the torque to rotate the motor is generated by a mechanism of strain wave gearing (circular spline and flexspline) without using friction. The motor is operated at variable frequency and its rotational position (angle) is controlled in open-loop because it is basically a synchronous motor. In this paper, the structure and principle of the proposed motor are explained and the driving method and the mechanical characteristics of an experimental motor also are described. The results are as follows:

• 1 The realizability of the proposed piezoelectric motor is verified experimentally. The experimental motor operates at 2920 steps per revolution, and its speed range is 0 to 960 pps [or 0 to 20 (rpms)].
• 2 The torque characteristics are clarified qualitatively.
• 3 The generated torque of the experimental motor is small (less than 0.03 Nm) and therefore the improvement of the torque is an important subject hereafter.
• 4 It is possible to construct the motor with nonmetallic material. This fact is considered to facilitate obtaining a means to lighten the weight of the motor in the future.

     

Stromal CCL5 Promotes Breast Cancer Progression by Interacting with CCR3 in Tumor Cells

Chemokines secreted from stromal cells have important roles for interactions with carcinoma cells and regulating tumor progression. C-C motif chemokine ligand (CCL) 5 is expressed in various types of stromal cells and associated with tumor progression, interacting with C-C chemokine receptor (CCR) 1, 3 and 5 expressed in tumor cells. However, the expression on CCL5 and its receptors have so far not been well-examined in human breast carcinoma tissues. We therefore immunolocalized CCL5, as well as CCR1, 3 and 5, in 111 human breast carcinoma tissues and correlated them with clinicopathological characteristics. Stromal CCL5 immunoreactivity was significantly correlated with the aggressive phenotype of breast carcinomas. Importantly, this tendency was observed especially in the CCR3-positive group. Furthermore, the risk of recurrence was significantly higher in the patients with breast carcinomas positive for CCL5 and CCR3 but negative for CCR1 and CCR5, as compared with other patients. In summary, the CCL5-CCR3 axis might contribute to a worse prognosis in breast cancer patients, and these findings will contribute to a better understanding of the significance of the CCL5/CCRs axis in breast carcinoma microenvironment.     

Different feeding and gustatory responses to ecdysone and 20-hydroxyecdysone by larvae of the silkworm,Bombyx mori

The feeding and gustatory responses to ecdysone and 20-hydroxyecdysone were investigated in the silkworm,Bombyx mori. 20-Hydroxyecdysone reduced feeding response strongly in fourth- and fifth-instar larvae, whereas ecdysone had no effect on feeding response. 20-Hydroxyecdysone stimulated the R receptor, the receptor to feeding deterrents, to a great degree. By contrast, ecdysone was much less effective for stimulating the R receptor. These results indicate that ecdysone and 20-hydroxyecdysone have different effects on feeding response due to different interactions with mouthpart chemoreceptors.     

Highly Transparent Lu-α-SiAlON

Novel Lu-α-SiAlON ceramics were produced by hot pressing mixtures of Si₃N₄, Lu₂O₃, AlN, and Al₂O₃ at 1950°C for 2 h in a nitrogen atmosphere. The resultant SiAlON was fully dense and possessed a uniform, equiaxed microstructure with a grain size of ∼1 μm, which resulted in a high hardness of >19 GPa. In addition to high hardness, the sample showed very high optical transparency in the visible light region, with >70% transmission at higher wavelengths. This high transparency was attributed to the uniform, dense microstructure and lack of residual grain-boundary phase.     

Oxidative coupling of methane over LaCoO3−δ-based mixed oxides

The catalytic activity of LaCoO_3–-based mixed oxides for the oxidative coupling of methane has been tested by TPR and cyclic reaction. Characterization has been done by XRD, TGA and Mössbauer spectrometry. It is likely that the perovskite-crystal structure containing hypervalent metal ions has an important role and that unique structural oxygen species in the perovskite contribute to the partial oxidation of methane.