Nanolayer CrAlN/TiSiN coating designed for tribological applications

With the goal to produce a hard and tough coating intended for tribological applications, CrAlN/TiSiN nanolayer coating was prepared by alternative deposition of CrAlN and TiSiN layers. In the first part of the article, a detailed study of phase composition, microstructure, and layer structure of CrAlN/TiSiN coating is presented. In the second part, its mechanical properties, fracture and tribological behavior are compared to the nanocomposite TiSiN coating. An industrial magnetron sputtering unit was used for coating deposition. X-ray photoelectron spectroscopy, energy dispersive X-ray spectroscopy, X-ray diffraction, scanning electron microscopy, and transmission electron microscopy were used for compositional and microstructural analysis. Mechanical properties and fracture behavior were studied by instrumented indentation and focused ion beam techniques. Tribological properties were evaluated by ball-on-disk test in a linear reciprocal mode. A complex layer structure was found in the nanolayer coating. The TiSiN layers were epitaxially stabilized inside the coating which led to formation of dislocations at interfaces, to introduction of disturbances in the coating growth, and as a result, to development of fine-grained columnar microstructure. Indentation load required for the onset of fracture was twice lower for the nanolayer CrAlN/TiSiN, compared to the nanocomposite TiSiN coating. This agrees very well with their mechanical properties, with H³/E² being twice higher for the TiSiN coating. However, the nanolayer coating experienced less severe damage, which had a strong impact on tribological behavior. A magnitude of order lower wear rate and four times lower steady state friction coefficient were found for the nanolayer coating.     

In situ measurements of human cough aerosol hygroscopicity

The airborne dynamics of respiratory droplets, and the transmission routes of pathogens embedded within them, are governed primarily by the diameter of the particles. These particles are composed of the fluid which lines the respiratory tract, and is primarily mucins and salts, which will interact with the atmosphere and evaporate to reach an equilibrium diameter. Measuring organic volume fraction (OVF) of cough aerosol has proved challenging due to large variability and low material volume produced after coughing. Here, the diametric hygroscopic growth factors (GF) of the cough aerosol produced by healthy participants were measured in situ using a rotating aerosol suspension chamber and a humidification tandem differential mobility analyser. Using hygroscopicity models, it was estimated that the average OVF in the evaporated cough aerosol was 0.88 ± 0.07 and the average GF at 90% relative humidity (RH) was 1.31 ± 0.03. To reach equilibrium in dry air the droplets will reduce in diameter by a factor of approximately 2.8 with an evaporation factor of 0.36 ± 0.05. Hysteresis was observed in cough aerosol at RH = ∼35% and RH = ∼65% for efflorescence and deliquescence, respectively, and may depend on the OVF. The same behaviour and GF were observed in nebulized bovine bronchoalveolar lavage fluid.     

The effect of multiple time scales and subexponentiality in MPEGvideo streams on queueing behavior

Guided by the empirical observation that real-time MPEG video streams exhibit both multiple time scale and subexponential characteristics, we construct a video model that captures both of these characteristics and is amenable to queueing analysis. We investigate two fundamental approaches for extracting the model parameters: using sample path and second-order statistics-based methods. The model exhibits the following two canonical queueing behaviors. When strict stability conditions are satisfied, i.e., the conditional mean of each scene is smaller than the capacity of the server, precise modeling of the interscene dynamics (long-term dependency) is not essential for the accurate prediction of small to moderately large queue sizes. In this case, the queue length distribution is determined using quasistationary (perturbation theory) analysis. When weak stability conditions are satisfied, i.e., the conditional mean of at least one scene type is greater than the capacity of the server, the dominant effect for building a large queue size is the subexponential (long-tailed) scene length distribution. In this case, precise modeling of intrascene statistics is of secondary importance for predicting the large queueing behavior. A fluid model, whose arrival process is obtained from the video data by replacing scene statistics with their means, is shown to asymptotically converge to the exact queue distribution. Using the transition scenario of moving from one stability region to the other by a change in the value of the server capacity, we synthesize recent queueing theoretic advances and ad hoc results in video modeling, and unify a broad range of seemingly contradictory experimental observations found in the literature. As a word of caution for the widespread usage of second-order statistics modeling methods, we construct two processes with the same second-order statistics that produce distinctly different queueing behaviors     

Modeling video sources for real-time scheduling

What is the impact of the autocorrelation of variable-bit-rate (VBR) sources on real-time scheduling algorithms? Our results show that the impact of long term, or interframe, autocorrelation is negligible, while the impact of short term, or intraframe, autocorrelation can be significant. Such results are essentially independent of the video coding scheme employed. To derive these results, video sequences are modeled as a collection of stationary subsequences called scenes. Within a scene, a statistical model is derived for both the sequence of frames and of slices. The model captures the distribution and the autocorrelation function of real-time video data. In previous work, the pseudoperiodicity of the slice level auto-correlation function made it difficult to develop a simple yet accurate model. We present a generalization of previous methods that can easily capture this pseudoperiodicity and is suited for modeling a greater variety of autocorrelation functions. By simply tuning a few parameters, the model reproduces the statistic behavior of sources with different types and levels of correlation on both the frame and the slice level.     

A 4-MB on-chip L2 cache for a 90-nm 1.6-GHz 64-bit microprocessor

A 4-MB L2 data cache was implemented for a 64-bit 1.6-GHz SPARC(r) RISC microprocessor. Static sense amplifiers were used in the SRAM arrays and for global data repeaters, resulting in robust and flexible timing operation. Elimination of the global clock grid over the SRAM array saves power, enabled by combining the clock information with array select signals. Redundancy was implemented flexibly, with shift circuits outside the main data array for area efficiency. The chip integrates 315 million transistors and uses an 8-metal-layer 90-nm CMOS process.     

Vortices in anisotropic type-II superconductors

We present a generalized variational model of an isolated vortex, valid in the anisotropic case when the external magnetic field is along one of the symmetry directions. We discuss the effects of the field anisotropy on the core and magnetic pinning of individual vortices.     

Aging, attention, and intelligence.

The aims of this study were (a) to find out if attentional ability factors that are separate from the well-established ability factors (e.g., fluid intelligence, crystallized intelligence, and short-term acquisition and retrieval function) can be identified, and (b) to establish, through the use of part correlations, whether attentional abilities play a role in the changes in fluid and crystallized intelligence that occur with increasing age. A battery of 36 tests (19 psychometric tests and 17 measures of attentional processes) were given to 100 people, 20 of whom were in each age decade between 20 and 70. Results indicated that three attentional factors—Search, Concentration, and Attentional Flexibility—exist at the primary-ability level and that all three define fluid intelligence at the second-order level. Results also indicate that the decline in fluid intelligence with increasing age disappears if attentional factors are parted-out. Similarly, the increase in crystallized intelligence with increasing age becomes even greater if one controls for attentional processes. I conclude that changes in attentional processes play an important part in changes in human intelligence with age. (PsycINFO Database Record (c) 2010 APA, all rights reserved)     

SurA assists the folding of Escherichia coli outer membrane proteins

Many proteins require enzymatic assistance in order to achieve a functional conformation. One rate-limiting step in protein folding is the cis-trans isomerization of prolyl residues, a reaction catalyzed by prolyl isomerases. SurA, a periplasmic protein of Escherichia coli, has sequence similarity with the prolyl isomerase parvulin. We tested whether SurA was involved in folding periplasmic and outer membrane proteins by using trypsin sensitivity as an assay for protein conformation. We determined that the efficient folding of three outer membrane proteins (OmpA, OmpF, and LamB) requires SurA in vivo, while the folding of four periplasmic proteins was independent of SurA. We conclude that SurA assists in the folding of certain secreted proteins.     

Central poststroke pain and Wallenberg''s lateral medullary infarction: frequency, character, and determinants in 63 patients

BACKGROUND: Questionnaire-based surveys from several countries have consistently detected adverse health associated with home dampness and mould growth. METHODS: To test the validity of questions commonly used to indicate the presence of indoor mould, questionnaires were administered in 403 homes where dust samples were taken for viable fungi and air samples for ergosterol. RESULTS: Geometric mean concentrations of the total viable fungi were 255 (SE 116) x 10(3) CFU/g when mouldy odours were reported and 155 (SE 55) when odours were not reported (P = 0.01). Similarly, reported water damage was associated with a 50% increase (P = 0.06). Geometric mean concentrations of the predominantly indoor-source fungi, Aspergillus plus Penicillium, were twice as high when mould or mildew was reported than when not mentioned (P = 0.01). The presence of reported mould or water damage was unrelated to the presence of detectable levels of ergosterol. There was evidence for reporting bias: in the presence of low concentrations of viable fungi in dust, respondents reporting allergies were more likely to report visible mould growth (odds ratio [OR] = 1.8, 95% confidence interval [CI]: 0.9-3.5, P = 0.10. In the presence of elevated concentrations of dust fungi, respondents who smoked were less likely to report visible mould growth, (OR = 0.4, 95% CI: 0.2-0.7, P = 0.005). CONCLUSIONS: Reported mould, water damage, and mouldy odours were associated with elevated levels of indoor fungi. However, inaccuracy was high and there was evidence of a systematic reporting bias. Future research should concentrate on developing accurate objective measures of exposure to fungi, and then use this information to develop valid questionnaires. Currently, objective measures not questionnaires, are recommended to clarify the health effects of indoor fungi.