Processing of Yttria-Alumina Coated Silicon Nitride Slips by Slip Casting

Si₃N₄powders coated with 6 wt% Y₂O₃and 4 wt% Al₂O₃were prepared by coprecipitation. The resulting powders were dispersed in water at different pH values and with addition of various amounts of ammonium polyacrylate (NH₄PA) to produce 32 vol% slips. The influence of the amount of NH₄PA solution added and pH on the rheological properties of 32 vol% coated Si₃N₄slips were studied. In addition, the sintered density of cast samples was determined and related to the degree of slip dispersion. The adsorption of the NH₄PA on the coated particle surface was rather high and the surface became saturated near 0.86 mg/m²at pH 9.2. High NH₄PA concentrations (1.7–3 wt%) were necessary to obtain well dispersed 32 vol% coated Si₃N₄slips at pH 9.2. The best stabilization was obtained with the addition of 2.3 wt% NH₄PA; in this condition, the viscosity reached a minimum value of 35 mPa.s at 100 s^–1. The slip viscosity increased with increasing pH from 9.2 to 10.2. Slips with low viscosities gave a more dense packing of cast samples and consequently higher sintered density values.     

Gyrotron coaxial cylindrical resonators with corrugated innerconductor: Theory and experiment

Gyrotron coaxial resonators with a longitudinally slotted inner cylinder are examined analytically using a surface impedance model, from which expressions for the electromagnetic field, ohmic quality (Q) factor, and characteristic equation of the transverse eigenvalues χ _m,p are obtained. The major attributes of such resonators are expressed by the dependence of χ_m,p on the parameter C-defined as the ratio of the outer to inner radii of the coaxial structure. In that connection, the effect of the corrugation parameters on χ_m,p is particularly investigated on the basis of an expression derived for the slope function dχ_m,p,p/dC. It is shown that the χ_m,p(C) curve may either exhibit oscillatory behavior or present a flat portion over a wide range of C depending on the corrugation parameters chosen. The theory is checked against experiment in which resonant frequencies and total Q factors were measured for TE modes operating in the range of 8-16 GHz in a coaxial cavity with 40 slots. Good agreement is found in that the magnitude of the relative error in frequency is less than 0.5%. Corrugated coaxial resonators prove to be relevant to megawatt gyrotrons where highly selective cavities are required to ensure high conversion efficiency     

Coupling GIS with Hydrologic and Hydraulic Flood Modelling

Geographic Information Systems (GIS) have been recognised as a powerful means to integrate and analyse data from various sources in the context of comprehensive floodplain management. As part of this comprehensive approach to floodplain management, it is very important to be able to predict the consequences of different scenarios in terms of flooded areas and associated risk. Hydrologic and hydraulic modelling plays a crucial role and there is much to gain in incorporating these modelling capabilities in GIS. This is still a rather complex task and research is being done on the full integration of these models. Interfacing between these models and GIS may be a very efficient way of overcoming the difficulties and getting very good results in terms of engineering practice. This paper presents results based on the use of Intergraph GIS coupled with Idrisi GIS. Using these two systems substantially increased the flexibility of using GIS as a tool for flood studies. A lumped (XSRAIN) and a distributed (OMEGA) hydrologic models were used to simulate flood hydrographs. The well known HEC-2 Hydraulic model was used to compute flooded areas. These models were applied in the Livramento catchment with very good results. The computation of flooded areas for different flood scenarios, and its representation in GIS, can be used in the assessment of affected property and associated damages. This is a very useful GIS-based approach to floodplain management.     

Compulsory notification of cysticercosis in Ribeir?o Preto-SP, Brazil

Cysticercosis is a severe public health problem in several regions of Asia, Africa and Latin America. Epidemiologic studies based on the frequency of cases observed in specialized neurology, neurosurgery and computed tomography services, at autopsy and in seroepidemiologic studies do not permit the determination of the true prevalence of the disease in the population. The objective of the present study was to investigate the prevalence of cysticercosis by compulsory notification. The coefficient of prevalence was 54 cases/100,000 inhabitants in the municipality of Ribeir?o Preto. The results also indicated that cysticercosis is not under control in our region since 21% of cases presented the active form of the disease. Compulsory notification proved to be a valuable resource for the epidemiologic study of cysticercosis, also permitting the mapping of more affected areas for a better direction of prevention strategies.     

A wind park reduced-order model using singular perturbations theory

Due to the increasing penetration of wind energy, it is necessary to possess design tools that are able to simulate the impact of these installations on electric utility grids. In order to provide a net contribution to this issue, a detailed wind park model has been developed and is briefly presented. However, the computational costs associated with the performance of such a detailed model in describing the behavior of a wind park composed by a considerable number of units may render its practical application very difficult. To overcome this problem, singular perturbations theory has been applied to reduce the order of the detailed wind park model, and therefore create the conditions for the development of a dynamic equivalent which is able to retain the relevant dynamics with respect to the existing AC power system. Validation results proving the ability of singular perturbations reduced order model to match the results provided by the detailed model are shown and commented upon