In situ measurements of human cough aerosol hygroscopicity

The airborne dynamics of respiratory droplets, and the transmission routes of pathogens embedded within them, are governed primarily by the diameter of the particles. These particles are composed of the fluid which lines the respiratory tract, and is primarily mucins and salts, which will interact with the atmosphere and evaporate to reach an equilibrium diameter. Measuring organic volume fraction (OVF) of cough aerosol has proved challenging due to large variability and low material volume produced after coughing. Here, the diametric hygroscopic growth factors (GF) of the cough aerosol produced by healthy participants were measured in situ using a rotating aerosol suspension chamber and a humidification tandem differential mobility analyser. Using hygroscopicity models, it was estimated that the average OVF in the evaporated cough aerosol was 0.88 ± 0.07 and the average GF at 90% relative humidity (RH) was 1.31 ± 0.03. To reach equilibrium in dry air the droplets will reduce in diameter by a factor of approximately 2.8 with an evaporation factor of 0.36 ± 0.05. Hysteresis was observed in cough aerosol at RH = ∼35% and RH = ∼65% for efflorescence and deliquescence, respectively, and may depend on the OVF. The same behaviour and GF were observed in nebulized bovine bronchoalveolar lavage fluid.     

Muscle-ligament interactions at the knee during walking.

A two-dimensional mathematical model of the knee is used with gait analysis to calculate muscle, cruciate ligament and tibio-femoral contact forces developed at the knee during normal level walking. Ten normal adult subjects--four females and six males--participated. The knee model is based upon a four-bar linkage comprising the femur, tibia and two cruciate ligaments. It takes account of the rolling and sliding of the femur on the tibia during flexion/extension and the changes in direction of the ligaments and muscle tendons. We considered forces transmitted by six elements: quadriceps, hamstrings, gastrocnemius, anterior and posterior cruciate ligaments, and tibio-femoral contact. The equations of mechanics can be used to determine the absolute values of only three of the knee forces simultaneously, so that twenty limiting solutions of three of the six forces were considered. A limiting solution was rejected if any of the three forces were negative, corresponding to compressive muscle or ligament forces, or tensile contact forces. These constraints always reduced and at times removed the redundancy of the knee structures. The high incidence of predicted single muscle activity, supported by electromyography, suggested that the ligaments play a significant role in load transmission during gait. The temporal patterns of muscle and ligament activity and ligament force magnitudes were sensitive to the choice of model parameters. The analysis showed that each of four possible minimum principles of muscle selection--minimal muscle force, muscle stress, ligament force and contact force--was unlikely to be valid throughout the walking cycle.     

Characterization of an ASIC for CPG sensors with grid-only depth of interaction sensing

A new version of the front-end application specific integrated circuit (ASIC) for co-planar-grid (CPG) sensors is presented. Compared to the first version, the ASIC is optimized for signal/noise performance, modified in peaking time, and it implements timing signals to measure the depth of interaction using the grids signals only. Experimental results using state-of the-art CPG sensors and different approaches for reducing the error due to electron trapping are reported. A new technique that makes use of the sum and difference of the grids signals is also presented.     

Retinal neurostimulator for a multifocal vision prosthesis.

A neurostimulator application-specific integrated circuit (ASIC) with scalable circuitry that can stimulate 14 channels, has been developed for an epi-retinal vision prosthesis. This ASIC was designed to allow seven identical units to be connected to control up to 98 channels, with the ability to stimulate 14 electrodes simultaneously. The neurostimulator forms part of a vision prosthesis, designed to restore vision to patients who have lost their sight due to retinal diseases such as retinitis pigmentosa and macular degeneration. For charge balance, the neurostimulator was designed to stimulate with current sources and sinks operating together, and with the ability to drive a hexagonal mosaic of electrodes to reduce the electrical crosstalk that occurs when multiple bipolar stimulation sites are active simultaneously. A hexagonal mosaic of electrodes surrounds each stimulation site and has been shown to effectively isolate each site, increasing the ability to inject localized independent charge into multiple regions simultaneously.     

Normality and impairment following profound early institutional deprivation: A longitudinal follow-up into early adolescence.

Longitudinal analyses on normal versus impaired functioning across 7 domains were conducted in children who had experienced profound institutional deprivation up to the age of 42 months and were adopted from Romania into U.K. families. Comparisons were made with noninstitutionalized children adopted from Romania and with nondeprived within-U.K. adoptees placed before the age of 6 months. Specifically, the validity of the assessment, the degree of continuity and change in levels of functioning from 6 to 11 years, and the factors in the pre- and postadoption environment accounting for heterogeneity in outcome were examined. Pervasive impairment was significantly raised in children experiencing institutional deprivation for ≥6 months of life, with a minority within this group showing no impairment. There was no additional significant effect of duration of deprivation beyond the 6-month cutoff, and few other predictors explained outcome. The pattern of normality/impairment was mainly established by 6 years of age, with considerable continuity at the individual level between 6 and 11 years. The findings are discussed in terms of the possibility of a sensitive period for development. (PsycINFO Database Record (c) 2010 APA, all rights reserved)     

Impact of microstructure on stability of permanent magnet biasedmagnetoresistive heads

This work pertains to output voltage stability of soft adjacent layer biased magnetoresistive heads with abutted permanent magnetic films for domain stabilization. A micromagnetic model has been developed to study the effect of the permanent magnet film microstructure and the micromagnetic properties of the abutted junction interface on head stability. The impact on head stability is analyzed with respect to interfacial ferromagnetic coupling across the junction interface and intergranular exchange coupling in the permanent magnet films among other film properties     

Quick evaluation of voltage surge in electrical power systems

The lattice diagram has been widely recognized and adopted to analyze the voltage surges produced at a particular location in an electrical system. These transient surges are caused by traveling waves induced by lightning strokes or switching operations. A lattice diagram can be used effectively, but the required computations are tedious. A simplified approach based on mathematical derivation is presented. The method will permit a quick evaluation of both initial and crest surge magnitudes as well as a wave shape that are all based on a given incoming surge and the surge impedances of the electrical elements involved. Sample calculations from the lattice diagram and the proposed quick evaluation are compared