A flow simulation for the epoxy casting process using a 3D finite‐element method

A three‐dimensional flow simulation for epoxy casting has been developed. A control‐volume‐based finite‐element method is employed, containing a conservative upwind formulation for the advection terms and equal order interpolations for all variables. This simulation predicts the non‐isothermal and reactive flow behavior under the gravity. The viscosity and reaction‐rate parameters were estimated by using a dynamic rheometer and a differential scanning calorimeter. The predicted flow front advancement and temperature profiles in the calculation domain similar to the mold cavity were in close agreement with the corresponding experimental results. The variation of epoxy surface configuration with flow rate also showed the same tendency between the prediction and the experiment. This simulation seems to be applicable not only to the epoxy casting, but also to other molding processes of various thermoset resins. POLYM. ENG. SCI. 45:364–374, 2005. © 2005 Society of Plastics Engineers.     

Oxidation of Fe (II) in sulfuric acid solutions with dissolved molecular oxygen

The oxidation of Fe(II) with dissolved molecular oxygen was studied in sulfuric acid solutions containing 0.2 mol . dm^-3 FeSO₄ at temperatures ranging from 343 to 363 K. In solutions of sulfuric acid above 0.4 mol . dm^-3, the oxidation of Fe (II) was found to proceed through two parallel paths. In one path the reaction rate was proportional to both [Fe²⁺]² and po₂, exhibiting an activation energy of 51.6 . kJ mol^-1. In another path the reaction rate was proportional to [Fe²⁺]², [SO_4-], and po₂ with an activation energy of 144.6 kJ . mol^-1. A reaction mechanism in which the SO_4- ions play an important role was proposed for the oxidation of Fe(II). In dilute solutions of sulfuric acid below 0.4 mol . dm^-3, the rate of the oxidation reaction was found to be proportional to both [Fe(II)]² and Po₂, and was also affected by [H⁺] and [SO_2- ⁴]. The decrease in [H⁺] resulted in the increase of reaction rate. The discussion was further extended to the effect of Fe (III) on the oxidation reaction of Fe (II).     

Quantitative evaluation of generator power control effect of FACTS controllers for power system stabilization

The advancement of power electronics technologies has significantly developed the power system stabilizing controllers. Quantitative as well as qualitative evaluation of their effectiveness in power systems is a matter of great importance for the feasibility investigation of these apparatus. In this paper, the possible control region of FACTS controllers with series and/or shunt configuration in a single machine to infinite bus system is formulated in the powerangle curve with a set of algebraic equations. The effectiveness of TCPST (Thyristor‐Controlled Phase Shifting Transformer), SSSC (Static Synchronous Series Compensator), and TCSC (Thyristor‐Controlled Series Compensator) for the improvement of the transient stability is evaluated quantitatively as a numerical example. The correctness of the proposed method has been confirmed by analysis based on the electromagnetic transients simulation with a detailed system model. © 2001 Scripta Technica, Electr Eng Jpn, 138(3): 43–51, 2002     

A Study of Shadowing on Indoor Visible-Light Wireless Communication Utilizing Plural White LED Lightings

White LED is considered as a strong candidate for the future lighting technology. We have proposed an optical wireless communication system that employs white LEDs for indoor wireless networks. In this system, LED is used not only as a lighting device, but also as a communication device. The transmitter has large optical power and large emission characteristics to function as lighting device. And the system has specific wireless channel impulse response differing from infrared wireless communication. In this paper, we discuss about shadowing effect on the system utilizing plural LED lightings including the performance of ISI based on the impulse response. We consider the downlink transmission based on TDMA and evaluate the shadowing effect caused by pedestrians with computer simulation. When the shadowing often occurs at 800 Mb/s, the performance of outage call duration rate and blocking rate are improved by using 3 LED lightings compared with 1 or 2 LED lightings. And, we show that the system with the optimal number of the LED lighting is robust against shadowing and can accommodate more calls. Toshihiko Komine was born in Shizuoka, Japan, on November 17, 1978. He received the B.E. and M.E. degrees in Information and Computer Science from Keio University, Yokohama, Japan, in 2001 and 2003 respectively. He is currently studying for the Ph.D. degree at Department of Information and Computer Science, Keio University. His current research interests are optical wireless communications and LED communications. Shinichiro Haruyama is a professor at Department of Information and Computer Science, Faculty of Science and Technology, Keio University, Yokohama, Japan. He received an M.S. in engineering science from University of California at Berkeley in 1983 and a Ph.D. in computer science from the University of Texas at Austin in 1990. He worked for Bell Laboratories of AT{&}T and Lucent Technologies, U.S.A from 1991 to 1996, and for Sony Computer Science Laboratories, Inc. from 1998 to 2002. His research interests include reconfigurable system, system design automation, wireless communication, and visible light communication. Masao Nakagawa was born in Tokyo, Japan in 1946. He received the B.E., M.E. and Ph.D. degrees in electrical engineering from Keio University, Yokohama, Japan, in 1969, 1971 and 1974 respectively. Since 1973, he has been with the Department of Electrical Engineering, Keio University, where he is now a Professor. His research interests are in CDMA, consumer Communications, Mobile communications, ITS (Intelligent Transport Systems), Wireless Home Networks, and Visible light Communication. He received 1989 IEEE Consumer Electronics Society Paper Award, 1999-Fall Best Paper Award in IEEE VTC, IEICE Achievement Award in 2000, IEICE Fellow Award in 2001. He was the executive committee chairman on International Symposium on Spread Spectrum Techniques and Applications in 1992 and the technical program committee chairman of ISITA (International Symposium on Spread Spectrum Techniques and Applications) in 1994. He is an editor of Wireless Personal Communications and was a guest editor of the special issues on “CDMA Networks I, II, III and IV” published in IEEE JSAC in 1994 (I and II) and 1996 (III and IV). He chairs the Wireless Home Link sub-committee in MMAC (Multimedia Mobile Access Communication Promotion Committee).     

Suppression of photo-induced dilation in cyanide treated hydrogenated amorphous silicon films

Effects of cyanide (CN) treatment with hydrogenated amorphous silicon (a-Si:H) films have been investigated. The decrease of ΔV/V was observed in cyanide treated a-Si:H films and the successive thermal annealing at 200°C after CN treatment induced the further reduction of the ΔV/V. XPS spectra show the indirect evidence that the cyanide species is present within 10 nm from the hydrogenated amorphous silicon surface. The results of CN treatment with a-Si:H solar cells are demonstrated.     

Planar AlGaAs/GaAs heterojunction bipolar transistors fabricatedusing selective W-CVD

The authors describe a planar process for the AlGaAs/GaAs HBTs in which collector vias are buried selectively, even to the base layers, with chemical vapor deposited tungsten (CVD-W) films. By using WF₆ /SiH₄ chemistry, W could be deposited on Pt films, which were overlapped 50 nm thick on the AuGe-based collector electrodes, without depositing W on the surrounding SiO₂ layers. Current gains of planar HBTs with 3.5-μm×3.5-μm emitters were up to 150, for a collector current density of about 2.5×10⁴ A/cm²     

Flexural properties of moldings of rigid polyurethane made by reaction injection molding

Flexural properties of moldings made by Reaction Injection Molding (RIM), which are structural foams consisting of high density skin and low density core, were investigated by three-point bending tests. Two failure modes were observed in bending tests of the moldings made by RIM, and they are classified as follows according to the density ratio of skin layer to core layer: the opposite side of the skin layer to which load was subjected failed by tensile stress: and the same side of the skin layer to which load was subjected failed by compressive stress, causing wrinkling or buckling. Then the conventional composite beam theory was applied to the former failure mode and Hoff s buckling theory to the latter, and equations were derived to predict the flexural properties of the structural foams, which involved buckling from the flexural properties of solid construction. In addition, it has been shown that there exists a density distribution that maximizes the flexural strength of the moldings made by RIM with a given overall density. The results obtained here should be useful to the optimum structural design of moldings made by RIM.     

Middle ear mucosa pathophysiology and healing processes in children with otitis media with effusion (OME)

Most otitis media with effusion (OME) in children heals spontaneously, but it is sometimes persistent and intractable. The major factors determining these different courses of OME are unknown. Identifying such factors would be clinically helpful. Factors affecting on the outcome of OME were studied experimentally and clinically. In animal experiment OME was induced in rabbit by occluding the Eustachian tube. Clinical study was conducted by investigating a histology of the middle ear mucosa, sampled from 64 children with OME (87 ears) who underwent middle ear tube ventilation. Furthermore, these cases studied how the degree of mastoid pneumatization before and after treatment, changes in the volume of the middle ear air cavity and the course after removal of the middle ear ventilation tube affected lesions in the middle ear mucosa. In animals, histology of the middle ear mucosa showed that in the early stages, the subepithelial layer of the middle ear mucosa was characterized by edematous hypertrophy and enlarged blood vessels. In later stages, it became fibrous as a result of chronic inflammation. These results suggest that lesions of the subepithelial layer are unlikely to recover. In clinical cases, histological changes in mucosal samples were rated on a two-point scale: changes in the epithelium and changes in the subepithelial layer. Re-pneumatization, a sign of healing of middle ear mucosal inflammation, was seen 12 months to 18 months after surgery. Among patients in whom the tube was left inserted for more than 18 months, only 11% had unfavorable outcomes and the recurrence rate was low. All patients who had recurrence of disease despite more than 18 months of tube insertion had prolonged inflammation in the middle ear mucosa. There results indicate that the air cavity returns to approximately normal degree of pneumatization more than 18 months after surgery, and that the extent of lesions in the middle ear mucosa, especially the subepithelial layer, is closely related to the healing of OME.