Multicanonical Monte Carlo Modeling of Wavelength Division Multiplexed Differential Phase Shift Keying Systems

Differential phase shift keying (DPSK) modulation is being considered as a possible candidate for future optical wavelength division multiplexed (WDM) transmission systems. In a single channel link, the balanced interferometric DPSK receiver exhibits increased tolerance against amplified spontaneous emitting (ASE) noise and fiber nonlinear effects. In this paper, a model is presented that can be used to estimate the performance of a multichannel DPSK system taking into account the influence of interchannel phenomena, namely cross-phase modulation (XPM) and four wave mixing (FWM), in the phase noise statistics. The model is based on an approximate solution of the fiber propagation equation and the multicanonical Monte Carlo (MCMC) method. It provides an efficient tool that can be used to investigate the influence of many link design parameters such as channel spacing, launch power, and fiber dispersion. The model is illustrated in the comparison of the performance of multichannel DPSK to on-off keying (OOK) systems. It is verified that, even in the presence of interchannel effects, DPSK modulation greatly enhances the system performance compared to OOK.     

Impact of Nonlinear LED Transfer Function on Discrete Multitone Modulation: Analytical Approach

Light-emitting diodes constitute a low-cost choice for optical transmitters in medium-bit-rate optical links. An example for the latter is local-area networks. However, one of the disadvantageous properties of light-emitting diodes is their nonlinear characteristic, which may limit the data transmission performance of the system, especially in the case of multiple subcarrier modulation, which is starting to attract attention in various applications, such as visible-light communications and data transmission over polymer optical fibers. In this paper, the influence of the nonlinear transfer function of the light-emitting diodes on discrete multitone modulation is studied. The transfer function describes the dependence of the emitted optical power on the driving current. Analytical expressions for an idealized link were derived, and these equations allow the estimation of the power of the noise-like, nonlinear crosstalk between the orthogonal subcarriers. The crosstalk components of the quadrature and in-phase subcarrier components were found to be independent and approximately normally distributed. Using these results, the influence of light-emitting-diode nonlinearity on the performance of the system was investigated. The main finding was that systems using a small number of subcarriers and/or high QAM level exhibit a large signal-to-noise-ratio penalty due to the nonlinear crosstalk. The model was applied to systems with white and resonant-cavity light-emitting diodes. It is shown that the nonlinearity may severely limit the performance of the system, particularly in the case of resonant-cavity light-emitting diodes, which exhibit a strong nonlinear behavior.     

Assessment of socio-techno-economic factors affecting the market adoption and evolution of 5G networks: Evidence from the 5G-PPP CHARISMA project

5G networks are rapidly becoming the means to accommodate the complex demands of vertical sectors. The European project CHARISMA is aiming to develop a hierarchical, distributed-intelligence 5G architecture, offering low latency, security, and open access as features intrinsic to its design. Finding its place in such a complex landscape consisting of heterogeneous technologies and devices, requires the designers of the CHARISMA and other similar 5G architectures, as well as other related market actors to take into account the multiple technical, economic and social aspects that will affect the deployment and the rate of adoption of 5G networks by the general public. In this paper, a roadmapping activity identifying the key technological and socio-economic issues is performed, so as to help ensure a smooth transition from the legacy to future 5G networks. Based on the fuzzy Analytical Hierarchy Process (AHP) method, a survey of pairwise comparisons has been conducted within the CHARISMA project by 5G technology and deployment experts, with several critical aspects identified and prioritized. The conclusions drawn are expected to be a valuable tool for decision and policy makers as well as for stakeholders.     

New techniques for the suppression of the four-wave mixing-induced distortion in nonzero dispersion fiber WDM systems

The performance of a wavelength-division multiplexing (WDM) optical network can be severely degraded due to fiber nonlinear effects. In the case where nonzero dispersion (NZD) fibers are employed, the four-wave mixing (FWM) effect sets an upper limit on the input power, especially in the case of narrow channel spacing. In order to reduce FWM-induced distortion two new techniques, the hybrid amplitude-/frequency-shift keying (ASK/FSK) modulation and the use of prechirped pulses are investigated. It is shown that both techniques can greatly improve the Q-factor in a 10 Gb/s WDM system. This happens even for very high input powers (/spl sim/10 dBm), where the degradation of the conventional WDM system is prohibitively high. The proposed methods are also applied and tested in higher bit rates (40 Gb/s). It is deduced that although the hybrid ASK/FSK modulation technique marginally improves the system performance, the optical prechirp technique can still be used to greatly increase the maximum allowable input power of the system.     

Evaluation by Monte Carlo simulations of the power limits and bit-error rate degradation in wavelength-division multiplexing networks caused by four-wave mixing

Fiber nonlinearities can degrade the performance of a wavelength-division multiplexing optical network. For high input power, a low chromatic dispersion coefficient, or low channel spacing, the most severe penalties are due to four-wave mixing (FWM). To compute the bit-error rate that is due to FWM noise, one must evaluate accurately the probability-density functions (pdf) of both the space and the mark states. An accurate evaluation of the pdf of the FWM noise in the space state is given, for the first time to the authors' knowledge, by use of Monte Carlo simulations. Additionally, it is shown that the pdf in the mark state is not symmetric as had been assumed in previous studies. Diagrams are presented that permit estimation of the pdf, given the number of channels in the system. The accuracy of the previous models is also investigated, and finally the results of this study are used to estimate the power limits of a wavelength-division multiplexing system.     

Modeling gender evolution and gap in science and technology using ecological dynamics

In this paper a model based on population biology is proposed in order to investigate the evolution of human resources (men and women) in science and technology as a share of labor market as well as the dynamics of their gap. An analytical and a simulation method using the Artificial Bee Colony optimization algorithm are described and used for the determination of the proposed model parameters. The presented model is applied to three case studies; Greece, Portugal and Europe-27.³ The accuracy of the obtained results is confirmed through comparison with actual data. In addition, the model can also be used to accurately forecast future trends. It is illustrated that the gender gap is continuously decreasing, while in the last years, women seem to outperform men in the field of science and technology. The estimation and forecasting ability of the model can be used as an extremely valuable tool for decision and policy makers.     

Optical Delay Lines Based on Soliton Propagation in Photonic Crystal Coupled Resonator Optical Waveguides

In this paper, a study of optical delay lines based on soliton propagation in coupled resonator optical waveguides is performed. For a given bit rate and required delay, design equations are given that relate the soliton peak power and collision period to the soliton width. To study the influence of higher order linear and nonlinear dispersion, a continuous wave propagation model incorporating these effects is also derived. Using this model, the soliton stability in the presence of higher order dispersion, optical loss and adjacent soliton pulses is numerically verified. It is also shown that soliton-based delay lines can achieve nanosecond delay at a propagation length of a few millimeters due to the high slow down factors that can be obtained.