Proton-Detected Solid-State NMR of the Cell-Free Synthesized α-Helical Transmembrane Protein NS4B from Hepatitis C Virus

Proton-detected 100 kHz magic-angle-spinning (MAS) solid-state NMR is an emerging analysis method for proteins with only hundreds of microgram quantities, and thus allows structural investigation of eukaryotic membrane proteins. This is the case for the cell-free synthesized hepatitis C virus (HCV) nonstructural membrane protein 4B (NS4B). We demonstrate NS4B sample optimization using fast reconstitution schemes that enable lipid-environment screening directly by NMR. 2D spectra and relaxation properties guide the choice of the best sample preparation to record 2D ¹H-detected ¹H,¹⁵N and 3D ¹H,¹³C,¹⁵N correlation experiments with linewidths and sensitivity suitable to initiate sequential assignments. Amino-acid-selectively labeled NS4B can be readily obtained using cell-free synthesis, opening the door to combinatorial labeling approaches which should enable structural studies.     

Tracking the mind during reading: The influence of past, present, and future words on fixation durations.

Reading requires the orchestration of visual, attentional, language-related, and oculomotor processing constraints. This study replicates previous effects of frequency, predictability, and length of fixated words on fixation durations in natural reading and demonstrates new effects of these variables related to 144 sentences. Such evidence for distributed processing of words across fixation durations challenges psycholinguistic immediacy-of-processing and eye-mind assumptions. Most of the time the mind processes several words in parallel at different perceptual and cognitive levels. Eye movements can help to unravel these processes. (PsycINFO Database Record (c) 2010 APA, all rights reserved)     

Analysis of the Survivability of GaN Low-Noise Amplifiers

This paper presents a detailed analysis of the stressing mechanisms for highly rugged low-noise GaN monolithic-microwave integrated-circuit amplifiers operated at extremely high input powers. As an example, a low-noise amplifier (LNA) operating in the 3-7-GHz frequency band is used. A noise figure (NF) below 2.3 dB is measured from 3.5 to 7 GHz with NF<1.8 dB between 5-7 GHz. This device survived 33 dBm of available RF input power for 16 h without any change in low-noise performance. The stress mechanisms at high input powers are identified by systematic measurements of an LNA and a single high electron-mobility transistor in the frequency and time domains. It is shown that the gate dc current, which occurs due to self-biasing, is the most critical factor regarding survivability. A series resistance in the gate dc feed can reduce this gate current by feedback, and may be used to improve LNA ruggedness     

Trypsin inhibitor activity of soybean as affected by genotype and fertilisation

The presence of protease inhibitors in soybean prohibits the utilisation of the raw beans for food and feed. However, little information is available about environmental influences and the effects of nitrogen and sulphur supply on the antinutritional constituents of soybean. As these factors may influence protease inhibitors, soybean genotypes segregated according to the presence or absence of the Kunitz trypsin inhibitor have been evaluated for trypsin inhibitor activity (TIA) in field trials. TIA was affected significantly by environment (geographical location), fertilisation treatment and genotype. Environmental means of TIA were between 69.5 and 104.8 mg g^?1. Nitrogen application, which caused an increase in seed protein content, resulted in a reduction in TIA by about 15% as compared with the control. Remarkably, simultaneous application of nitrogen and sulphur in the form of ammonium sulphate had a similar reductive effect on TIA to that of nitrogen application alone, although soybean protease inhibitors are rich in sulphur amino acids. Significant genetic variation in TIA was found both within the genotype class with the Kunitz inhibitor present as well as within the class lacking this inhibitor. The results suggest that TIA of soybean may be modified considerably by genetic improvement and appropriate agronomic management. Copyright © 2003 Society of Chemical Industry     

Case Study of an Aerosol Explosion and a Method to Determine Explosion Temperatures

A failure analysis case study is presented for a two-piece aerosol containing tetrafluoroethane, commonly referred to as Refrigerant 134a. A gentleman was preparing to recharge the air conditioning system of an automobile when the bottom exploded off the aerosol container, propelling the body of the aerosol container like a rocket, which hit the man in the eye and blinded him in that eye. The aerosol was never connected to the air conditioner, therefore backpressure from the air conditioner (AC) compressor was ruled out as a cause for the explosion. The objective of the study was to determine why the aerosol exploded. Several recently developed test methods were used, including two types of heat-to-burst tests and a puncture chamber to measure the pressure-versus-temperature behavior of aerosols. More common test methods were also used, such as water bath pressure tests, hydro pressure burst tests, pneumatic pressure burst tests, hardness measurements, weight measurements, metallography, scanning electron microscopy (SEM), energy-dispersive spectroscopy (EDS), and an accident scenario recreation. A semi-empirical correlation between the hardness and weights of the container bottoms was used to determine the explosion temperature and/or pressure. This semi-empirical correlation agrees in principle with an analysis of the explosion pressures using finite-element analysis (FEA). The root cause for the explosion was determined to be a lack of strength of the bottom of the two-piece aerosol coupled with heating the aerosol to temperatures significantly above room temperature.     

Adaptive generation of surfaces in volume data

A widespread approach to generating polygonal approximations of iso-surfaces or contour surfaces in volume data is the socalled marching-cubes algorithm. This algorithm, however, has the disadvantage that the number of polygonal chains generated is considerable. The splitting-box algorithm presented here reduces the number of polygonal chains by adapting their size to the shape of the surface. The resulting polygonal chains offer a wide spectrum for representing the contour surface. An exact representation is achieved by a new type of generic patches calculated from the polygonal chains. Approximations of different quality may be obtained by combining the algorithm generating the patches with simple triangulations.