Role of Co in formation of Ni-Ti clusters in maraging stainless steel

The effect of Co addition on the formation of Ni-Ti clusters in maraging stainless steel was studied by three dimensional atom probe (3DAP) and first-principles calculation. The cluster analysis based on the maximum separation approach showed an increase in size but a decrease in density of Ni-Ti clusters with increasing the Co content. The first-principles calculation indicated weaker Co-Ni (Co-Ti) interactions than Co-Ti (Fe-Ti) interactions, which should be the essential reason for the change of distribution characteristics of Ni-Ti clusters in bcc Fe caused by Co addition.     

Evaporated Thin Films of CdS and CdTe: Optimization for Photovoltaic Applications

Thin films of cadmium sulphide and cadmium telluride have been prepared by thermal evaporation under various conditions of deposition. These films have been characterized optically. electrically and for structure determination. The results of these characterizations along with the initial results of all thin film CdS/CdTe solar cells are presented in this paper     

Influence of ferrite-martensite microstructural morphology on tensile properties of dual-phase steel

The influence of ferrite-martensite microstructural morphology, volume fraction of martensite, epitaxial ferrite on the tensile behaviour of dual-phase steels, was studied. It was observed that increasing the martensite content and its aspect ratio raised tensile strength and ductility. Epitaxial ferrite in rolled material strongly reduced the strength and improved the ductility, suggesting that substructure strengthening of material, as well as increased stress transfer to the hard phase, contribute to the strength of thermo-mechanically processed material. Mettallographic analysis of deformed samples revealed that void nucleation occurs predominantly along the ferrite-martensite interface. The void density in the necked region increased towards the fracture surface in all samples and was higher for samples which exhibited localized necking.     

Energy-efficient clustering in mobile ad-hoc networks using multi-objective particle swarm optimization

A mobile ad hoc network (MANET) is dynamic in nature and is composed of wirelessly connected nodes that perform hop-by-hop routing without the help of any fixed infrastructure. One of the important requirements of a MANET is the efficiency of energy, which increases the lifetime of the network. Several techniques have been proposed by researchers to achieve this goal and one of them is clustering in MANETs that can help in providing an energy-efficient solution. Clustering involves the selection of cluster-heads (CHs) for each cluster and fewer CHs result in greater energy efficiency as these nodes drain more power than noncluster-heads. In the literature, several techniques are available for clustering by using optimization and evolutionary techniques that provide a single solution at a time. In this paper, we propose a multi-objective solution by using multi-objective particle swarm optimization (MOPSO) algorithm to optimize the number of clusters in an ad hoc network as well as energy dissipation in nodes in order to provide an energy-efficient solution and reduce the network traffic. In the proposed solution, inter-cluster and intra-cluster traffic is managed by the cluster-heads. The proposed algorithm takes into consideration the degree of nodes, transmission power, and battery power consumption of the mobile nodes. The main advantage of this method is that it provides a set of solutions at a time. These solutions are achieved through optimal Pareto front. We compare the results of the proposed approach with two other well-known clustering techniques; WCA and CLPSO-based clustering by using different performance metrics. We perform extensive simulations to show that the proposed approach is an effective approach for clustering in mobile ad hoc networks environment and performs better than the other two approaches.     

Influence of sources of dietary oils on the life span of stroke-prone spontaneously hypertensive rats

In recent studies, the life span of stroke-prone spontaneously hypertensive (SHRSP) rats was altered by a variety of dietary fats. It was relatively shorter in rats fed canola oil as the sole source of fat. The present study was performed to find out whether the fatty acid profile and the high content of sulfur compounds in canola oil could modulate the life span of SHRSP rats. SHRSP rats (47 d old, n=23/group) were matched by body weight and systolic blood pressure and fed semipurified diets containing 10% canola oil, high-palmitic canola oil, low-sulfur canola oil, soybean oil, high-oleic safflower oil, a fat blend that mimicked the fatty acid composition of canola oil, or a fat blend high in saturated fatty acids. A 1% sodium chloride solution was used as drinking water to induce hypertension. After consuming the diets for 37 d, five rats from each dietary group were killed for collection of blood and tissue samples for biochemical analysis. The 18 remaining animals from each group were used for determining their life span. The mean survival time of SHRSP rats fed canola oil (87.4±4.0 d) was not significantly different (P>0.05) from those fed low-sulfur canola oil (89.7±8.5 d), suggesting that content of sulfur in canola oil has no effect on the life span of SHRSP rats. The SHRSP rats fed the noncanola oil-based diets lived longer (mean survival time difference was 6–13 d, P<0.05) than those fed canola and low-sulfur canola oils. No marked differences in the survival times were observed among the noncanola oil-based groups. The fatty acid composition of the dietary oils and of red blood cells and liver of SHRSP rats killed after 37 d of treatment showed no relationship with the survival times. These results suggest that the fatty acid profile of vegetable oils plays no important role on the life span of SHRSP rat. However, phytosterols in the dietary oils and in liver and brain were inversely correlated with the mean survival times, indicating that the differential effects of vegetable oils might be ascribed, at least partly, to their different phytosterol contents.     

Fuzzy decision support system for fertilizer

Fuzzy geographic information systems is a newly emerging field of computational intelligence. It combines fuzzy logic with spatial context. Most of the natural phenomena are fuzzy in nature. They show a degree of uncertainty or vagueness in their extent and attribute, which cannot be expressed by a crisp value. Agriculture is one of the fields of the spatial domain that needs to be described in fuzzy terms. Fertilizer is a key input for the agriculture sector. In this article, the spatial surfaces of fertilizers are developed for the wheat crop using a fuzzy decision support system. The algorithm of our system takes soil nutrients and cropping time as input, applies fuzzy logic on the input values, defuzzifies the fuzzy output to crisp value, and generates a fertilizer surface. The resultant output surface of fertilizer describes the amount of fertilizer needed to cultivate a specific crop in a specified area. The complexity of our algorithm is \(O(mnr)\) , where \(m\) is the height of the raster, \(n\) is the width of the raster, and \(r\) is the number of expert rules.     

High aspect ratio gold nanopillars on microelectrodes for neural interfaces

Microelectrode arrays (MEA) have become an established tool in applied and fundamental research. Low impedance at the interface between tissue and conducting electrodes is of utmost importance for the electrical recording or stimulation of electrophysiological active cells such as cardiac myocytes and neurons. A common way to improve this interface is to increase the electrochemically active surface area of the electrode. In this paper the fabrication of microelectrodes covered with very high aspect ratio (AR > 100) gold nanopillars is presented and electrode biocompatibility is investigated using cell culture experiments. The nanopillar electrodes show decreased impedance over the entire scanned frequency range of 1 Hz–100 kHz and an impedance improvement of up to 89.5 at 1 kHz depending on nanopillar height. Neurons adhere well to the substrate and electrodes and signals with amplitudes up to ten times higher than with conventional gold electrodes were recorded in cell culture experiments.     

An architecture modeling framework for probabilistic prediction

In the design phase of business and IT system development, it is desirable to predict the properties of the system-to-be. A number of formalisms to assess qualities such as performance, reliability and security have therefore previously been proposed. However, existing prediction systems do not allow the modeler to express uncertainty with respect to the design of the considered system. Yet, in contemporary business, the high rate of change in the environment leads to uncertainties about present and future characteristics of the system, so significant that ignoring them becomes problematic. In this paper, we propose a formalism, the Predictive, Probabilistic Architecture Modeling Framework (P²AMF), capable of advanced and probabilistically sound reasoning about business and IT architecture models, given in the form of Unified Modeling Language class and object diagrams. The proposed formalism is based on the Object Constraint Language (OCL). To OCL, P²AMF adds a probabilistic inference mechanism. The paper introduces P²AMF, describes its use for system property prediction and assessment and proposes an algorithm for probabilistic inference.     

Enhanced halftone-based secure and improved visual cryptography scheme for colour/binary Images

Visual Cryptography (VC) is gaining attraction during the past few years to secure the visual information in the transmission network. It enables the visual data i.e. handwritten notes, photos, printed text, etc. to encrypt in such a way that their decryption can be done through the human visual framework. Hence, no computational assistance is required for the decryption of the secret images they can be seen through naked eye. In this paper, a novel enhanced halftoning-based VC scheme is proposed that works for both binary and color images. Fake share is generated by the combination of random black and white pixels. The proposed algorithm consists of 3 stages i.e., detection, encryption, and decryption. Halftoning, Encryption, (2, 2) visual cryptography and the novel idea of fake share, make it even more secure and improved. As a result, it facilitates the original restored image to the authentic user, however, the one who enters the wrong password gets the combination of fake share with any real share. Both colored and black images can be processed with minimal capacity using the proposed scheme.

     

Privacy Preserving Geo-Linkage in the Big Urban Data Era

Big data technologies and a range of Government open data initiatives provide the basis for discovering new insights into cities; how they are planned, how they managed and the day-to-day challenges they face in health, transport and changing population profiles. The Australian Urban Research Infrastructure Network (AURIN – www.aurin.org.au) project is one example of such a big data initiative that is currently running across Australia. AURIN provides a single gateway providing online (live) programmatic access to over 2000 data sets from over 70 major and typically definitive data-driven organizations across federal and State government, across industry and across academia. However whilst open (public) data is useful to bring data-driven intelligence to cities, more often than not, it is the data that is not-publicly accessible that is essential to understand city challenges and needs. Such sensitive (unit-level) data has unique requirements on access and usage to meet the privacy and confidentiality demands of the associated organizations. In this paper we highlight a novel geo-privacy supporting solution implemented as part of the AURIN project that provides seamless and secure access to individual (unit-level) data from the Department of Health in Victoria. We illustrate this solution across a range of typical city challenges in localized contexts around Melbourne. We show how unit level data can be combined with other data in a privacy-protecting manner. Unlike other secure data access and usage solutions that have been developed/deployed, the AURIN solution allows any researcher to access and use the data in a manner that meets all of the associated privacy and confidentiality concerns, without obliging them to obtain ethical approval or any other hurdles that are normally put in place on access to and use of sensitive data. This provides a paradigm shift in secure access to sensitive data with geospatial content.