Long-term sensor measurements of lung deposited surface area of particulate matter emitted from local vehicular and residential wood combustion sources

Abstract

Lung deposited surface area (LDSA) is a relatively new metric that has been argued to be more accurate at predicting health effects from aerosol exposure. For typical atmospheric aerosol, the LDSA concentration depends mainly on the concentration of ultrafine particles (e.g. vehicular exhaust emissions and residential wood combustion) and therefore optical methods cannot be used to measure and quantify it. The objective of this study was to investigate and describe typical characteristics of LDSA under different urban environments and evaluate how a diffusion charging-based Pegasor AQ Urban sensor (Pegasor Ltd., Finland) can be used as an alternative to optical sensors when assessing local combustion emissions and respective LDSA concentrations. Long-term (12?months) sensor measurements of LDSA were carried out at three distinctly different measurement sites (four sensor nodes) in the Helsinki metropolitan area, Finland. The sites were affected mainly by vehicular exhaust emission (street canyon and urban background stations) and by residential wood combustion (two detached housing area stations). The results showed that the accuracy of the AQ Urban was good (R² = 0.90) for the measurement of LDSA when compared to differential mobility particle sizer. The mean concentrations of LDSA were more than twice as high at the street canyon (mean 22 µm² cm^?3) site when compared to the urban background site (mean 9.4 µm² cm^?3). In the detached housing area, the mean concentrations were 12 µm² cm^?3, and wood combustion typically caused high LDSA peaks in the evenings. High correlations and similar diurnal cycles were observed for the LDSA and black carbon at street canyon and urban background stations. The utilization of a small-scale sensor network (four nodes) showed that the cross-station variability in hourly LDSA concentrations was significant in every site, even within the same detached housing area (distance between the two sites ～670?m).     

Bio-derived fuels may ease the regeneration of diesel particulate traps

Particulate is the most problematic emission from diesel engines. To comply with environmental regulations, these engines are often equipped with particulate traps, which must be regenerated frequently for the sake of efficiency. The regeneration is commonly achieved by rising the temperature in the trap till the particulate self-ignites. However, this method implies energy losses and thermal shocks in the trap. Alternatively, catalysts and additives have been recently considered for reducing the ignition temperature of particulate, but these techniques suffer from poisoning and undesirable byproducts. The present experimental study shows that the ignition temperature of particulate from seed-derived oils (SO) and from blends of SO with diesel fuel oil (DO) can be lower than that of particulate from neat DO. If substantiated by more extensive studies, such finding could have noteworthy implications on the future of fuels and traps.     

Is the development of adenoma and carcinoma in proximal colon related to apolipoprotein E phenotype?

BACKGROUND & AIMS: Alterations in plasma lipoprotein levels and bile acid metabolism observed in patients with colorectal adenoma and carcinoma may reflect a genetic background predisposing to altered lipid metabolism and tumors. This study was designed to determine whether the polymorphism of apolipoprotein E, one of the key regulatory proteins in cholesterol metabolism, is associated with proximal or distal colonic neoplasia. METHODS: Apolipoprotein E phenotype was determined in 135 patients with colorectal adenoma, 122 patients with colorectal carcinoma, and 199 randomly selected control subjects. RESULTS: The frequency of the epsilon 4 allele of apolipoprotein E was low (0.075 and 0.073) in patients with proximal adenoma and those with carcinoma, respectively, compared with the control subjects (0.181) (P < 0.05). In patients with distal tumors, there was no alteration in epsilon 4 frequency. In all subjects with the epsilon 4 allele compared with subjects without epsilon 4, the odds ratio for proximal adenoma was 0.36 (95% confidence interval, 0.14-0.89), and the odds ratio for proximal carcinoma was 0.35 (95% confidence interval, 0.14-0.86). CONCLUSIONS: The data suggest that the epsilon 4 allele of apolipoprotein E provides protection from the development of adenoma and carcinoma of the proximal colon. These results support the theory that there are common susceptibility genes modulating the susceptibility to external carcinogenic factors.     

Out-of-Field Hippocampus from Partial-Body Irradiated Mice Displays Changes in Multi-Omics Profile and Defects in Neurogenesis

The brain undergoes ionizing radiation exposure in many clinical situations, particularly during radiotherapy for brain tumors. The critical role of the hippocampus in the pathogenesis of radiation-induced neurocognitive dysfunction is well recognized. The goal of this study is to test the potential contribution of non-targeted effects in the detrimental response of the hippocampus to irradiation and to elucidate the mechanisms involved. C57Bl/6 mice were whole body (WBI) or partial body (PBI) irradiated with 0.1 or 2.0 Gy of X-rays or sham irradiated. PBI consisted of the exposure of the lower third of the mouse body, whilst the upper two thirds were shielded. Hippocampi were collected 15 days or 6 months post-irradiation and a multi-omics approach was adopted to assess the molecular changes in non-coding RNAs, proteins and metabolic levels, as well as histological changes in the rate of hippocampal neurogenesis. Notably, at 2.0 Gy the pattern of early molecular and histopathological changes induced in the hippocampus at 15 days following PBI were similar in quality and quantity to the effects induced by WBI, thus providing a proof of principle of the existence of out-of-target radiation response in the hippocampus of conventional mice. We detected major alterations in DAG/IP3 and TGF-β signaling pathways as well as in the expression of proteins involved in the regulation of long-term neuronal synaptic plasticity and synapse organization, coupled with defects in neural stem cells self-renewal in the hippocampal dentate gyrus. However, compared to the persistence of the WBI effects, most of the PBI effects were only transient and tended to decrease at 6 months post-irradiation, indicating important mechanistic difference. On the contrary, at low dose we identified a progressive accumulation of molecular defects that tended to manifest at later post-irradiation times. These data, indicating that both targeted and non-targeted radiation effects might contribute to the pathogenesis of hippocampal radiation-damage, have general implications for human health.     

Hydrogenation of Citral Over a Polymer Fibre Catalyst

A polymer-supported Pd catalyst was investigated in hydrogenation of citral (3,7-dimethyl-2,6-octadienal), which is a stereoisomer with an isolated and a conjugated double bond as well as a carbonyl group. The catalyst was a fibrous polymer-supported catalyst modified with functional groups and immobilized metals. A comparison of the polymer-supported catalyst with conventional catalysts was made.     

Reaction engineering studies in a polytropic fixed-bed reactor over a highly active and selective catalyst for oxidative methane coupling

The oxidative coupling of methane (OCM) was carried out in a polytropic fixed-bed reactor applying a Zr/La/Sr catalyst developed by the Neste company. Over this catalyst the OCM reaction follows a complex reaction scheme which includes primary parallel reaction steps to CO, CO₂ and C₂H₆ and consecutive reactions of ethane to ethylene or CO_x. Yield of higher hydrocarbons C₂₊ obtained with this catalyst strongly depended on reaction conditions, i.e. low partial pressures of methane and oxygen obtained by diluting the feed gas with nitrogen and high reaction temperatures promoted C₂₊ selectivity and yield. The maximum yield amounted to 21.4% (20 Vol.-% CH₄, 9 Vol.-% O₂, 71 Vol.-% N₂, T = 860°C; X_CH4 = 41.8%, S = 52.5%). This result belongs to the highest yields reported in the open literature.     

A new failure criterion for the Gurson-Tvergaard dilational constitutive model

In the Gurson-Tvergaard model a failure criterion has to be used to signify the void coalescence. In the literature, a constant critical void volume fraction criterion has been widely used. However, it is questionable whether the critical void volume fraction is a material constant and, furthermore, it is also difficult in practice to determine the constant. By modifying Thomason's plastic limit-load model, a new failure criterion which is fully compatible with the Gurson-Tvergaard model, is presented in this study. In the present criterion, the void coalescence failure mechanism by internal necking has been considered and the material failure is a natural result of the development of dual constitutive, stable and unstable, responses. In practical application of the present criterion, no critical void volume fraction needs to be pre-determined either numerically or experimentally. Furthermore, according to the new criterion, the void volume fraction corresponding to void coalescence is not a material constant, rather a function of stress triaxiality. The predictions using the present criterion have been compared with the finite element results by Koplik and Needleman, and very good agreement is observed. The potential advantage of this criterion and other related issues are discussed.     

Physical Violence Detection Based on Distributed Surveillance Cameras

Mobile Networks and Applications - In recent years, physical violence detection has become a research hotspot in the area of human activity recognition. With the improvement and full coverage of...     

Animating with style: defining expressive semantics of motion

Actions performed by a virtual character can be controlled with verbal commands such as ‘walk five steps forward’. Similar control of the motion style, meaning how the actions are performed, is complicated by the ambiguity of describing individual motions with phrases such as ‘aggressive walking’. In this paper, we present a method for controlling motion style with relative commands such as ‘do the same, but more sadly’. Based on acted example motions, comparative annotations, and a set of calculated motion features, relative styles can be defined as vectors in the feature space. We present a new method for creating these style vectors by finding out which features are essential for a style to be perceived and eliminating those that show only incidental correlations with the style. We show with a user study that our feature selection procedure is more accurate than earlier methods for creating style vectors, and that the style definitions generalize across different actors and annotators. We also present a tool enabling interactive control of parametric motion synthesis by verbal commands. As the control method is independent from the generation of motion, it can be applied to virtually any parametric synthesis method.