Localized corrosion of (lean) duplex stainless steels in immersion units of urban wastewater treatment plants

With lower alloying cost and higher mechanical properties, lean duplex stainless steels can be an alternative to the more commonly used austenitic stainless steels. However, these alloys are still not the preferred choice, probably due to a lack of field experience. A study was thus initiated in view of defining the limits of use of selected (lean) duplexes for urban wastewater treatment units. The present paper shows the localized corrosion performance of selected lean duplexes in chloride contaminated solutions. The results are compared with austenitic S30403 and S31603 and with the more standard duplexes S82441 and S32205. The effect of welding was also investigated. Exposures in field municipal wastewater plants were conducted for 1 year in low and high chloride content units. The results show that lean duplexes S32101 and S32202 can be used as alternatives to S30403 and S31603 in low chloride electrolytes. At 500 ppm of chloride content, duplex stainless steel S32304 showed better corrosion resistance than S30403 and S31603. For higher chloride contents (1000 ppm and above) the standard duplexes S82441 and S32205 shall be preferred.     

Potential influence of microorganisms on the corrosion of carbon steel in the French high- and intermediate-level long-lived radioactive waste disposal context

In the context of the high-level radioactive waste disposal CIGEO, the corrosion rate due to microbially influenced corrosion (MIC) has to be evaluated. In France, it is envisaged to dispose of high- and intermediate-level long-lived radioactive waste at a depth of 500 m in a deep geological disposal, drilled in the Callovo-Oxfordian claystone (Cox) formation. To do so, a carbon steel casing will be inserted inside disposal cells, which are horizontal tunnels drilled in the Cox. A specific cement grout will be injected between the carbon steel casing and the claystone. A study was conducted to evaluate the possibility of MIC on carbon steel in the foreseeable high radioactive waste disposal. The corrosiveness of various environments was investigated at 50°C and 80°C with or without microorganisms enriched from samples of Andra's underground research laboratory. The monitoring of corrosion during the experiments was ensured using gravimetric method and real-time corrosion monitoring using sensors based on the measurements of the electrical resistance. The corrosion data were completed with microbiological analyses including cultural and molecular characterizations.     

Analysis of the Single-Crystalline Silicon Photovoltaic (PV) Module Performances Under Low γ - Radiation from Radioactive Source

The present paper is about an experimental evaluation of the terrestrial silicon single-crystalline solar PV module behavior under low gamma radiation. The     

Corrosion of hot-dip-galvanised steel and zinc alloy-coated steel in ammonia and ammonium chloride

There are many potential causes of corrosion in animal buildings. Animals exhale large quantities of moisture into the air creating high relative humidity in the building if the moisture is not properly vented. High humidity increases the potential for condensation. In addition, ammonia may be found in large quantities in animal buildings. Ammonia is released from manure and urine. In addition, ammonium chloride is used as a nitrogen source in fertilisers. In this study, the atmospheric corrosion of hot-dip-galvanised steel and zinc alloy-coated steel such as zinc–aluminium and zinc–aluminium–magnesium has been studied in atmospheres containing different levels of ammonia. Investigations have also been conducted at different levels of ammonium chloride. The results are discussed in view of the mechanisms of corrosion of zinc and zinc alloy-coated steel in ammonia and ammonium chloride-containing environments.     

Design of an antibacterial gelatin based on a covalent protein–protein coupling

An antibacterial peptide (AMP), i.e., nisin, was covalently bound to gelatin through a protein–protein coupling. Various reaction conditions were tested to study and optimize parameters of grafting e.g., orientation and density of AMP, which could impact the final antibacterial activity of the modified biopolymer. Modification was investigated by Fourier transform infrared (FT‐IR) spectroscopy and zeta potential. The antibacterial activity of the nisin‐enriched gelatin was evaluated against two staphylococci bacterial strains, i.e., Staphylococus epidermidis and Staphylococcus aureus. A higher activity was found for gelatin modified at pH = 7.4 revealing an influence of the nisin orientation on the protein antibacterial property. © 2014 Wiley Periodicals, Inc. J. Appl. Polym. Sci. 2015 , 132, 41825.     

Cyanogenic,carotenoids and protein composition in leaves and roots across seven diverse population found in the world cassava germplasm collection at CIAT,Colombia

The objective of this study was to characterise the nutritional potential of leaves and identify a diversity centre with low cyanide and high nutrient content among 178 Latin American cassava genotypes. This field-based collection represents the seven diversity centres, held at The International Center for Tropical Agriculture (CIAT Palmira, Colombia) by the Cassava Program. The cyanide, all-trans-β-carotene and lutein concentrations in cassava leaves ranged from 346 to 7484 ppm dry basis (db), from 174–547 μg g⁻¹ db and 15–181 μg g⁻¹ db, respectively. Cassava leaves also showed significant levels of essential amino acids leucine, lysine, phenylalanine, valine and threonine, and average total protein content of 26.24 g 100 g⁻¹ db. Among seven diversity centres, South American rainforest group showed low cyanide and high carotene content in leaves. In addition, VEN77 and PAN51 genotypes stood out for having low cyanide in leaves and roots and high carotene in leaves. This genetic diversity can be used to select high potential progenitors for breeding purposes.     

Study of a BGO calorimeter using electron and hadron beams from 1 to 50 GeV

A calorimeter of 25 bismuth germanate (BGO) crystals equipped with silicon photodiode readout has been tested at the CERN SPS in the energy range 1–50 GeV. The response for electrons has been shown to be linear in this energy range and the rms resolution obtained ( ) is approximately 1%, for E > 4 GeV. The electron/pion separation was found to be better than 1:500 in the energy range 1–20 GeV. Data on lateral and longitudinal shower development were compared with the results of a Monte Carlo simulation using the SLAC-EGS program and found to be in good agreement.     

Some approximate Godunov schemes to compute shallow-water equations with topography

We study here the computation of shallow-water equations with topography by Finite Volume methods, in a one-dimensional framework (though all methods introduced may be naturally extended in two dimensions). All methods are based on a discretisation of the topography by a piecewise function constant on each cell of the mesh, from an original idea of Le Roux et al. Whereas the Well-Balanced scheme of Le Roux is based on the exact resolution of each Riemann problem, we consider here approximate Riemann solvers. Several single step methods are derived from this formalism, and numerical results are compared to a fractional step method. Some test cases are presented: convergence towards steady states in subcritical and supercritical configurations, occurrence of dry area by a drain over a bump and occurrence of vacuum by a double rarefaction wave over a step. Numerical schemes, combined with an appropriate high-order extension, provide accurate and convergent approximations.     

In vivo clonal expression of T lymphocytes specific for an immunodominant N-terminal myelin basic protein epitope in healthy individuals

The role of myelin basic protein (MBP) T cell recognition in the induction of experimental allergic encephalomyelitis (EAE) has been well established in mice and rats. A remarkable restriction has been observed in T cell receptor (TCR) genes utilized by encephalitogenic T cell lines (TCLs) specific for immunodominant epitopes in these species. Pathological similarities between this animal model and multiple sclerosis (MS) has led to consider MBP as a major candidate autoantigen in this human disorder. Unlike in inbred strains of animals, the T cell response to MBP in humans is quite heterogenous with regard to fine epitope specificity. The existence of V alpha and/or V beta restriction in MBP-specific T cells, from MS patients and healthy controls, is still a matter of debate. In this study we generated 77 MBP-specific TCLs from nine healthy donors and showed that peptide 7-27 is one of the most frequently recognized epitopes. 37% of all epitope-specific TCLs recognized this peptide and p7-27 specific TCLs were generated from seven out of the nine subjects studied. A high level of in vivo clonal expansion was observed in p7-27-specific TCLs in several subjects, which however is not specific of this epitope since this phenomenon was also observed in p85-104- and 149-162-specific TCLs.     

Integrated Personal Mobility Architecture: A Complete Personal Mobility Solution

The high expectations and demand for users to access the Internet from anywhere at anytime has made user mobility an important part of the design and development of the next generation mobile communications and computing. Traditionally user mobility has been divided into two areas: Terminal Mobility and Personal Mobility. In recent years terminal mobility has focused on the movement of the terminal and developed extensions to IP protocols such as Mobile IP. In contrast, personal mobility has only received limited attention, and is somewhat lagging behind. This research has either focussed on personal mobility in communications or personalisation of operating environments. As a result, to date no framework for providing true personal mobility has emerged. In this paper, we introduce a new personal mobility framework called IPMoA (Integrated Personal Mobility Architecture), which integrates both aspects of personal mobility to provide a complete personal mobility solution, and illustrate the viability of this approach through a proof-of-concept implementation.