Effects of SO2 on selective catalytic reduction of NO with NH3 over a TiO2 photocatalyst

The effect of SO₂ gas was investigated on the activity of the photo-assisted selective catalytic reduction of nitrogen monoxide (NO) with ammonia (NH₃) over a TiO₂ photocatalyst in the presence of excess oxygen (photo-SCR). The introduction of SO₂ (300 ppm) greatly decreased the activity of the photo-SCR at 373 K. The increment of the reaction temperature enhanced the resistance to SO₂ gas, and at 553 K the conversion of NO was stable for at least 300 min of the reaction. X-ray diffraction, FTIR spectroscopy, thermogravimetry and differential thermal analysis, x-ray photoelectron spectroscopy (XPS), elemental analysis and N₂ adsorption measurement revealed that the ammonium sulfate species were generated after the reaction. There was a strong negative correlation between the deposition amount of the ammonium sulfate species and the specific surface area. Based on the above relationship, we concluded that the deposition of the ammonium sulfate species decreased the specific surface area by plugging the pore structure of the catalyst, and the decrease of the specific surface area resulted in the deactivation of the catalyst.     

Analysis of XANES for identification of highly dispersed transition metal oxides on supports

XANES of vanadium and niobium oxide on silica or alumina have been analyzed quantitatively by a deconvolution technique. Based on the results for reference compounds, local structures of supported vanadium and niobium species were identified. The composition was estimated from difference spectra for the samples which consisted of two kinds of species.     

Silicon nitride thin-film deposition by LPCVD with in situ HF vaporcleaning and its application to stacked DRAM capacitor fabrication

Silicon nitride film deposited by LPCVD with newly developed in situ HF vapor cleaning has been studied and applied to fabricate dielectric films for stacked DRAM capacitors. Using this method, an oxide-free surface of underlaid poly-Si can be obtained. Silicon nitride film deposited on this surface has been verified by FTIR measurement to have the stoichiometrically proper composition of Si₃N₄ . However, the film was found to be selectively deposited on poly-Si electrodes. This selective deposition degrades the reliability of the stacked capacitor, because the silicon nitride can not completely cover the periphery of poly-Si electrodes on SiO₂. We propose a simple process that avoids the problem making it possible to apply silicon nitride film to stacked-capacitor fabrication. Stacked capacitors fabricated by this process exhibit very low leakage current and high electrical reliability even for ultra-thin silicon nitride films less than 5 nm thick     

A novel technique for a DC brushless motor without position sensors

A dc brushless motor is a kind of synchronous motor driven by an inverter and requires sensors to detect the rotor position. As one of the methods, the induced voltages of a brushless motor have been utilized in practice. However, there are some problems in this method, e.g., the motor can obtain insufficient torque due to the low induced voltages in a low-speed range. This paper proposes a new method which controls the inverter angular frequency ω₁ by using inherent characteristics wherein the torque current i_r is almost proportional to the internal phase angle φ where the primary flux of a synchronous motor is controlled to be constant. If the parameters of a motor are given exactly, the speed regulation is quite small and the transient characteristics with high response and high starting torque are obtained. Furthermore, it is possible to operate a synchronous motor in the field-weakening range. Here, the principle of the control method and the performance characteristics of a dc brushless motor having no position sensors are discussed. The simulation and the experimental results of the tested machine show that the proposed method is very useful for practical applications.     

Enhancement of adenovirus-mediated gene transfer to human bone marrow cells

Adenovirus infection of CD34+ hematopoietic stem/progenitor cells is dependent on the multiplicity of infection (MOI), time of incubation, the volume in which the co-incubation occurs and the presence or absence of growth factors. Studies revealed that a brief co-incubation (1-8 hours), resulted in low levels of transgene expression, suggesting that adenovirus infection of CD34+ cells occurs slowly, and optimal transduction requires a 24 hour exposure to adenovirus. Infection by Ad/beta-gal or Ad/p53 at a MOI of 500:1 provided a high transduction efficiency but inhibited hematopoietic function. However, treatment at a MOI of 50-100 resulted in efficient transduction (10.7-15.7% positive) without detectable toxicity. Secondary proof of adenovirus transgene expression was demonstrated by detection of mRNA for p53 in Ad/p53 infected stem cells. We conclude that a 24 hour exposure to recombinant adenovirus encoding p53 or beta-gal, at a MOI of 50-100 is optimal for in vitro gene transfer to BM cells and has no significant effect on hematopoietic function. Adenovirus-mediated transduction of BM cells can also be modulated by growth factors (IL-3, GM-CSF and G-CSF) with improved gene delivery and maintenance of hematopoietic function. In summary, adenovirus vectors can be used to transiently transduce stem cells, and conditions have been defined to maximize expression and limit inhibitory effects on CD34+ cells. These data support continued investigation of this vector for local cytokine delivery and purging of stem cell products.     

Crystallization process and magnetic properties of Fe100−x,B x (10 ≦ × ≦ 35) amorphous alloys and supersaturated state of boron inα-Fe

Amorphous specimens of Fe_100–x B _x were prepared in the range 10 × 35 at % B by a single-roller method. The crystallization process and the boron concentration dependence of the Curie temperature were examined by differential scanning calorimetry, X-ray diffraction, Mössbauer spectroscopy and magnetic measurements. Two-step crystallization was observed in specimens with× < 17: amorphous amorphous + boron-supersaturated b c c phase (-Fe(B)) t-Fe₃B +-Fe. A single-Fe(B) phase was not observed. The transition temperature from t-Fe₃B to stable (-Fe + t-Fe₂B) sensitively depends on the boron content in the alloys. The crystallization temperature (T _x) of the amorphous alloys was almost unchanged for 17 × 31, but increased remarkably at high boron concentrations of× 33, where the decomposition products consisted of t-Fe₂B and o-FeB. The Curie temperature (T _c) of the amorphous phase was as low as 480 K at× = 10, increased with increasing boron content up to 820 K and then decreased in the high boron concentration alloys of× > 28. A single-Fe(B) phase was not detected in the as-quenched specimens of× = 8 and 10. The phase coexisted with the o-Fe₃B and amorphous phases. The lattice parameter of the phase was 0.2861₀ nm which was smaller than that of pure iron by 2/1000, indicating the substitutional occupation of boron atoms in the b c c lattice.     

Thraustochytrid as a potential source of carotenoids

Thraustochytrids, marine protists whose dominant genera are Thraustochytrium and Schizochytrium, belong to the kingdom Chromista and are known as an industrial source of DHA. We describe here that thraustochytrid strain KH105, isolated as a DHA producer, also accumulates significant levels of β-carotene and xanthophylls including canthaxanthin and astaxanthin. A4-d cultivation using a medium composed of 10% glucose and less than 0.3% of nitrogen sources in a half-concentration of seawater gave an astaxanthin production up to 6.1 mg/L, and canthaxanthin content reached more than 10 mg/L under conditions where a higher concentration of nitrogen sources (6%) was employed. It might be advantageous in mass production systems for these carotenoids to be extracted readily by simply suspending the cells with organic solvents such as acetone and chloroform. Analyses on the morphological and life history features of the KH105 strain revealed that it belongs to the genus Schizochytrium. This particular species of thraustochytrids is thus considered to be a promising source of xanthophylls as well as DHA for use in the food industry.     

High-performance cone beam reconstruction using CUDA compatible GPUs

Compute unified device architecture (CUDA) is a software development platform that allows us to run C-like programs on the nVIDIA graphics processing unit (GPU). This paper presents an acceleration method for cone beam reconstruction using CUDA compatible GPUs. The proposed method accelerates the Feldkamp, Davis, and Kress (FDK) algorithm using three techniques: (1) off-chip memory access reduction for saving the memory bandwidth; (2) loop unrolling for hiding the memory latency; and (3) multithreading for exploiting multiple GPUs. We describe how these techniques can be incorporated into the reconstruction code. We also show an analytical model to understand the reconstruction performance on multi-GPU environments. Experimental results show that the proposed method runs at 83% of the theoretical memory bandwidth, achieving a throughput of 64.3 projections per second (pps) for reconstruction of 512³-voxel volume from 360 512²-pixel projections. This performance is 41% higher than the previous CUDA-based method and is 24 times faster than a CPU-based method optimized by vector intrinsics. Some detailed analyses are also presented to understand how effectively the acceleration techniques increase the reconstruction performance of a naive method. We also demonstrate out-of-core reconstruction for large-scale datasets, up to 1024³-voxel volume.     

Te concentration dependent photoemission and inverse-photoemission study of FeSe1?xTex

We have characterized the electronic structure of FeSe_1−xTe_x for various x values using soft x-ray photoemission spectroscopy (SXPES), high-resolution photoemission spectroscopy (HRPES) and inverse photoemission spectroscopy (IPES). The SXPES valence band spectral shape shows that the 2 eV feature in FeSe, which was ascribed to the lower Hubbard band in previous theoretical studies, becomes less prominent with increasing x. HRPES exhibits systematic x dependence of the structure near the Fermi level (E_F): its splitting near E_F and filling of the pseudogap in FeSe. IPES shows two features, near E_F and approximately 6 eV above E_F; the former may be related to the Fe 3d states hybridized with chalcogenide p states, while the latter may consist of plane-wave-like and Se d components. In the incident electron energy dependence of IPES, the density of states near E_F for FeSe and FeTe has the Fano lineshape characteristic of resonant behavior. These compounds exhibit different resonance profiles, which may reflect the differences in their electronic structures. By combining the PES and IPES data the on-site Coulomb energy was estimated at 3.5 eV for FeSe.