Binding of mutated Ras- and p53-derived peptides to HLA-DR molecules

We investigated retrospectively 132 cases of open wedge high tibial osteotomy using an external fixation device, concentrating on the rate of neurological complications. One group of patients underwent surgery according to the conventional technique (n = 89). The rate of transient neurological complications was 15.7%; 7 months after surgery the rate of persistent deficits was 12.4%. For the second group (n = 43) a modified surgical technique was used that lowered the complication rate significantly (transient deficits 14%, persistent deficits 4.7%). In the modified technique the osteotomy is not performed in the conventional way using an oscillating saw but through consecutive drill holes of increasing diameter followed by osteoclasis. The lower complication rate in the second group is mainly due to the less extensive approach that leads to a smaller number of postoperative tibialis anterior syndromes (type B lesion). No differences were found with type C lesions (extension deficit of D1). No complete peroneal nerve palsy (type A) occurred in either group. We conclude that the reduction of neurological complications in group 2 is related to the less extensive approach of the proposed technique.     

Physicochemical properties of monosodium glutamate-compounded tapioca starch exceeds those of simple heat-moisture treated starch

Monosodium glutamate (GluNa)-compounded starch was prepared by heat-moisture treating a mixture of tapioca starch and GluNa. GluNa-compounded starch exhibited a higher gelatinization temperature and reduced swelling and solubility, essentially lower hardness of the granule center, and paste viscosity than those of the heat-moisture treated tapioca starch and the untreated starch. However, its appearance, unit chain length distribution, and α-amylase digestibility were similar to those of the heat-moisture treated tapioca. It is thus concluded that GluNa compounding is useful for providing a unique type of starch that possesses a less swollen and viscous texture than that produced with simple heat-moisture treatment.     

Demulsification of oil-in-water emulsion under freezing conditions: Effect of crystal structure modifier

The demulsification of oil-in-water (O/W) emulsions under freezing conditions is connected to fat crystallization in the oil droplet. Therefore, demulsification can be prevented by the use of oil with a low melting point, and also by lowering the O/W ratio. However, an oil with a low melting point, such as sunflower, is rather expensive, and the O/W ratio has a significant effect on the texture of emulsions. We searched for an oil that is suitable for the production of a freeze-stable emulsion and found that soybean oil has unique characteristics. Normally, emulsions are more unstable at lower temperatures; soybean oil emulsion is unstable at −10°C and stable at −20°C. This unique characteristic results from the following two reasons. First, the solid fat content of soybean oil is almost the same at −10 and −20°C. Second, small crystals form a larger network over a period of time, and the higher temperature promotes faster restructuring. This structure formation was microscopically observed with the use of a thermostated stage. Structure formation was suppressed with the addition of a crystal structure modifier, polyglycerol fatty acid full ester, which also suppressed coalescence.     

Anti-viral effect of interferon-alpha on bovine viral diarrhea virus

PURPOSE: Lamotrigine (LTG) is recognised as effective add-on therapy for focal epilepsies, but this is the first double-blind, placebo-controlled, crossover study in treatment-resistant generalised epilepsy. METHODS: The study consisted of 2 x 8-week treatment periods followed by a 4-week washout period. Patients received doses of either 75 or 150 mg daily, depending on their concomitant antiepileptic drugs (AEDs). Long-term continuation was offered at the end of the study with open-label LTG. RESULTS: Five centres in Australia recruited 26 patients who were having absence, myoclonic, or generalized tonic-clonic seizures or a combination of these. Twenty-two patients completed the study. There was a significant reduction in frequency of both tonic-clonic and absence seizure types with LTG. A 350% decrease in seizures was observed for tonic-clonic seizures in 50% of cases and for absence seizures in 33% of evaluable cases. Rash was the only adverse effect causing discontinuation. Twenty-three of 26 opted for open-label LTG, with 20 still receiving LTG for a mean of 26 months. In these 20, 80% had > or =50% seizure reduction and five (25%) were seizure free. CONCLUSIONS: This study shows that LTG is effective add-on therapy in patients with refractory generalised epilepsies. Statistically significant reduction in seizures in both absence and tonic-clonic seizure types was seen even with low doses of LTG.     

Structural stability and mechanochemical activity of titanium nitride prepared by mechanical alloying

Pure titanium nitride (TiN) was synthesized by mechanical alloying (MA). In order to prevent the contamination from the MA vial and atmospheric gas, the MA steel vial was replaced with a titanium vial and atmospheric gas was deoxidized using sponge titanium heated to 623 K. The mechanochemical activity during MA was estimated from the gas purification temperature. The investigation of thermal and pressure stability by thermal treatment and hot isostatic pressing (HIP) revealed that titanium nitride, TiN, was stable on heating to 1173 K under a vacuum, but became unstable under a high pressure, 100 MPa.     

On the boundary-layer control through momentum injection: Studies with applications

The concept of moving surface boundary-layer control, as applied to a Joukowsky airfoil, is investigated through a planned experimental programme complemented by numerical studies. The moving surface was provided by rotating cylinders located at the leading edge and/or trailing edge as well as top surface of the airfoil. Results suggest that the concept is quite promising, leading to a substantial increase in lift and a delay in stall. Depending on the performance desired, appropriate combinations of cylinder geometry, location and speed can be selected to obtain favourable results over a wide range of angle of attack. Next, effectiveness of the concept in reducing drag of bluff bodies such as a two-dimensional flat plate at large angles of attack, rectangular prisms and three-dimensional models of trucks is assessed through an extensive wind tunnel test-programme. Results show that injection of momentum through moving surfaces, achieved here by introduction of bearing-mounted, motordriven, hollow cylinders, can significantly delay separation of the boundary-layer and reduce the pressure drag. The momentum injection procedure also proved effective in arresting wind-induced vortex resonance and galloping type of instabilities. A flow visualization study, conducted in a closed-circuit water tunnel using slit lighting and polyvinyl choride tracer particles, adds to the wind-tunnel and numerical investigations. It shows, rather dramatically, the effectiveness of the moving surface boundary-layer control (MSBC). The Sabita Chaudhury Memorial Lecture The models were fabricated in the Mechanical Engineering Workshop. The assistance of M/s E Abell, P Hurren and D Camp in the design and construction of the models is gratefully acknowledged. The investigation was supported by the Natural Sciences and Engineering Research Council of Canada, Grant No. A-2181.     

Production of recombinant porcine tumor necrosis factor alpha in a baculovirus expression system

PURPOSE: Stress is often noted by patients to be a precipitating factor in causing seizures. No precise data are, however, available. In 1995 for 250,000 inhabitants in The Netherlands, a serious life event occurred within a period of seven days. An extreme high water level in the province of Gelderland, with the possibility of a flood, made the government decide to evacuate people and their livestock. This retrospective study investigated the influence of this forced evacuation on the seizure frequency of patients with epilepsy, compared with patients of the same age and type of epilepsy living outside the evacuation area at the time of the threatening flood. METHODS: Information regarding epilepsy syndrome, seizure type, and frequency was derived from seizure diaries and medical histories of 30 evacuated patients and 30 matched control patients. RESULTS: Of the 30 evacuees, eight showed an increase and one a decrease in seizure frequency during or shortly after the evacuation period, compared with one and zero control patients, respectively. These results proved to be statistically significant (p < 0.05). CONCLUSIONS: Our data support the hypothesis that there is a relation, albeit small, between a stressful life event and seizure frequency.     

A Fast and Accurate Method of Redesigning Analog Subcircuits for Technology Scaling

In this paper, we present an efficient approach for technology scaling of MOS analog circuits by using circuit optimization techniques. Our new method is based on matching equivalent circuit parameters between a previously designed circuit and the circuit undergoing redesign. This method has been applied to a MOS operational amplifier. We were able to produce a redesigned circuit with almost the same performance in under 4 h, making this method 5 times more efficient than conventional methods.     

Ultrastructural features of the myotendinous junction of the sternomastoid muscle in Wistar rats: From newborn to aging

The myotendinous junction (MTJ) is a major area for transmitting force from the skeletal muscle system and acts in joint position and stabilization. This study aimed to use transmission electron microscopy to describe the ultrastructural features of the MTJ of the sternomastoid muscle in Wistar rats from newborn to formation during adulthood and possible changes with aging. Ultrastructural features of the MTJ from the newborn group revealed pattern during development with interactions between muscle cells and extracellular matrix elements with thin folds in the sarcolemma and high cellular activity evidenced through numerous oval mitochondria groupings. The adult group had classical morphological features of the MTJ, with folds in the sarcolemma forming long projections called “finger‐like processes” and sarcoplasmic invaginations. Sarcomeres were aligned in series, showing mitochondria near the Z line in groupings between collagen fiber bundles. The old group had altered “finger‐like processes,” thickened in both levels of sarcoplasmic invaginations and in central connections with the lateral junctions. We conclude that the MTJ undergoes intense activity from newborn to its formation during adulthood. With increasing age, changes to the MTJ were observed in the shapes of the invaginations and “finger‐like processes” due to hypoactivity, potentially compromising force transmission and joint stability. Microsc. Res. Tech. 75:1292–1296, 2012. © 2012 Wiley Periodicals, Inc.     

Critical duration of intracellular Ca2+ response required for continuous translocation and activation of cytosolic phospholipase A2

When cells are exposed to certain external stimuli, arachidonic acid (AA) is released from the membrane and serves as a precursor of various types of eicosanoids. A Ca2+-regulated cytosolic phospholipase A2 (cPLA2) plays a dominant role in the release of AA. To closely examine the relation between Ca2+ response and AA release by stimulation of G protein-coupled receptors, we established several lines of Chinese hamster ovary cells expressing platelet-activating factor receptor or leukotriene B4 receptor. Measurement of intracellular Ca2+ concentration ([Ca2+]i) demonstrated that cell lines capable of releasing AA elicited a sustained [Ca2+]i increase when stimulated by agonists. The prolonged [Ca2+]i elevation is the result of Ca2+ entry, because this elevation was blocked by EGTA treatment or in the presence of Ca2+ channel blockers (SKF 96365 and methoxyverapamil). cPLA2 fused with a green fluorescent protein (cPLA2-GFP) translocated from the cytosol to the perinuclear region in response to increases in [Ca2+]i. When EGTA was added shortly after [Ca2+]i increase, the cPLA2-GFP returned to the cytosol, without liberating AA. After a prolonged [Ca2+]i increase, even by EGTA treatment, the enzyme was not readily redistributed to the cytosol. Thus, we propose that a critical time length of [Ca2+]i elevation is required for continuous membrane localization and full activation of cPLA2.