Nanolayer CrAlN/TiSiN coating designed for tribological applications

With the goal to produce a hard and tough coating intended for tribological applications, CrAlN/TiSiN nanolayer coating was prepared by alternative deposition of CrAlN and TiSiN layers. In the first part of the article, a detailed study of phase composition, microstructure, and layer structure of CrAlN/TiSiN coating is presented. In the second part, its mechanical properties, fracture and tribological behavior are compared to the nanocomposite TiSiN coating. An industrial magnetron sputtering unit was used for coating deposition. X-ray photoelectron spectroscopy, energy dispersive X-ray spectroscopy, X-ray diffraction, scanning electron microscopy, and transmission electron microscopy were used for compositional and microstructural analysis. Mechanical properties and fracture behavior were studied by instrumented indentation and focused ion beam techniques. Tribological properties were evaluated by ball-on-disk test in a linear reciprocal mode. A complex layer structure was found in the nanolayer coating. The TiSiN layers were epitaxially stabilized inside the coating which led to formation of dislocations at interfaces, to introduction of disturbances in the coating growth, and as a result, to development of fine-grained columnar microstructure. Indentation load required for the onset of fracture was twice lower for the nanolayer CrAlN/TiSiN, compared to the nanocomposite TiSiN coating. This agrees very well with their mechanical properties, with H³/E² being twice higher for the TiSiN coating. However, the nanolayer coating experienced less severe damage, which had a strong impact on tribological behavior. A magnitude of order lower wear rate and four times lower steady state friction coefficient were found for the nanolayer coating.     

Evaluation of microbial toxins,trace elements and sensory properties of a high-theabrownins instant Pu-erh tea produced using Aspergillus tubingensis via submerged fermentation

Theabrownins (TB) are polymeric phenolic compounds associated with the multiple bioactivities of Pu-erh tea, a post-fermented Chinese dark tea. High-TB instant Pu-erh tea was produced via a novel submerged fermentation (SF) using Aspergillus tubingensis and compared with samples produced commercially via the conventional solid-state fermentation (SSF). Viable microorganisms and microbial toxins, especially aflatoxins B₁, G₁, B₂, G₂, cyclopiazonic acid, fumonisins B₁, B₂, B₃ and ochratoxin A, were below the detection limit in all samples. Fewer microbial metabolites were found in SF instant tea compared with the SSF teas. Based on an adult consuming 1 g of instant Pu-erh tea daily, the dietary intake of investigated elements was below the safe limits recommended by various authorities. Tasters viewed the instant tea infusions as very mild, smooth, mellow and full. This suggested that submerged fermentation using A. tubingensis offers a speedy and safe alternative to commercial production of instant Pu-erh tea.     

Fast internal dynamics in polyelectrolyte gels measured by dynamic light scattering

Summary Dynamic light scattering was used to investigate the dynamics of sodium poly(styrene sulfonate) and fully neutralized poly(acrylic acid) gels as a function of the degree of swelling and weight ratio of cross-linking agent. It was shown that the collective diffusion coefficient increases with increasing degree of swelling and that the diffusion coefficient shows stronger concentration dependence than predicted by scaling arguments. For gel samples measured at the swelling equilibrium, the diffusion coefficient increases with increasing gel concentration for both gel systems.     

Kinetic Monte-Carlo simulation of network formation

Summary the simulation described in Part I was applied to random step polyaddition of a trifunctional monomer and the results were compared with exact solution for an infinite system. The gel point conversions, the weight-average degree of polymerization before (P _w) and beyond (P _w,sol) the gel point, the sol fraction and the cycle rank were used for comparison. The best way for detection of the gel point conversion is the extrapolation of the gel fraction, w _g, to w _g=0. The largest fluctuations are exhibited by P _w and P _w,sol. To get results closer to the exact ones, one can repeat several experiments with smaller number of units or increase the number of units, the former way being somewhat more economical. Typical orders of magnitude used were 10⁷ monomeric units.     

Quality of ecologically produced foods of animal origin

The production of organic (ecological) food of animal origin is done in many ways and uses many different breeds. Therefore a real comparison with conventionally produced food is difficult. From the limited number of published data it appears, that the characteristics of quality of the products, the nutritional, hygienic, sensorial and technological factors, are not very different in both systems of production. In some factors organic food gets better marks, in others the conventionally produced food. The differences are in the production system (process quality) during lifetime of the animals.     

Sucrosemia in untreated celiac disease: a potential screening test

During studies to develop serum tests of small intestinal permeability, we detected an unidentified disaccharide in HPLC traces of sera from untreated celiacs. This present study aimed to identify the disaccharide and determine whether the presence of the disaccharide in the serum after an oral challenge had potential as a simple screening test for celiac disease. The disaccharide was identified as sucrose by incubation studies of sera with disaccharidases. Twenty untreated celiacs, 15 treated celiacs, and 20 normal or dyspeptic controls were studied for the presence of sucrose in their serum after an oral load (8 g). The results in celiacs were compared with the presence of serum IgA endomysial antibodies. The 10 normal controls were also given a larger sucrose challenge (50 g). Ten of the untreated celiacs and 10 controls had their brush border disaccharidase activities measured. Sucrose eluted in the same position as the unidentified disaccharide in the HPLC trace and the latter could be removed by incubation with sucrase. All untreated celiacs but none of the treated celiacs had sucrose in their serum after the 8-g oral challenge. None of the controls had sucrose in their serum after the 8-g or 50-g challenges. Three untreated celiacs were IgA endomysial antibody negative as were all the treated cases. Brush border sucrase activity was low in untreated celiac disease. The presence of sucrose in the serum after an oral load shows promise as a noninvasive test for celiac disease.