全文获取类型
收费全文 | 83篇 |
免费 | 8篇 |
国内免费 | 1篇 |
专业分类
电工技术 | 3篇 |
综合类 | 20篇 |
化学工业 | 21篇 |
金属工艺 | 4篇 |
机械仪表 | 1篇 |
建筑科学 | 22篇 |
矿业工程 | 8篇 |
能源动力 | 1篇 |
水利工程 | 1篇 |
石油天然气 | 1篇 |
无线电 | 4篇 |
一般工业技术 | 6篇 |
出版年
2024年 | 3篇 |
2023年 | 3篇 |
2022年 | 2篇 |
2021年 | 5篇 |
2020年 | 2篇 |
2019年 | 7篇 |
2018年 | 4篇 |
2017年 | 2篇 |
2016年 | 6篇 |
2015年 | 7篇 |
2014年 | 13篇 |
2013年 | 6篇 |
2012年 | 3篇 |
2011年 | 9篇 |
2010年 | 5篇 |
2009年 | 5篇 |
2008年 | 9篇 |
1966年 | 1篇 |
排序方式: 共有92条查询结果,搜索用时 15 毫秒
1.
基于国内外对硫酸盐腐蚀环境下纤维沥青混合料的低温抗裂性鲜有研究的现状,采用干湿循环作用下不同浓度(5%、10%)Na2SO4溶液加速劣化试验,研究了水镁石纤维沥青混合料在Na2SO4腐蚀介质中的低温抗裂性变化规律,并与聚酯纤维和玄武岩纤维沥青混合料进行对比;探索了沥青混合料硫酸盐腐蚀损伤机理及纤维在混合料中的阻裂作用。研究结果表明:与纯净水环境相比,沥青混合料在盐蚀环境下的低温抗裂性能劣化程度更为严重;Na2SO4溶液渗入沥青混合料空隙和裂缝中发生的结晶型侵蚀是导致沥青混合料低温抗裂性劣化的主要诱因;水镁石纤维具有优良的增强增韧效应,可以有效提高沥青混合料在硫酸盐腐蚀环境下的低温抗裂性。研究成果可为硫酸盐富集地区沥青混合料材料组成设计提供参考。 相似文献
2.
3.
针对不同沥青与矿粉组成的3种高粘沥青胶浆抗剪性能进行研究,分析锥重、材料组成、温度、粉胶比等对高粘沥青胶浆抗剪性能的影响。结果表明,锥重对沥青胶浆抗剪强度影响很小。随着温度升高,沥青胶浆抗剪强度下降,在25~35℃之间,且当粉胶比大于1.2时,抗剪强度变化趋势显著加快。同种沥青胶浆,随着粉胶比增大其抗剪强度增大,但抗剪强度随温度敏感性先减小后增大,粉胶比为1.2时沥青胶浆抗剪性能温度稳定性最好。与矿粉类型相比,沥青性质对胶浆抗剪强度及其温度敏感性影响更为显著。 相似文献
4.
通过引入VMA*,借鉴贝雷法的骨架思想,结合体积法的填充原则,提出基于VMA*的排水路面沥青混合料矿料组成设计方法。针对基于VMA*设计的排水沥青混合料矿料组成特点,提出贝雷法三参数级配评价中CA值的修正公式及其参数FAc和FAf范围。计算及验证结果表明,基于VMA*的矿料组成设计方法适合排水路面沥青混合料矿料组成设计,修正后的贝雷法三参数级配评价法适用于评价排水沥青混合料,其参数FAc和FAf范围应为0.5~0.8。 相似文献
5.
6.
7.
8.
9.
将铜川煤矸石进行热活化和机械活化后,加入石灰进行化学激发,掺入水泥砂浆中进行强度测试,对石灰和煤矸石掺量进行了实验研究,分析了石灰对煤矸石水泥砂浆的作用。结果表明,煤矸石和石灰掺入对水泥砂浆的强度具有较大的影响。煤矸石水泥砂浆的早期抗压和抗折强度均较低,但28 d强度随煤矸石和石灰用量增加出现先增加后降低的趋势。在煤矸石用量达到40%,石灰取代量为40%左右时,水泥砂浆抗压和抗折强度出现最大值。石灰的加入对煤矸石水泥砂浆的强度具有较大的提升作用,掺石灰后,煤矸石水泥砂浆28 d抗压强度提高约21%,抗折强度提高约31%。 相似文献
10.
The corrosion to asphalt mixture under different kinds of corrosion solution, such as pH=2 solution, pH=12 solution, pH =
12 solution and 10% Na2SO4 solution, was studied. The performance attenuation of asphalt mixture was analyzed under the normal environment and the freeze-thaw
environment, and the analysis was given on the sensitivity of the test results to the evaluation index. The experimental results
show that the performance of asphalt mixture is attenuated faster under the acidic solution, alkaline solution and sulfate
solution. Corrosion factor K
c, freeze-thaw corrosion factor K
f, and freeze-thaw effect factor K
fc are proposed to evaluate asphalt mixture resistance to corrosion in different kinds of corrosion solution. The values of
K
c and K
fc decrease with the increasing of corrosion time. The change rule of K
f show that the rate of corrosion is decreased by the action of freeze-thaw in acidic solution and in alkaline solution, but
is increased by the action of freeze-thaw in sulfate solution. The microscopic analysis indicates that acid solution reacts
with aggregate of asphalt mixture, alkaline solution reacts with asphalt cement of asphalt mixture, the surface tension of
sulfate solution and crystallization of sulfate are the main reasons which weak the performance of asphalt mixture. 相似文献