排序方式: 共有4条查询结果,搜索用时 31 毫秒
1
1.
Interfacial microstructure and properties of YG11C/42CrMo joint brazed with BCu64MnNi filler metal
下载免费PDF全文
![点击此处可从《中国焊接》网站下载免费的PDF全文](/ch/ext_images/free.gif)
Brazing hard alloy to high strength steel, incomplete atomic diffusion and excessive brittle reaction product precipitation at the faying interface are usually suffered because of incomplete understanding the process of the initial interface disappearing and diffusion layer forming and evolving. In this paper, hard alloy YG11C (WC-11wt.%Co) and high strength steel 42CrMo were picked up as base metals and BCu64MnNi as filler metal to clarify the interfacial microstructure evolution. The process parameters of dwell time were set as 30s, 60s, 120s, and 300s and braze temperature were set as 950℃, 970℃, 990℃, 1010℃, the effect of which on the evolution of interfacial microstructure, tensile strength, integrated with fracture morphology analysis, were conducted. The results showed that increasing brazing temperature from 950℃ to 970℃, no significant difference existed in the joint interface, whereas brazed at 990℃, the binder phase erosion occurred, i.e. the liquid filler metal etched into Co binder phase of WC-Co base metal, which caused WC particles debonding from the base metal surface and formed an micro-anisotropic zone.. Increase temperature to 1010℃, severe binder erosion happened so as to micropores appear. Through the parameters optimization, the tensile strength can reach to the maximum 589MPa at temperature of 970℃. The dwell time showed similar effect on tensile strength because longer dwell time also caused erosion and porosity owing to long-time diffusion and reaction. 相似文献
2.
5A06铝合金TIG丝材-电弧增材制造工艺 总被引:2,自引:0,他引:2
选用Φ1.2mm的5A06铝焊丝为成形材料,研究TIG丝材-电弧增材制造工艺。以TIG焊机为电源(交流模式),以四轴联动数控机床为运动机构,研究单层和多层成形时预热温度和电流对成形形貌的影响,观察成形件微观组织,并测试其力学性能。建立了单层单道基板预热温度和电弧峰值电流工艺规范带判据,以保证良好成形。结果表明:成形件的高度从第一层的3.4mm急剧下降,直到第8层后高度稳定在1.7mm。层间组织为细小的树枝晶和等轴晶;层间结合处组织最粗大,为柱状树枝晶;顶部组织最细小,由细小的树枝晶转变为等轴晶。成形件的力学性能各向同性,抗拉强度为295MPa,伸长率为36%。 相似文献
3.
4.
随着数控刀具行业的发展,对其加工精度和加工质量都提出了严格的要求,这就需要提高现有的加工手段。以可转位刀具为例(图1),具体讲解Cimatron在加工中的具体应用。 相似文献
1