排序方式: 共有21条查询结果,搜索用时 296 毫秒
1.
本文以Udimet500合金为基,研究了不同Co含量对镍基高温合金的蠕变速率、蠕变激活能、持久性能及组织结构的影响。结果表明:在780—860℃范围内,稳态蠕变速率以10—15%Co的合金为好,持久断裂时间在15%Co时出现峰值。无Co合金有单一蠕变激活能值,含Co合金有两个蠕变激活能值,激活能转变温度随Co含量增加而提高。Co主要固溶在基体中,γ′相数量随Co含量变化较小;Co有抑制γ′相长大的作用。综合实验结果,提出了Udimet 500型合金降低Co含量的可能性。 相似文献
2.
3.
4.
5.
本文较详细地研究了一种铁镍铬基合金长期时效过程中力学性能变化与组织结构的关系。合金的缺口敏感性与薄膜状TiC沿晶界析出有着密切的关系,随着时效温度的提高和时效时间的延长,晶界薄膜状TiC逐渐变为块状,因而缺口敏感得以消除。由于σ相数量很少,并呈块状分布,因此它能提高高温拉伸塑性及持久延伸率,对消除缺口敏感性也起到一定有利作用,但使室温拉伸塑性及室温冲击韧性下降,其不良影响比TiC及硼化物要小。 相似文献
6.
本文研究了Na_2SO_4,NaCl混合介质对一种镍基高温合金持久性能的影响。试验结果表明:75%Na_2SO_4 25%NaCl的混合介质使合金在750,800℃的持久寿命缩短,断裂塑性降低,持久曲线左移;90%Na_2SO_4 10%NaCl的混合介质对750℃的持久性能无明显影响;95%Na_2SO_4 5%NaCl的混合介质对800℃的持久性能也无明显影响;电解抛光增加合金对热盐腐蚀的敏感性。经金相、扫描电镜、电子探针等分析表明:热盐介质对持久性能影响是通过破坏试样表面保护性氧化膜使基体金属被氧化,且在应力作用下,氧化沿晶界向内部深入而造成。其影响程度与表面状态、盐的组分、应力大小有关。 相似文献
7.
8.
9.
The correlation between the creep rupturebehaviour and the stacking fault energy of matricesof γ′strengthened superalloys has been studied dur-ing constant load creep.At high temperature andintermediate stress,the creep rupture time andstrain strongly depend on the stacking fault energyof matrices rather than the creep friction stress,butat higher stress,the role of grain boundary carbidesbecomes more obvious.However,in the considerably extensive stressrange investigated here,the mean creep rate is apower function of the stacking fault energy ofmatrices and the power index decreases with in-creasing initial applied stress.Particularly,at inter-mediate stresses the product of this index and theinitial applied stress compensated by the shearmodulus is same for two series of superalloys.Hence,this product may be a criterion predictingthat the matrix deformation controls high tempera-ture creep rupture. 相似文献
10.