In-air epitaxy of nanostructures (Aerotaxy) has recently emerged as a viable route for fast, large-scale production. In this study, we use small-angle X-ray scattering to perform direct in-flight characterizations of the first step of this process, i.e., the engineered formation of Au and Pt aerosol nanoparticles by spark generation in a flow of N2 gas. This represents a particular challenge for characterization because the particle density can be extremely low in controlled production. The particles produced are examined during production at operational pressures close to atmospheric conditions and exhibit a lognormal size distribution ranging from 5–100 nm. The Au and Pt particle production and detection are compared. We observe and characterize the nanoparticles at different stages of synthesis and extract the corresponding dominant physical properties, including the average particle diameter and sphericity, as influenced by particle sintering and the presence of aggregates. We observe highly sorted and sintered spherical Au nanoparticles at ultra-dilute concentrations (< 5 × 105 particles/cm3) corresponding to a volume fraction below 3 × 10–10, which is orders of magnitude below that of previously measured aerosols. We independently confirm an average particle radius of 25 nm via Guinier and Kratky plot analysis. Our study indicates that with high-intensity synchrotron beams and careful consideration of background removal, size and shape information can be obtained for extremely low particle concentrations with industrially relevant narrow size distributions.
Retrospectively 78 patients with uni- or bilateral acute acoustic trauma (AAT) were evaluated to assess the therapeutic effect of hyperbaric oxygenation (HBO). All subjects received saline or dextran (Rheomacodrex) infusions with Ginkgo extracts (Tebonin) and prednisone. Thirty six patients underwent additional hyperbaric oxygenation at a pressure of 2 atmospheres absolute for 60 minutes once daily. Both treatment groups were comparable as far as age, gender, initial hearing loss and prednisone dose are concerned. The delay of therapy onset was 15 hours in both groups and treatment was started within 72 hours in all cases. Control audiometry was performed after 6.5 days, when the HBO group had had 5 exposures to hyperbaric oxygenation. The average hearing gain in the group without HBO was 74.3 dB and in the group treated additionally with HBO 121.3 dB (P < 0.004). It is concluded, that hyperbaric oxygenation significantly improves hearing recovery after AAT. Therefore acute acoustic trauma with significant hearing threshold depression remains an otological emergency. Minimal therapy involving waiting for spontaneous recovery, which is mostly incomplete leaving a residual C5 or C6 and handicapping tinnitus, is not the treatment of choice. Randomized prospective clinical trials with a larger patient series are needed and further experimental studies are required to understand the physiological mechanisms of HBO responsible for the clinical success in AAT. 相似文献
Two-dimensional equivalent-circuit models for bipolar junction transistors are systematically derived by solving the continuity equations for DC, AC, and transient excitations. These models take into account carrier propagation delay, all injection levels, as well as exponential doping profiles. They include analytically DC, AC, and transient emitter crowding in a more detailed and accurate manner than previously available. Extensions of the models to accommodate arbitrarily doped and heavily doped quasi-neutral layers and to include energy-gap narrowing due to the electron-hole plasma present at high current density are described. The analysis leads to compact large- and small-signal equivalent-circuit lumped models, suitable for use in circuit simulators such as SPICE. The analytical solutions obtained reveal the two-dimensional distribution of the current and carrier densities in the intrinsic base layer and the onset of emitter crowding. They also provide information for the extraction of the intrinsic base resistance. Several assumptions made in the derivations are assessed by the computer program PISCES. The methods presented apply to both homojunction and heterojunction bipolar transistors 相似文献
An experimental investigation of heat transfer and pressure drop from a new type of corrugated channels is presented. The investigation has been carried out for Reynolds numbers in the range of for one corrugated and one smooth channel. It is found that the heat transfer from the corrugated channel is up to 3.5 times higher than for the smooth one. The pressure drop is however large (5 – 6 times the value of a smooth channel) and it is suggested that the corrugation height and length should be altered in order to balance the increases in heat transfer and pressure drop. 相似文献
Addresses issues related to partial measurement invariance using a tutorial approach based on the {lisrel} confirmatory factor analytic model. Specifically, we demonstrate procedures for (a) using "sensitivity analyses" to establish stable and substantively well-fitting baseline models, (b) determining partially invariant measurement parameters, and (c) testing for the invariance of factor covariance and mean structures, given partial measurement invariance. We also show, explicitly, the transformation of parameters from an all-X to an all-Y model specification, for purposes of testing mean structures. These procedures are illustrated with multidimensional self-concept data from low (n?=?248) and high (n?=?582) academically tracked high school adolescents. (PsycINFO Database Record (c) 2011 APA, all rights reserved) 相似文献
A photocrosslinking precess for polyethylene and its industrial irradiation apparatus has recently been developed and used successfully in the manufactre of thin wall crosslinked polyethylene-insulated wires. Polyethylene (PE) resin with the desired amounts of additives, such as photoinitiator, multifunctional crosslinker, and antioxidant is mixe homogeneously. The amixture of PE is granulated, and then extruded on a conductor wire. The coated PE layer in the melt is subsequently irradiated in a specially designed UV irradiation apparatus for 5 to 10 s. The studies show that the photocrosslinked PE-insulation high voltage television wires produced by this new technique possess excellent electrical and mchanical properties and much lower operating cost compared with wires produced by the electron beam crosslinking technique. 相似文献
A method for measuring mixing performance in large-scale vessels is investigated. The method is evaluated experimentally in a pilotscale reactor and by using a model based on the three-dimensional calculation of the flow field. The method is based on injection of a tracer and measuring the concentration with several detectors at different locations. The mixing performance is measured as the decay rate of the difference between the concentration at the detectors and the final concentration.
The model predicts a strong dependence on injection point. The assumption of a first-order decay rate of the concentration deviation is more appropriate for some injection points. 相似文献
The gas-liquid mass transfer in two-phase flow through a capillary has been measured for water-air, ethanol-air and ethylene glycol-air systems. A semi-theoretical model has been developed and compared with experimental results. and a full computer simulations of the flow pattern and mass transfer using a flow simulation program have been made. The measured values are about 30% less than the calculated values. 相似文献