Characterization of Aluminum Foam Impact Response

Strength of Materials - The paper addresses the investigation of high-strain rate compressive behavior of Al foams subjected to impact at the intermediate striking velocity ranged from 40 to...     

Photoinduced recovery of gamma-irradiated fluoride glasses

Radiation-induced changes in the optical properties of fluoride glasses (FGs) were studied on samples of zirconium fluoride and aluminum fluoride based compositions gamma-irradiated to a total dose of 1.2 MGy. Upon exposure, the fundamental absorption edge smears and shifts toward longer wavelengths. The FGs studied exhibit self-recovery of the optical properties, whereby the radiation-induced absorption decreases in the course of storage without action of any external factors. Photostimulated recovery of the optical properties of the gamma-irradiated FGs was studied in the range of light wavelengths from 400 to 1200 nm at a light intensity of 1–3 mW/cm². The maximum rate of recovery for both zirconium and aluminum fluoride based glasses was observed for the photoannealing at 600 nm.     

Precision Spectrometric Determination of Th and Pu in Solutions with Arsenazo III Using Internal Standardization

A spectrophotometric procedure with internal standardization was suggested for precision determination of the concentrations of Th and Pu in the form of colored complexes with arsenazo III in nitric acid solutions. The sensitivity of the method was significantly improved owing to the use of colored complexes. The optical density optimum (0.3-0.5) of the solutions for spectrophotometric measurements can be achieved at concentrations in solution of the element analyzed as low as (2-3) ×10^-6 M, at the arsenazo and HNO₃ concentrations of 1 ×10^-4 and 6 M, respectively. With this composition of the solution, the relative rms deviation of the results for a single run is no greater than 0.15 and 0.3% for thorium and plutonium, respectively.     

The social consequences of expressive suppression.

At times, people keep their emotions from showing during social interactions. The authors' analysis suggests that such expressive suppression should disrupt communication and increase stress levels. To test this hypothesis, the authors conducted 2 studies in which unacquainted pairs of women discussed an upsetting topic. In Study 1, one member of each pair was randomly assigned to (a) suppress her emotional behavior, (b) respond naturally, or (c) cognitively reappraise in a way that reduced emotional responding. Suppression alone disrupted communication and magnified blood pressure responses in the suppressors' partners. In Study 2, suppression had a negative impact on the regulators' emotional experience and increased blood pressure in both regulators and their partners. Suppression also reduced rapport and inhibited relationship formation. (PsycINFO Database Record (c) 2010 APA, all rights reserved)     

Rehabilitation of the radioactively contaminated objects and territory of the Russian Science Center Kurchatov Institute

This article is devoted to work done in 2002–2006 as part of the unified project Reabilitatsiya to rehabilitate radiation hazardous objects and sections of the radioactively contaminated territory of the Russian Science Center Kurchatov Institute. The main objects of the rehabilitation work were old storage sites built for radioactive wastes on the territory of the Institute when military and civilian nuclear technologies were under development. The structural features of the storage sites, including the volumes and characteristics of the wastes stored, are presented. The salient aspects of the disposal sites, taken into account during the rehabilitation work, are discussed. The organization of the rehabilitation operations and the sequence in which they are performed, the special features of the technical design solutions used, the technological methods, and ways for conducting the work are described. __________ Translated from Atomnaya énergiya, Vol. 102, No. 5, pp. 300–306, May, 2007.     

Optical properties of doped bismuth telluride crystals in the region of plasma effects

The optical properties of bismuth telluride crystals doped with donor-and acceptor-type impurities are studied. The fact that energy corresponding to the resonance frequency of plasma oscillations of free charge carriers (plasmons) approaches the band-gap energy is detected in the infrared spectral region, where the main elementary excitations in the electronic system of these materials are observed. The mentioned approach of energies varies the intensity of electron-plasmon interaction, which affects the recombination processes in the materials widely used for the fabrication of thermoelectric energy converters.     

Effect of sampling density on the measurement of stream condition indicators in two lowland Australian streams

There is widespread application of indicators to the assessment of environmental condition of streams. These indicators are intended for use by managers in making various comparative and absolute assessments and often have a role in resource allocation and performance assessment. Therefore, the problem of formally defining confidence in the results is important but difficult because the sampling strategies used are commonly based on a compromise between the requirements of statistical rigour and the pragmatic issues of access and resources. It is rare to see this compromise explicitly considered and consequently there is seldom quantification of the uncertainty that could affect the confidence a manager has in an indicator. In this paper, we present a method for quantitatively assessing the tradeoffs between sampling density and uncertainty in meeting various monitoring objectives. Assessments using judgement‐based representative reaches are shown to be unreliable; instead a sampling approach is recommended based on the random selection of measuring sites. A detailed dataset was collected along two streams in Victoria, Australia, and the effect of sampling density was assessed by subsampling from this dataset with precision related to the number of sites assessed per reach length and the intensity of the sampling at each site. The sampling scheme to achieve a given precision is shown to depend on the monitoring objective. In particular, three objectives were considered: (1) making a baseline assessment of current condition; (2) change detection; and (3) detection of a critical threshold in condition. Change detection is shown to be more demanding than assessing baseline condition with additional sampling effort required to achieve the same precision. Sampling to detect a critical threshold depends on nominating acceptable values of Type I and II error and the size of the effect to be detected. Copyright © 2006 John Wiley & Sons, Ltd.