Nanolayer CrAlN/TiSiN coating designed for tribological applications

With the goal to produce a hard and tough coating intended for tribological applications, CrAlN/TiSiN nanolayer coating was prepared by alternative deposition of CrAlN and TiSiN layers. In the first part of the article, a detailed study of phase composition, microstructure, and layer structure of CrAlN/TiSiN coating is presented. In the second part, its mechanical properties, fracture and tribological behavior are compared to the nanocomposite TiSiN coating. An industrial magnetron sputtering unit was used for coating deposition. X-ray photoelectron spectroscopy, energy dispersive X-ray spectroscopy, X-ray diffraction, scanning electron microscopy, and transmission electron microscopy were used for compositional and microstructural analysis. Mechanical properties and fracture behavior were studied by instrumented indentation and focused ion beam techniques. Tribological properties were evaluated by ball-on-disk test in a linear reciprocal mode. A complex layer structure was found in the nanolayer coating. The TiSiN layers were epitaxially stabilized inside the coating which led to formation of dislocations at interfaces, to introduction of disturbances in the coating growth, and as a result, to development of fine-grained columnar microstructure. Indentation load required for the onset of fracture was twice lower for the nanolayer CrAlN/TiSiN, compared to the nanocomposite TiSiN coating. This agrees very well with their mechanical properties, with H³/E² being twice higher for the TiSiN coating. However, the nanolayer coating experienced less severe damage, which had a strong impact on tribological behavior. A magnitude of order lower wear rate and four times lower steady state friction coefficient were found for the nanolayer coating.     

Investigation the correlation between chemical structure and swelling,thermal and flocculation properties of carboxymethylcellulose hydrogels

Hydrophilic polymer networks (hydrogels) based on sodium carboxymethylcellulose (NaCMC) and polycarboxylic acids (oxalic, succinic, citric and adipic) as cross-linking agents are synthesized by esterification reaction; one series of NaCMC hydrogels cross-linked with citric acid is prepared with acrylamide and acrylic acid (Aam/Aac) copolymers using the design of semi-interpenetrating polymer networks (semi-IPN), in order to increase their potential application for flocculation purposes. The Infrared spectroscopy (FTIR) of hydrogels confirms the esterification reaction between NaCMC and cross-linking agents. Results of swelling measurements show that citric acid in the amount of 15 wt% gives the hydrogels with the best absorption capacity. The results of Differential scanning calorimetry (DSC) and Thermal gravimetric analysis (TGA) show no significant difference in thermal properties of neat and semi-interpenetrating NaCMC hydrogels. The amorphous nature of hydrogels is confirmed by X-ray diffraction analysis (XRD). The results of flocculation study show that combination of NaCMC network and Aam/Aac copolymer with initial mass ratio of 10/90 creates a theoretical platform for the production of flocculant which could show high efficacy in purifying of water dominated by positively charged particles.     

Development of green extraction process to produce antioxidant-rich extracts from purple coneflower

The present study was conducted to develop subcritical water extraction (SWE) of Echinacea purpurea flowers. The influence of temperature and extraction time on quality of extracts considering total phenols content, total flavonoids content, antioxidant capacity and extraction yield, was determined. Optimized extraction parameters for maximised investigated responses were as follows: 147.56 °C and 8.43 min. The experimental values agreed with the values predicted, thus indicating the adequacy of central composite experimental design for modelling the SWE of bioactive compounds from E. purpurea. Results of the study also highlighted the potential application of E. purpurea subcritical water extracts as a source of valuable bioactive compounds.     

Corrosion behaviour of AA2024 aluminium alloy in different tempers in NaCl solution and with the CeCl3 corrosion inhibitor

The paper analyses the corrosion behaviour of naturally and artificially aged AA2024 alloy in NaCl solution and in the presence of an environment-friendly corrosion inhibitor, CeCl₃. On the basis of the values of polarisation resistance and corrosion current density, the corrosion resistance of the protective inhibitor film is established as well as the general corrosion resistance of this aluminium alloy. Resistance to pit formation is determined based on the difference in pitting and corrosion potentials while resistance to pit growth is determined based on the amount of charge consumed during pit growth. A scanning electron microscope is used to examine the morphology of the pits formed during the pitting corrosion testing, as well as to determine the cerium content on intermetallic particles and the matrix AA2024 alloy. The corrosion behaviour of AA2024 alloy is investigated after different test periods in NaCl solution and in the same solution with the CeCl₃ inhibitor. The corrosion resistance of both tempers of AA2024 alloy is more than one order of magnitude higher in the presence of CeCl₃. An explanation of the observed differences in the corrosion behaviour of the naturally and artificially aged AA2024 alloy is proposed. Different corrosion behaviour of the alloy after different test periods is also explained.     

Anthocyanin composition of the red wine Babić affected by maceration treatment

Identification of anthocyanins in the wine made of the Croatian autochthonous grape variety of Babić (Vitis vinifera L.) was carried out and their profile was determined by means of high-performance liquid chromatography with diode array and mass spectrometric detection. Dependence of anthocyanins content and profile on maceration treatment conditions was investigated. Statistically significant differences of anthocyanins concentration in wines Babić produced by various maceration treatments were confirmed by the use of multivariate analysis of variances. The investigation results indicated that the maceration temperature exerts higher influence on anthocyanins concentration than the duration of maceration. In addition, on the basis of anthocyanin composition and using different multivariate statistical analyses, differentiation of wines Babić according to maceration treatments was procured.     

Viral dynamics of primary viremia and antiretroviral therapy in simian immunodeficiency virus infection

Mathematical modeling of viral replication dynamics, based on sequential measurements of levels of virion-associated RNA in plasma during antiretroviral treatment, has led to fundamental new insights into human immunodeficiency virus type 1 pathogenesis. We took advantage of the simian immunodeficiency virus (SIV)-infected macaque model to perform detailed measurements and mathematical modeling during primary infection and during treatment of established infection with the antiretroviral drug (R)-9-(2-phosphonylmethoxypropyl)adenine (PMPA). The calculated clearance half-life for productively infected cells during resolution of the peak viremia of primary infection was on the order of 1 day, with slightly shorter clearance half-lives calculated during PMPA treatment. Viral reproduction rates upon discontinuation of PMPA treatment after 2 weeks were approximately twofold greater than those obtained just prior to initiation of treatment in the same animals, likely reflecting accumulation of susceptible target cells during treatment. The basic reproductive ratio (R0) for the spread of SIV infection in vivo, which represents the number of productively infected cells derived from each productively infected cell at the beginning of infection, was also estimated. This parameter quantifies the extent to which antiviral therapy or vaccination must limit the initial spread of virus to prevent establishment of chronic disseminated infection. The results thus provide an important guide for efforts to develop vaccines against SIV and, by extension, human immunodeficiency virus.     

Resumption of mitosis during post-thaw culture: a key parameter in selecting the right embryos for transfer

A new oxidative pathway for the degradation of caffeine(1,3,7-Trimethylxanthine, I) by a mixed culture consisting of strains belonging to the genera Klebsiella and Rhodococcus is presented. The mixed culture does not initiate degradation by N-demethylation either complete or partial, but instead carries out oxidation at the C-8 position resulting in the formation of 1,3,7-trimethyluric acid (TMU, II) which further gets degraded to 3,6,8-trimethylallantoin (TMA, III). Both TMU and TMA are hitherto not shown to be formed in the microbial system. Further degradation of TMA (III) by caffeine grown cells yields dimethylurea (VII) as one of the metabolites. Oxygen uptake studies indicated that caffeine(I) grown cells oxidized TMU(II), TMA (III), glyoxalic acid (VI), dimethylurea(VII), and monomethylurea(V), but not monomethyl and dimethyluric acids. The mixed culture does not accept theophylline(1,3-dimethylxanthine), theobromine(3,7-dimethylxanthine), and paraxanthine(1,7-dimethylxanthine) as the carbon source.     

Foetal alcohol syndrome in Saskatchewan: unchanged incidence in a 20-year period

Ethers and thioethers of monosaccharides have been synthesised which show potent toxicity to mouse (LD50 > or = 4 g.kg-1 O.W. and 0.2 to 1.5 g.kg-1 I.P.W.). A study of calcium antagonist activity for the full series of compounds indicated that the activity was similar for both O- and S- ethers and maximum activities were observed for monoacetoneglucose ethers possessing carbon chain close to 8 carbons.