The band areas of proteins determined by fluorescent scanning in the commercial automated gel electrophoresis apparatus

An automated gel electrophoresis apparatus, recently available commercially, allows one to follow the band during electrophoresis in real time, and lends itself therefore to an evaluation of bandwidth as a function of migration time (the dispersion coefficient), resolution and band shape. These determinations assume the constancy of band area with migration time and at various gel concentrations. The purpose of the present study was to verify these assumptions. Representative proteins and sodium dodecyl sulfate (SDS)-proteins, either natively fluorescent or fluorescein carboxylate labeled, were found to exhibit band areas which approach constancy as a function of migration time in both agarose and polyacrylamide gel electrophoresis, provided that (i) the protein concentration under the band was low enough to obviate self-quenching of fluorescence; (ii) the separation of the protein of interest from contaminants had progressed sufficiently during the time at which band areas were measured; (iii) the baseline under the peak was sufficiently well defined. However, band areas decrease with increasing gel concentration. Protein peaks exhibited leading and trailing tails. The ratio of the combined tail area to total area appeared to be near-constant at varying migration times. However, that ratio increases with increasing gel concentration. The tail area does not appear to be an artifact of fluorometric detection since it is reproduced upon fluorimetric analysis of the protein eluted from gel slices after electrophoresis. However, it may be due to photochemical destruction under the conditions of repetitive fluorometric peak detection.     

Effects of flux enhancing polymer on the characteristics of sludge in membrane bioreactor process.

A newly developed membrane performance enhancer (MPE) was used to prevent membrane fouling in a membrane bioreactor (MBR) process. It transpired that 1,000 mg/l of MPE reduced polysaccharide levels from 41 mg/I to 21 mg/I on average under the experimental condition. Repeated experiments also confirmed that 50-1,000 mg/l of MPE could reduce membrane fouling significantly and increase the intervals between membrane cleanings. Depending on MPE dosages and experimental conditions, trans-membrane pressure (TMP) increase was suppressed for 20-30 days, while baseline TMP surged within a few days. In addition, MPE allowed MBR operation even at 50,000 mg/l of total solid and reduced permeate COD. However, no evidence of toxicity for sludge was found from respiratory works.     

Symptom correlates of attentional improvement following hospitalization for a first episode of affective psychosis

BACKGROUND: This study examined patients with a first-episode of affective psychosis during acute and compensated states in order to determine whether changes in attentional functioning over time were accompanied by changes in the severity of psychotic or affective symptoms. METHODS: Attentional performance was measured in patients (n = 27) using the degraded-stimulus continuous Performance Test (CPT) and symptoms were assessed at the time of index hospitalization, and 2 months after discharge. A comparison group of normal volunteers (n = 31) also performed the CPT two months apart. RESULTS: Patients performed significantly worse than controls at the initial testing but not at follow-up. The improvement in attentional performance significantly correlated with decreased severity of manic symptoms. CONCLUSIONS: Results suggest attentional dysfunction is a state-dependent characteristic of mania, and may provide an additional measure of clinical improvement following treatment.     

Microfabricated Lamb wave device based on PZT sol-gel thin film formechanical transport of solid particles and liquids

The fabrication using silicon micromachining and characterization of an acoustic Lamb wave actuator is presented. The intended use of the device is for mass transport and sensor applications. The device consists of dual interdigitated transducers patterned on a thin-film composite membrane of silicon nitride, platinum, and a sol-gel-derived piezoelectric ceramic (PZT) thin film. The acoustic properties of the device are presented along with preliminary applications to mechanical transport and liquid delivery systems. Improved acoustic signals and improved mass transport are achieved with PZT over present Lamb wave devices utilizing ZnO or AlN as the piezoelectric transducer