A comparison of emulsifiers for the formation of oil-in-water emulsions: stability of the emulsions within 9 h after production and MR signal properties

Objective

To provide a basis for the selection of suitable emulsifiers in oil-in-water emulsions used as tissue analogs for MRI experiments. Three different emulsifiers were investigated with regard to their ability to stabilize tissue-like oil-in-water emulsions. Furthermore, MR signal properties of the emulsifiers themselves and influences on relaxation times and ADC values of the aqueous phase were investigated.

Materials and methods

Polysorbate 60, sodium dodecyl sulfate (SDS) and soy lecithin were used as emulsifiers. MR characteristics of emulsifiers were assessed in aqueous solutions and their function as a stabilizer was examined in oil-in-water emulsions of varying fat content (10, 20, 30, 40, 50%). Stability and homogeneity of the oil-in-water emulsions were evaluated with a delay of 3 h and 9 h after preparation using T₁ mapping and visual control. Signal properties of the emulsifiers were investigated by ¹H-MRS in aqueous emulsifier solutions. Relaxometry and diffusion weighted MRI (DWI) were performed to investigate the effect of various emulsifier concentrations on relaxation times (T₁ and T₂) and ADC values of aqueous solutions.

Results

Emulsions stabilized by polysorbate 60 or soy lecithin were stable and homogeneous across all tested fat fractions. In contrast, emulsions with SDS showed a significantly lower stability and homogeneity. Recorded T₁ maps revealed marked creaming of oil droplets in almost all of the emulsions with SDS. The spectral analysis showed several additional signals for polysorbate and SDS. However, lecithin remained invisible in ¹H-MRS. Relaxometry and DWI revealed different influences of the emulsifiers on water: Polysorbate and SDS showed only minor effects on relaxation times and ADC values of aqueous solutions, whereas lecithin showed a strong decrease in both relaxation times (r_1,lecithin = 0.11 wt.%⁻¹ s⁻¹, r_2,lecithin = 0.57 wt.%⁻¹ s⁻¹) and ADC value (Δ(ADC)_lecithin =  − 0.18 × 10^–3 mm²/s⋅wt.%) with increasing concentration.

Conclusion

Lecithin is suggested as the preferred emulsifier of oil-in-water emulsions in MRI as it shows a high stabilizing ability and remains invisible in MRI experiments. In addition, lecithin is suitable as an alternative means of adjusting relaxation times and ADC values of water.

     

Bipolar electric fatigue behaviour as a function of field strength in antiferroelectric (Pb,Ba,La)(Zr,Sn,Ti)O3 ceramics

The bipolar electric fatigue behaviour of antiferroelectric ceramics with the composition of Pb_0.88Ba_0.10La_0.02(Zr_0.55Sn_0.35Ti_0.10)O₃ was investigated under various cycling fields. The material exhibits a degradation in the maximum field induced strain, a diffuse AFE-FE phase transition and an enhancement in the diffusion character of the FE-AFE phase transition due to electric cycling. Those variations increase with cycle number, indicating a logarithmic fatigue up to 10⁸ cycles. There is no indication for the variations to be recovered, and the symmetry of the negative and positive parts of the strain hysteresis loops still remains. Higher cycling field results in a stronger deterioration of the maximum field induced strain and a larger extent of diffusion in AFE-FE and FE-AFE phase transitions. The normalized maximum strain shows nearly the same scale of degradation when the materials are cycled at various electric fields. After a heat treatment at 500°C for 1 h, the variations in the AFE-FE and FE-AFE phase transition due to cycling disappear, whereas the maximum strain resumes almost to its original value. Electrochemical variations are considered to contribute to the main fatigue mechanism for the material under investigation.     

Neurocontrol for lateral vehicle guidance

A solution to autonomous lateral vehicle guidance using a neurocontroller that can learn from measured human-driving data without knowledge of the physical car parameters is discussed. Simulations and practical tests confirm that a small-size feedforward autonomous neural network (21 neurons) can learn to steer a vehicle at high speeds only from looking at human-driving examples. In this way, the network learns the total closed-loop behavior, including the nonlinear dynamics of the vehicle and the driver's individual driving style. The main result of practical investigations is that the neutral controller trained on human-driving examples exhibits an aperiodic behavior that does not vanish at higher speeds (tests performed up to 130 km/h) and produces fewer lateral deviations than the linear state controller     

Relationship between CO2 Sensor Voltage Response and Phase Equilibrium of Solid Electrolyte Na, K-β/β"-Al2O3

A type of CO2 sensor based on oxygen concentration cell was designed as following: Cell I: Pt | Au, O2,CO2|Na2CO3(Au)|NKBA(Au)|YSZ|O2, CO2|Pt or Cell Ⅱ: Pt|Au, O2, CO2|K2CO3(Au)|NKBA(Au)|YSZ|O2, CO2|Pt.(Na,K-β/β″-Al2O3 is named by NKBA). The sensor signal is consistent with the Nernstian slope within the region ofphase equilibrium for Na, K-β/β"-Al2O3 material. The relationship between CO2 sensor voltage response and phaseequilibrium of solid electrolyte Na, K-β/β-Al2O3 is discussed in this paper.     

Pretreatment and physical activation of acetylene cokes

Pretreatment of acetylene cokes at 450 °C with a mixture of nitrogen, oxygen and water vapour creates a relatively large surface area and some initial microporosity, further developed by water activation at 800 °C. For the same degree of burn-off, but without pretreatment, large micropores (L > 2–3 nm) are obtained and the external surface area remains small.     

Novel aspects of the microstructure of PP/PA blends prepared by reactive compounding as studied by microhardness

The microhardness of injection-moulded i-polypropylene/polyamide (iPP/PA) blends prepared by reactive compounding was determined. The formulation rules and processing technology for the preparation of these alloys was reported previously. iPP/PA compositions between 100/0 and 50/50 using functionalized PP with various degrees of mainchain grafting, were investigated. It is shown that the deviation of microhardness from the additivity law of the single components is mainly due to a decrease in the crystallinity of the iPP phase. The results are discussed in the light of the microstructural variations as revealed by X-ray diffraction methods.     

Digital Signatures: A Business View

The technology to create secure digital signatures is proven and workable on PC-level hardware, as well as on mainframes. the issues currently restraining widespread use of digital signatures are primarily legal. This tutorial survey first identifies the functions a digital signature should ideally perform by tracing an example Internet-based electronic business transaction. After an overview of the technology that provides the required functionality, this article presents the current legal status of digital signature use, including a number of unresolved liability issues, and summarizes some precautions for digital signature use.     

The Electrochemistry of Liposomes

This review aims to summarize the current state of research concerning the interaction of electrodes with liposomes suspended in solutions. Main attention is given to the complex mechanism of adhesion and spreading of liposomes on mercury electrodes. That mechanism can be studied with the help of chronoamperometry, where each adhesion-spreading event appears as a capacitive current spike. Integration of these spikes produces charge versus time transients that can be modeled and simulated, revealing the details of the multi-step adhesion-spreading process. Whereas the number of spikes per time mirrors the macro-kinetics, the analysis of the time behavior of each spike mirrors the micro-kinetics of each adhesion-spreading event. The reviewed studies show that this approach provides a new tool to study the properties of liposome membranes. The adhesion-spreading of liposomes on mercury electrodes has strong similarities to the process of vesicle fusion, which makes these studies a biomimetic model allowing one to deduce the effects of foreign molecules in bilayer membranes.     

Race as a moderator in a model of sexual harassment: An empirical test.

L. F. Fitzgerald, C. L. Hulin. and F. Drasgow (1995) proposed that victim characteristics, such as race, might moderate the relationships between sexual harassment and its job, psychological, and health status outcomes. This study describes 2 theoretical positions, tokenism and double jeopardy, that could account for this possible moderation by race, as well as the alternative view that no moderating effects exist. The effects of race are empirically examined through simultaneous path analysis. Results indicate that whereas, mean levels of harassment differ across race, the phenomenon of sexual harassment unfolds similarly across races; race is not a moderator of the relationships between sexual harassment and the variables proposed as its antecedents and outcomes. (PsycINFO Database Record (c) 2010 APA, all rights reserved)