A New Hand-Held Microsystem Architecture for Biological Analysis

This paper presents a hand-held microsystem based on new fully integrated magnetoresistive biochips for biomolecular recognition (DNA hybridization, antibody antigen interaction, etc.). Magnetoresistive chip surfaces are chemically treated, enabling the immobilization of probe biomolecules such as DNA or antibodies. Fluid handling is also integrated in the biochip. The proposed microsystem not only integrates the biochip, which is an array of 16times16 magnetoresistive sensors, but it also provides all the electronic circuitry for addressing and reading out each transducer. The proposed architecture and circuits were specifically designed for achieving a compact, programmable and portable microsystem. The microsystem also integrates a hand-held analyzer connected through a wireless channel. A prototype of the system was already developed and detection of magnetic nanoparticles was obtained. This indicates that the system may be used for magnetic label based bioassays     

Solutions to a combined problem of excessive hydrogen sulfide in biogas and struvite scaling.

The Woodman Point Wastewater Treatment Plant (WWTP) in Western Australia has experienced two separate problems causing avoidable maintenance costs: the build-up of massive struvite (MgNH4PO4. 6H2O) scaling downstream of the anaerobic digester and the formation of hydrogen sulfide (H2S) levels in the digester gas to levels that compromised gas engine operation and caused high operating costs on the gas scrubber. As both problems hang together with a chemical imbalance in the anaerobic digester, we decided to investigate whether both problems could be (feasibly and economically) addressed by a common solution (such as dosing of iron solutions to precipitate both sulfide and phosphate), or by using separate approaches. Laboratory results showed that, the hydrogen sulfide emission in digesters could be effectively and economically controlled by the addition of iron dosing. Slightly higher than the theoretical value of 1.5 mol of FeCl3 was required to precipitate 1 mol of dissolved sulfide inside the digester. Due to the high concentration of PO4(3-) in the digested sludge liquor, significantly higher iron is required for struvite precipitation. Iron dosing did not appear an economic solution for struvite control via iron phosphate formation. By taking advantage of the natural tendency of struvite formation in the digester liquid, it is possible to reduce the risk of struvite precipitation in and around the sludge-dewatering centrifuge by increasing the pH to precipitate struvite out before passing through the centrifuge. However, as the Mg2+/PO4(3-) molar ratio in digested sludge was low, by increasing the pH alone (using NaOH) the precipitation of PO4(3-) was limited by the amount of cations (Ca2+ and Mg2+) available in the sludge. Although this would reduce struvite precipitation in the centrifuge, it could not significantly reduce PO4(3-) recycling back to the plant. For long-term operation, maximum PO4(3-) reduction should be the ultimate aim to minimise PO4(3-) accumulation in the plant. Magnesium hydroxide liquid (MHL) was found to be the most cost-effective chemical to achieve this goal. It enhanced struvite precipitation from both, digested sludge and centrate to the point where more than 95% PO4(3-) reduction in the digested sludge was achieved.     

Study of the nozzle flow in a cross-flow turbine

An investigation of the flow inside the nozzle of a Cross-Flow turbine, which is a hydraulic turbine where the rectangular water jet issuing from the nozzle crosses the rotor blades twice, is presented here. Part of the investigation consisted in the experimental measurement of the static pressure distribution on the inside walls of two different nozzle configurations, both with the nozzle mounted alone and in the presence of a rotor. The tests performed in the presence of a rotor included the measurement of efficiency and covered a wide range of working conditions around the best efficiency point. The analysis of the results obtained in this way give us an indication of the influence of the turbine non-dimensional volume flow rate on the flow inside the nozzle and the way it affects the reaction degree of the machine and its efficiency level. Although most of the tests were carried out with a 25-blade rotor, one of the analysed nozzle configurations (that with an inside vane) was also tested with a 10-blade rotor, permitting the assessment of the effect the number of blades has on the flow in the nozzle.The flow inside the nozzle with no inside vane was numerically analysed using a method based on a Schwarz-Christoffel conformal transformation of variables. The numerical results show a fair agreement with the experimental data collected when the rotor was not present. A qualitative discussion of some of the losses occurring in the nozzle is advanced based on the computer results, and its conclusions are used for explaining the poor performance of the nozzle with no inside vane.     

1.04 GBd low EMI digital video interface system using small swingserial link technique

In a high-resolution flat panel system, a conventional interface that directly connects a liquid crystal display (LCD) controller to a flat panel cannot overcome the problems of excess EMI (electromagnetic interference) and power caused by full-swing transmission signals in parallel lines. This paper presents a high-speed digital video interface system implemented with a low-cost standard CMOS (complimentary metal-oxide-semiconductor) technology that can mitigate EMI and power problems in high-resolution flat panel display systems. The combined architecture of the high-speed, small number of parallel lines and low-voltage swing serial interface can support resolutions from VGA (640×480 pixels) up to XGA (1024×768 pixels) with significant power improvement and drastic EMI reduction. To support high-speed, low-voltage swing signaling and overcome channel-to-channel skew problems, a robust data recovery system is required. The proposed digital phase-locked loop enables robust skew-insensitive data recovery of up to 1.04 GBd     

Evaluation of in vitro stability of large unilamellar liposomes coated with a modified polysaccharide (O-palmitoylpullulan)

Aiming at encapsulation of a hydrosoluble drug, large unilamellar liposomes (LUV) of egg phosphatidylcholine (PC) were coated with a natural polysaccharide derivative, O-palmitoylpullulan (OPP), and its in vitro stability evaluated using fluorescent probes. This coating (in OPP/PC weight ratio of 3) improved significantly the in vitro stability of LUV by decreasing both the permeability and fluidity of the liposomal membrane.This paper was accepted for publication after the 1995 Conference of the European Society of Biomaterials, Oporto, Portugal, 10–13 September.     

Infrared and ultraviolet–visible spectroscopic studies of silica, [(Cp)2ZrCl2] and trimethylaluminum interactions

Infrared and UV–vis studies of metallocene immobilization on silica are reported here. The results have indicated changes in the Zr coordination sphere of metallocene depending on the immobilization route used. The reaction of [(Cp)₂ZrCl₂] with silica formed [(Cp)₂ZrCl]⁺[SiO]⁻ species. The same metallocene, reacting with TMA modified silica, formed monomethylated and dimethylated species by the substitution of chloro for methyl ligands, stabilized on the surface by interaction with “MAO-like” species (methylaluminoxane, MAO). These monomethylated and dimethylated cationic zirconium species are the active centers for the polymerization reaction. Different order of TMA addition in the silica modification step generated surface species of a similar nature, differing in their relative quantities. The highest amount of these active species was obtained when the support was added to the TMA solution rather than adding the TMA solution to the silica support. This was the most significant parameter affecting catalytic activity in ethylene polymerization.     

Generalized Nakagami-m phase crossing rate

This paper provides simple, exact, new closed-form expressions for the generalized phase crossing rate of Nakagami-m fading channels. Sample numerical results obtained by simulation are presented that validate the formulations developed here. A special case of this formulation is the Rayleigh case, whose result agrees with that obtained elsewhere in the literature. In passing, several new closed-form results concerning the statistics of the envelope, its in-phase and quadrature components, phase, and their time derivatives are obtained.     

Robustness of VS-MRAC with respect to unmodelled dynamics and external disturbances

A variable structure model reference adaptive controller (VS-MRAC) using only input and output measurements was recently proposed and shown to be globally asymptotically stable with superior transient behaviour and disturbance rejection properties. In this paper a singular perturbation approach is used in order to establish the robustness of the controller in the presence of unmodelled dynamics (parasitics) and disturbances. We develop a new Lyapunov-based technique to analyse the overall system and show that for sufficiently small parasitics the system remains stable and the output error is small in some sense.     

Decrease and inequalities of infant mortality in Salvador, 1980-1988

This study sought to describe the changes in mortality among infants under one year of age in different areas of the city of Salvador, Bahia, during the period 1980-1988. This was done using estimates of variation in two indicators: proportional infant mortality and the coefficient of infant mortality. Values for the first indicator were separated into low, intermediate, high, and very high quartiles for 1980 and then calculated again using 1988 data. The second indicator was derived from the estimated number of live births using the rate of 33.4/1,000 inhabitants for 1980 and 31.4/1,000 for the years thereafter. The results showed that infant mortality in that age group had declined over the period, but that at the end of the period inequalities persisted in the distribution of infant deaths, which confirmed that conditions remained adverse for certain segments of the population.