Determination du coefficient d'extinction molaire de OH− dans les verres fluores a base de metaux lourds

The extinction coefficient ? at 2.9 μm for OH in fluoride glasses is measured by determining the amount of HF evolved during heating of the glass under steam and the corresponding intensity of the OH absorption band. This coefficient is respectively equal to 31 litre mole^?1 cm^?1 for BTYbZ glass (15 BaF₂ - 29 ThF₄ - 28 YbF₃ - 28 ZnF₂) and 19.5 litre mole^?1 cm^?1 for BALLA glass (34 BaF₂ - 57 ZrF₄ - 4 AlF₃ - 5 LaF₃).     

Organic matter release in low temperature thermal treatment of biological sludge for reduction of excess sludge production.

Thermal treatment applied in association with a biological system allows for a significant reduction in excess sludge production (approximately 50%). In general, heat treatment is described as a sludge disintegration technique. This paper offers a thorough study on the impact of heat treatment, at temperatures below 100 degrees C, on the solubilisation of the sludge COD and its biodegradability. Discontinuous heating experiments were performed on activated and digested sludge. At all temperatures tested the released COD for digested sludge was systematically higher than that for activated sludge (15 and 40%, respectively, at 95 degrees C for 40 min of contact time). For the first 30 min, a 1st order kinetic, with respect to the residual COD, was systematically found. In the range of 40-95 degrees C, digested sludge had a lower activation energy than activated sludge (26 kcal/mol compared to 70-160 kcal/mol). COD solubilisation is thus more positively influenced by temperature in the case of activated sludge. This may be due to the significant difference in the ratio of protein/carbohydrate in digested and activated sludge (1-5 and 0.2-0.7, respectively). The increase in the COD/TKN ratio in the solubilised fraction after thermal treatment of activated sludge suggests a preferential solubilisation of proteins over carbohydrates. Respirometric tests performed on the solubilised COD showed that whatever the sludge origin, only 40-50% of released COD is biodegradable at a conventional hydraulic retention time (i.e., 24 h). Hence, heat treatment would act more through organic matter solubilisation rather than by a biodegradability increase.     

Electron escape time from single quantum wells

A theoretical model for electrons escaping a quantum well under the influence of an applied electric field is developed. Both the thermionic emission and tunneling components of the currents are calculated, taking into account the proper partitioning between the two currents. The group velocity for a nonuniform electron distribution within the quantum well, which is a function of position and energy, and the continuous energy dependence of the quantum well density of states is considered. A comparison between this model and previously reported experimental results are made which demonstrates excellent agreement     

Preparation and Characterization of Inorganic Fluorides—Fullerenes Compounds

Reaction of metallic fluorides: WF₆ TaF₅, NbF₅ and TiF₄ with C₆₀/C₇₀ extract was performed at appropriate temperatures. M0F₅ and BF₃ fluorides do not react. Chemical formulas based on mass uptake show MF_n/C₆₀ ratios up to 2.00. Compounds were analysed by means of X-ray diffraction, FT-IR and NMR spectroscopies. The presence of neutral fluorides and associated anionic species is put forward and it is shown that MF_n compounds do not act as fluorination agents. Electrical conductivity measurements are also presented.     

Perturbation of an elementary logic system submitted to the effects induced by a perturbing sine wave

Data transmission networks and systems are often subject to perturbations due to the fact that (low level) data signals are surrounded by perturbing electromagnetic fields. This paper presents and analyses information perturbing mechanisms. The authors examine data streams transmitted by an elementary system which represents the basis of any electronic device. We show the influence of technological families of cmos circuits and present a test method and bench to investigate the sensitivity of devices under test by means of statistical parameters.     

Reactivity of steam in exhaust gas catalysis III. Steam and oxygen/steam conversions of propane on a Pd/Al2O3 catalyst

A 1% Pd catalyst (38% dispersion) was prepared by impregnating a γ-alumina with palladium acetylacetonate dissolved in acetone. The behaviour of this catalyst in oxidation and steam reforming (SR) of propane was investigated. Temperature-programmed reactions of C₃H₈ with O₂ or with O₂ + H₂O were carried out with different stoichiometric ratios S(S =[O₂]/5[C₃H₈]). The conversion profiles of C₃H₈ for the reaction carried out in substoichiometry of O₂ (S < 1) showed two discrete domains of conversion: oxidation at temperatures below 350°C and SR at temperatures above 350°C. The presence of steam in the inlet gases is not necessary for SR to occur: there is sufficient water produced in the oxidation to form H₂ and carbon oxides by this reaction. Contrary to what was observed with Pt, an apparent deactivation between 310 and 385°C could be observed with Pd in oxidation. This is due to a reduction of PdO_x into Pd⁰, which is much less active than the oxide in propane oxidation. Steam added to the reactants inhibits oxidation while it prevents the reduction of PdO_x into Pd⁰. Compared to Pt and to Rh, Pd has a higher thermal resistance: no deactivation occurred after treatment up to 700°C and limited deactivation after treatment up to 900°C, provided that the catalyst is maintained in an oxygen-rich atmosphere during the cooling.     

Phase Equilibria in the Na2O-Cs2O-SiO2 System

The Na₂O-Cs2O-SiO₂ system has been investigated by means of a new differential thermal analysis apparatus. Two compounds have been observed for the first time in the metasilicate and disilicate joins. The CsNaSi₂O₅ disilicate melts congruently at 1217 K and the peritectic fusion of the CsNaSiO₃ metasilicate occurs at 1120 K.