基于状态空间法的电动机故障诊断和识别

电动机的初期故障信号一般较弱,不易辨别,而状态空间法在小信号的处理中灵敏度很高。为达到对电动机故障的诊断和识别,试图把状态空间法应用到对电动机的故障诊断中,先通过推导,从数学理论层面分析了状态空间法对于电动机故障信号的可辨别性,再使用Matlab软件搭建状态空间的辨别模型,把实验台测试的三组数据导入到模型中进行测试。测试的结果有力地证明了此方法的可行性,并能克服快速傅里叶变换(FFT)中数据采集量较大、分辨率不高的缺点。     

低渗透油藏生产井关井测压时间的计算与应用

低渗透油藏的生产井压裂后，在单井试油试采过程中，压力恢复测试关井时间不同，其中有些井压力恢复曲线不能出现边界反应段，渗流不能反映地层中真实流动特征。针对这种情况，基于长庆绥靖油田塞39井区长：低渗透油藏大量试井和实际生产资料，利用现代试井解释理论，研究合理关井时间的界限及其计算方法。结果表明，当油井关井测压时间达到3倍地层径向流开始出现的时间后，利用此时的压力数据解释地层参数和地层压力，其结果的误差小于5％，同时能较准确地判断边界类型。计算的理论曲线和霍纳法解释值非常接近，对于塞39井区，若预先知道某生产井地层有效渗透率值，可从理论曲线查出压力恢复试井的关井时间，否则，建议按照该井区地层有效渗透率（大约在6mD左右），将不稳定试井测试时间控制在25d以上为宜。图4表3参14     

Transient aspects of inner wall temperatures at different spatial positions in fluidized bed evaporators

In this work, the instantaneous data of inner wall temperatures obtained at given axial positions but for different heated tubes or at various axial positions but at the same heated tube in a tube-bank fluidized bed evaporator with a vapor–liquid–solid external natural circulation flow were analyzed by employing linear and nonlinear time series analysis methods, including correlation dimension and Kolmogorov entropy analyses besides time domain, power spectrum and autocorrelation analyses. It is found that nonlinear characteristics of the wall temperature time series vary with spatial position in the evaporator at given operation conditions, and thus the multi-phase flow boiling behavior. However, the signals obtained at given axial position but different heated tubes in the evaporator exhibit more similar nonlinear evolution behavior, and those measured in the same heated tube but at different axial heights in the evaporator undergo more distinct nonlinear dynamic behavior. Multi-scale phenomena in different spatial positions are also found and discussed. These transient aspects of inner wall temperatures are closely related to the average holdup of solid particles and motion of vapor bubbles in vapor–liquid–solid flow. These results can provide some valuable information on the system modeling and controlling from the point of view of nonlinearity.     

Effects of chemical and plasma surface treatments on the O2-annealed Ni/Au contact to p-Gan

The effects of boiling Aqua Regia (AQ), N₂/Cl₂ plasma followed by AQ and O₂ plasma followed by AQ surface treatments prior to Ni/Au (20 nm/20 nm) metallization to p-GaN:Mg (∼ 3 × 10¹⁷ cm^− 3) have been investigated. N₂/Cl₂ plasma was employed in a bid to lower the Ga/N and O/Ga ratios of the GaN surface to improve the contact properties to p-GaN, while O₂ plasma was employed as an alternative to incorporate O into the Ni/Au system. Results show that a low Ga/N ratio does not necessarily correspond to a better contact. The positive effect of O₂ over N₂ anneal is observed only for the AQ-treated sample, although the mechanisms responsible for its positive effect: NiO formation and Ni/Au layer-reversal were observed for all O₂-annealed contacts. We conclude that the effect of O₂ anneal on the Ni/Au contact is dependant on the p-GaN surface prior to metallization.     

电流变体特性及电流变体应用器件的进展

本文详细评述了电流变体(ERF)材料的组成、工作机理及其流变力学性能,提出以Bingham塑性体来近似描述电流变体的流变特性,综述了电流变体在智能材料、汽车离合器、液压阀门等器件中的应用,给出了含电流变体的双层智能复合材料梁单层、双层加电状态对其振动特性的影响,设计了含电流变体的主动控制式减振器,并对其在外加电场作用下的减振性能进行了评价。     

数据处理系统性能评价的简单理论模型

提出了一个简单的理论模型．旨在为数据处理系统的性能评价提出一个理论框架．以此框架为基础，可形成实用的简单评估方法．该模型只含两个参数，它们是统计量，可用统计方法确定．     

Tree-based partitioning of date for association rule mining

The most computationally demanding aspect of Association Rule Mining is the identification and counting of support of the frequent sets of items that occur together sufficiently often to be the basis of potentially interesting rules. The task increases in difficulty with the scale of the data and also with its density. The greatest challenge is posed by data that is too large to be contained in primary memory, especially when high data density and/or low support thresholds give rise to very large numbers of candidates that must be counted. In this paper, we consider strategies for partitioning the data to deal effectively with such cases. We describe a partitioning approach which organises the data into tree structures that can be processed independently. We present experimental results that show the method scales well for increasing dimensions of data and performs significantly better than alternatives, especially when dealing with dense data and low support thresholds. Shakil Ahmed received a first class BSc (Hons) degree from Dhaka University, Bangladesh, in 1990; and an MSc (first class), also Dhaka University, in 1992. He received his PhD from The University of Liverpool, UK, in 2005. From 2000 onwards he is a member of the Data Mining Group at the Department of Computer Science of the University of Liverpool, UK. His research interests include data mining, Association Rule Mining and pattern recognition. Frans Coenen has been working in the field of Data Mining for many years and has written widely on the subject. He received his PhD from Liverpool Polytechnic in 1989, after which he took up a post as a RA within the Department of Computer Science at the University of Liverpool. In 1997, he took up a lecturing post within the same department. His current Data Mining research interests include Association rule Mining, Classification algorithms and text mining. He is on the programme committee for ICDM'05 and was the chair for the UK KDD symposium (UKKDD'05). Paul Leng is professor of e-Learning at the University of Liverpool and director of the e-Learning Unit, which is responsible for overseeing the University's online degree programmes, leading to degrees of MSc in IT and MBA. Along with e-Learning, his main research interests are in Data Mining, especially in methods of discovering Association Rules. In collaboration with Frans Coenen, he has developed efficient new algorithms for finding frequent sets and is exploring applications in text mining and classification.     

ELEVATED TEMPERATURE FRACTURE OF PARTICULATE-REINFORCED ALUMINUM PART I: FRACTURE TOUGHNESS

Abstract—The plane-strain initiation and growth fracture toughnesses of powder-metallurgy-processed, SiC particulate-reinforced 2009 plate were measured at temperatures from 25°C to 316°C. Initiation toughness from electrical potential monitoring ( K _JICi) is 18 MPa°m at 25°C, and is nearly constant to 220°C before decreasing sharply to 6 MPa°m at 316°C. Growth toughness, given by the tearing modulus ( T _R), is less than 3 from 25°C to 125°C, and increases dramatically above 200°C. The magnitude and temperature dependence of initiation toughness depend on detection of the critical fracture event. Standard measures of toughness K _IC and K _JIC exceed K _JICi and increase to a plateau with increasing temperature. The fracture mode for the composite is microvoid nucleation, growth and coalescence at all temperatures. Void nucleation is associated with SiC; such particles both crack and create stress and plastic strain concentrations that rupture the interface or adjacent matrix, particularly at corners. Matrix plasticity and cavitation increase with increasing temperature. Void growth is regular at all temperatures, but limited by adjacent SiC particles. Both K _JICi and T _R are governed by the temperature-dependent crack-tip plastic stress and strain fields, and the intrinsic damage resistance of the composite microstructure.     

取向硅钢晶粒取向的不均匀分布及其检测

利用X射线衍射和背散射电子衍射检测了取向硅钢板表层和中心部位的宏观织构和微观晶粒取向分布,观察了相应的晶粒组织。结果表明,二次再结晶不彻底的成品钢板的表面会残留非{110}<001>取向的小晶粒,并影响钢板的软磁性能。取向硅钢板表层的晶粒取向分布能够在一定程度上反映出钢板的质量,因此可以借助X射线表面无损检测技术发展取向硅钢织构的工业在线检测技术。