Embedded deterministic test for low-cost manufacturing

You have probably heard that BIST takes too long and its fault coverage is low, and that deterministic test requires too many patterns. This article shows how on-chip compression and decompression techniques provide high fault coverage with low test times.     

Structural,Raman, and Dielectric Studies on Multiferroic Mn‐doped Bi1−xLaxFeO3 Ceramics

Multiferroic Bi_1?xLa_xFeO₃ [BLFO (x)] ceramics with x = 0.10–0.50 and Mn‐doped BLFO (x = 0.30) ceramics with different doping contents (0.1–1.0 mol%) were prepared by solid‐state reaction method. They were crystallized in a perovskite phase with rhombohedral symmetry. In the BLFO (x) system, a composition (x)‐driven structural transformation (R3c→C222) was observed at x = 0.30. The formation of Bi₂Fe₄O₉ impure phase was effectively suppressed with increasing the x value, and the rhombohedral distortion in the BLFO ceramics was decreased, leading to some Raman active modes disappeared. A significant red frequency shift (~13 cm^?1) of the Raman mode of 232 cm^?1 in the BLFO ceramics was observed, which strongly perceived a significant destabilization in the octahedral oxygen chains, and in turn affected the local FeO₆ octahedral environment. In the Mn‐doped BLFO (x = 0.30) ceramics, the intensity of the Raman mode near 628 cm^?1 was increased with increasing the Mn‐doping content, which was resulted from an enhanced local Jahn–Teller distortions of the (Mn,Fe)O₆ octahedra. Electron microscopy images revealed some changes in the ceramic grain sizes and their morphologies in the Mn‐doped samples at different contents. Wedge‐shaped 71° ferroelectric domains with domain walls lying on the {110} planes were observed in the BLFO (x = 0.30) ceramics, whereas in the 1.0 mol% Mn‐doped BLFO (x = 0.30) samples, 71° ferroelectric domains exhibited a parallel band‐shaped morphology with average domain width of 95 nm. Dielectric studies revealed that high dielectric loss of the BLFO (x = 0.30) ceramics was drastically reduced from 0.8 to 0.01 (measured @ 10⁴ Hz) via 1.0 mol% Mn‐doping. The underlying mechanisms can be understood by a charge disproportion between the Mn⁴⁺ and Fe²⁺ in the Mn‐doped samples, where a reaction of Mn⁴⁺ + Fe²⁺→Mn³⁺ + Fe³⁺ is taken place, resulting in the reduction in the oxygen vacancies and a suppression of the electron hopping from Fe³⁺ to Fe²⁺ ions effectively.     

Interaction of F-actin with synthetic peptides spanning the loop region of human cardiac beta-myosin heavy chain containing Arg403

The atomic model of the F-actin-myosin subfragment 1 complex (acto-S-1) from skeletal muscle suggests that the transition of the complex from a weakly to a strongly binding state, generating mechanical force during the contractile cycle, may involve the attachment of the upper 50-kDa subdomain of myosin subfragment 1 (S-1) to the interface between subdomains 1 and 3 of actin. For the human cardiac myosin, this putative interaction would take place at the ordered loop including Arg403 of the beta-heavy chain sequence, a residue whose mutation into Gln is known to elicit a severe hypertrophic cardiomyopathy caused by a decrease of the rate of the actomyosin ATPase activity. Moreover, in several nonmuscle myosins the replacement of a Glu residue within the homolog loop by Ser or Thr also results in the reduction of the actomyosin ATPase rate that is alleviated by phosphorylation. As an approach to the characterization of the unknown interaction properties of F-actin with this particular S-1 loop region, we have synthesized four 17-residue peptides corresponding to the sequence Gly398-Gly414 of the human beta-cardiac myosin. Three peptides included Arg403 (GG17) or Gln403 (GG17Q) or Ser409 (GG17S) and the fourth peptide (GG17sc) was a scrambled version of the normal GG17 sequence. Using fluorescence polarization, cosedimentation analyses and photocross-linking, we show that the three former peptides, but not the scrambled sequence, directly associate in solution to F-actin, at a nearly physiological ionic strength, with almost identical affinities (Kd approximately 40 microM). The binding strength of the F-actin-GG17 peptide complex was increased fivefold (Kd = 8 microM) in the presence of subsaturating concentrations of added skeletal S-1 relative to actin, without apparent competition between the peptide and S-1. Each of the three actin-binding peptides inhibited the steady-state actin-activated MgATPase of skeletal S-1 by specifically decreasing about twofold the Vmax of the reaction without changing the actin affinity for the S-1-ATP intermediate. Cosedimentation assays indicated the binding of about 0.65 mol peptide/mol actin under conditions inducing 70% inhibition. Collectively, the data point to a specific and stoichiometric interaction of the peptides with F-actin that uncouples its binding to S-1 from ATP hydrolysis, probably by interfering with the proper attachment of the S-1 loop segment to the interdomain connection of actin.     

Er doped waveguide amplifiers written with femtosecond laser in germanate glasses

The authors report the fabrication and characterization of active waveguides in GeO₂–PbO–Ga₂O₃ glass samples doped with Er³⁺, written with a femtosecond laser delivering pulses of 150 fs duration at 1 kHz repetition rate. Permanent refractive index change was obtained and waveguides were formed under different laser pulse energies and scan velocities. The passive and active optical properties of the waveguides were investigated. The minimum value of propagation loss was of 4.8 dB/cm. Optical amplification at 1.5 μm under 980 nm excitation was observed showing a maximal internal gain of 2.7 dB/cm.     

Fluoridation in Anglesey 1993: a clinical study of dental caries in 5-year-old children who had experienced sub-optimal fluoridation

Several studies since the commencement of fluoridation in 1955 have demonstrated over 50% reduction in mean dmft for 5-year-old Anglesey children in comparison with local control groups. From 1987 fluoridation became intermittent and in 1991 it was terminated. In the present study, carried out in 1993, the total number of children examined was 725 (88.4% of the entire population of 5-year-old school children), of whom 498 had continually resided in specific water distribution zones. The mean dmft for the entire number examined was 2.01 (SD = 3.27). For those who had experienced fluoridation during approximately 35% of their lives (n = 230) it was 1.81 (SD = 2.86) and for those who had experienced fluoridation for less than 10% of their lives (n = 268) it was 2.28 (SD = 3.48). In 1987/88, the last year of optimal fluoridation, the mean dmft of Anglesey 5-year-old children was 0.80 (SD = 1.43) and for those resident on the non-fluoridated Gwynedd mainland it was 2.26 (SD = 3.17). The study demonstrates the serious consequences for dental health when fluoridation is withdrawn and how difficult it will be to reach dental health targets in North Wales without fluoridation.     

Proper orthogonal decomposition and modal analysis for acceleration of transient FEM thermal analysis

A method of reducing the number of degrees of freedom and the overall computing times in finite element method (FEM) has been devised. The technique is valid for linear problems and arbitrary temporal variation of boundary conditions. At the first stage of the method standard FEM time stepping procedure is invoked. The temperature fields obtained for the first few time steps undergo statistical analysis yielding an optimal set of globally defined trial and weighting functions for the Galerkin solution of the problem at hand. Simple matrix manipulations applied to the original FEM system produce a set of ordinary differential equations of a dimensionality greatly reduced when compared with the original FEM formulation. Using the concept of modal analysis the set is then solved analytically. Treatment of non‐homogeneous initial conditions, time‐dependent boundary conditions and controlling the error introduced by the reduction of the degrees of freedom are discussed. Several numerical examples are included for validation of the approach. Copyright © 2004 John Wiley & Sons, Ltd.     

3D seismic and formation micro-imager (FMI) integrated study to delineate depositional pattern of Abu Madi (Upper Miocene) clastic reservoir rocks in El-Wastani gas field,onshore Nile Delta,Egypt

Ten wells (EW-4, EW-5, EW-6, EW-7, EW-8, EW-9, EW-10, EW-12, EW-13 and EW-15) were interpreted using the composite well logs, data of core analysis, gamma-ray logs, formation micro-imager logs (FMI), and 3D seismic data in SEGY format to understand the stratigraphy of the onshore, Nile Delta, Egypt.The amplitude analysis of 3-D seismic horizon slice of Lower Abu Madi rock unit together with the lithostratigraphic correlation through the study area depending on the gamma-ray log “HSGR” (left to right increasing), and the identification of type of bed geometry, nature of bed contacts, type of the sedimentary structures and the dominant formative paleocurrents by using some available borehole micro-resistivity images (FMI) and core photos. All of these techniques are used together to define the different depositional facies and depositional environment of the Messinian clastics (Lower Abu Madi rock unit), which is considered to be the main reservoir in the El-Wastani gas field, onshore Nile Delta, Egypt.The present study of depositional pattern of the Upper Miocene clastics reservoir (Lower Abu Madi rock unit) revealed that it is represented by high sinuous meandering channels or paleo-valley and three types of fluvial facies were defined; channel fill, channel margin, and floodplain basin.     

A systematic literature review on Internet of things in education: Benefits and challenges

With close to 20.4 billion devices connected to the Internet to be deployed by 2020, Internet of things (IoT) is already being leveraged in diverse sectors. Now, because of the ubiquitous nature of IoT devices, schools and academic institutions are looking to incorporate IoT in educational activities. With the increased use of IoT in the education domain, it is of utmost importance to study how this technology with its distinguished system functions such as sensing and decision making can support and challenge the pedagogical processes for all interrelated actors (faculty, students, and staff) as well as all involved assets (e.g., libraries, classrooms, and labs). Although there have been several contributions on the inclusion of IoT into the education domain, there is still a lack of consolidated and coherent views on this subject. Hence, we are motivated to close the gap of knowledge and embarked on mapping out the published studies available. This study presents the results of a systematic literature review focusing on the benefits and the challenges faced in education in integrating IoT into the curriculum and educational environments. Different mapping views of the extracted studies are provided as long as a summary of the already implemented tools and a list of gap research questions yet to be investigated.