Oxidation of doped europium in BaMgAl10O17 by annealing studied by x‐ray‐absorption fine‐structure measurements

Abstract— We studied the influence of annealing in air on doped europium in BaMgAl₁₀O₁₇ by performing x‐ray absorption fine‐structure measurements. We determined the oxidation of doped divalent europium by annealing in air at over 500°C. The interatomic distance between the europium and the surrounding oxygen atoms was compressed by oxidation. It also appears that the oxidation process of europium is determined by the diffusion of oxygen into BaMgAl₁₀O₁₇.     

Transmittance and cathodoluminescence of AlN ceramics sintered with Ca3Al2O6 as sintering additive

Aluminum nitride ceramics were prepared by sintering with 0–4.8 mass% of Ca₃Al₂O₆ (C₃A) as a sintering additive. The transmittance in the range of 260–550 nm increased with increasing amount of C₃A. The cathodoluminescence intensity attributed to oxygen-induced defects decreased with increasing amount of C₃A. From the results, the increase of the transmittance in the range of 260–550 nm was considered to be related to the decrease of the oxygen-induced defect density.     

A sensorless brushless dc motor system

This paper describes a brushless dc motor system without position or speed sensor. The brushless motor consists of a permanent magnet synchronous motor and a voltage-source inverter capable of controlling the amplitude and frequency of voltage. The rectangular-shaped stator current with a conducting interval of 120° (electrical) is controlled to be in phase with the trapezoidal back electromotive force. This results in producing maximum torque. Variable speed is achieved by adjusting the average motor voltage similarly to chopper control of dc motors. In this paper, two sensorless position detecting methods, i.e., an “indirect method” suited for the lower-speed range and a “direct method” suited for the higher-speed range are proposed. The combination of the two makes it possible to detect the rotor position over a wide-speed range. Furthermore, a speed-sen-sorless PLL control is proposed in applying the principle of the direct method. Experimental results obtained from a prototype brushless dc motor are shown to confirm the validity of the sensorless drive. The starting procedure of the motor also is discussed because it is impossible to detect the rotor position at a standstill.     

Simulation study of eutrophication in Hiroshima Bay: Simulation of particulate and dissolved organic matter using cyclic transformation of carbon

A phytoplankton model, which includes a carbon cycle combined with a constant current obtained by the computation of tidal currents, was applied to the coastal region (Hiroshima Bay, Japan). The transformation rate constants for the carbon cycle were experimentally evaluated.The seasonal variations of particulate and dissolved organic matter by the simulation model were reasonably consistent with the field data. Carbon concentration increased by primary production in the upper layer was approx. 10 times that augmented by loading of carbon from land at the shore in summer. Sinking plays an important role in the elimination of particulate organic matter. On the other hand, horizontal advection and turbulent diffusion are important factors for the diminution of dissolved organic matter.     

Distinctive combustion stages of single heavy oil droplet under microgravity

This report presents an investigation on the combustion of single droplets comprised of heavy oil and oil mixtures blending diesel light oil (LO) and a heavy oil residue (HOR). The tests were conducted in a microgravity facility that offered 10 s of free-fall time. Fine wire thermocouples supported the droplets, resulting in a measurement of droplet temperature history. Additional data were the droplet and flame size history. The results identified four distinctive burning stages between ignition and extinction for heavy oil (C class) and HOR-LO blends. They are, in succession, the start-up, inner evaporation, thermal decomposition (pyrolysis) and polymerization stages. The start-up stage denoted an initial transient period, where the LO components burned from the droplet surface and the droplet temperature increased rapidly. The latter three stages featured pronounced droplet swellings and contractions caused by fuel evaporation and decomposition inside the droplet. An evaporation temperature demarcated the start-up stage from the inner evaporation stage, and this temperature corresponded to a plateau in the temperature history of the droplet. Two additional temperatures, termed the decomposition and polymerization temperatures, indicated the ends of the evaporation and decomposition stages. These temperatures were similarly identified by plateaus or inflection points in the time-temperature diagram. The evaporation temperature gradually decreased with increasing the initial LO mass fraction in the droplet, whereas the other two temperatures were almost independent of the oil composition. All three temperatures increased with decreasing initial droplet diameter, but the dependence was very slight. Based on the results, the combustion of heavy oil droplets appears to be dominated by a distillation-like vaporization mechanism, because of the rapid mass transport within the droplets caused by the disruptive burning.     

Preparation of Self-Standing, Submillimeter-Thick Porous Titania Films with Anatase Nanocrystallites Using Evaporation-Induced Self-Assembly

Self-standing transparent submillimeter-thick (∼0.34 mm) mesoporous titania films were prepared using the evaporation-induced self-assembly (EISA) of a triblock copolymer template and titanium tetraethoxide. Performing EISA at low temperature and low humidity improved the transparency and continuity of the films. As synthesized films had a well-defined hexagonal mesostructure and the existence of both amorphous titania and anatase nanocrystallites (2 nm) was confirmed. The films that were calcined at 400°C were composed of anatase nanocrystallites (14–16 nm) and had a BET surface area of 90 m² g⁻¹ with 13-nm pores. The films were characterized using XRD, FE-SEM, TEM, and N² adsorption–desorption measurements. An erratum to this article can be found at     

Quantitative structural analysis of twin boundary in alpha-Zn7Sb2O12 using HAADF STEM method

The structure and composition of the 1/4{110} twin boundary in alpha-Zn7Sb2O12 have been determined by using quantitative high-angle annular dark field scanning transmission electron microscopy (HAADF STEM) analysis. The noise in the experimental HAADF STEM images is reduced by using the maximum entropy method and average processing, and the parameters used in dynamical simulations are experimentally determined. From the analysis, it has been found that octahedral sites in the twin boundary slightly shift parallel to the [110] direction, and a reduction of the Sb concentration at the octahedral sites on the plane adjacent to the twin boundary was detected. The reduction was measured from three regions in the same twin boundary, and the Sb concentrations were 4 +/- 3, 8 +/- 3 and 19 +/-2 at% from 33 at%.     

A 63-year-old man with progressive cauda equina/conus medullaris syndrome

BACKGROUND: This article presents results of the acute treatment phase of a 2-site study comparing cognitive behavioral group therapy (CBGT) and treatment with the monoamine oxidase inhibitor phenelzine sulfate for social phobia. METHODS: One hundred thirty-three patients from 2 sites received 12 weeks of CBGT, phenelzine therapy, pill placebo administration, or educational-supportive group therapy (an attention-placebo treatment of equal credibility to CBGT). The "allegiance effect," ie, the tendency for treatments to seem most efficacious in settings of similar theoretical orientation and less efficacious in theoretically divergent settings, was also examined by comparing responses to the treatment conditions at both sites: 1 known for pharmacological treatment of anxiety disorders and the other for cognitive behavioral treatment. RESULTs: After 12 weeks, phenelzine therapy and CBGT led to superior response rates and greater change on dimensional measures than did either control condition. However, response to phenelzine therapy was more evident after 6 weeks, and phenelzine therapy was also superior to CBGT after 12 weeks on some measures. There were few differences between sites, suggesting that these treatments can be efficacious at facilities with differing theoretical allegiances. CONCLUSIONS: After 12 weeks, both phenelzine therapy and CBGT were associated with marked positive response. Although phenelzine therapy was superior to CBGT on some measures, both were more efficacious than the control conditions. More extended cognitive behavioral treatment and the combination of modalities may enhance treatment effect.     

Development of a pulse control-type MEMS microrobot with a hardware neural network

This article presents the micro-electro-mechanical systems (MEMS) microrobot which demonstrates locomotion controlled by hardware neural networks (HNN). The size of the microrobot fabricated by the MEMS technology is 4 × 4 × 3.5 mm. The frame of the robot is made of silicon wafer, and it is equipped with a rotary-type actuator, a link mechanism, and six legs. The rotary-type actuator generates rotational movement by applying an electrical current to artificial muscle wires. The locomotion of the microrobot is obtained by the rotation of the rotary-type actuator. As in a living organism, the HNN realized robot control without using any software programs, A/D converters, or additional driving circuits. A central pattern generator (CPG) model was implemented as an HNN system to emulate the locomotion pattern. The MEMS microrobot emulated the locomotion method and the neural networks of an insect with the rotary-type actuator, the link mechanism, and the HNN. The microrobot performed forward and backward locomotion, and also changed direction by inputting an external trigger pulse. The locomotion speed was 0.325 mm/s and the step width was 1.3 mm.     

Extremely localized interaction in a market model

The model of self-organized criticality (SOC) is a useful tool to understand the complexity of natural systems in the form of the artificial life and the artificial market. However, SOC remains the question what guarantees the criticality even though the natural systems seem to keep itself in the critical state. In this paper, we focus on the locality of interaction in zero-intelligence plus (ZIP) model. The extremely localized interaction changes the behavior of the ZIP model from equilibrium to intermittency. Although the original ZIP model falls into unstable with some noise, extremely localized interaction model archives robust intermittency against the noise parameter. Further, the statistical property of intermittent behavior shows the power-law nature.