Anomalies of the tracheobronchial tree in patients with esophageal atresia

Bone marrow examination revealed a lipid-laden histiocytosis in seven patients undergoing long-term total parenteral nutrition necessitated by extensive short-bowel surgical resection. Clinical abnormalities occurred during this treatment which required bone marrow examination. These included hepatosplenomegaly and peripheral blood cytopenia; the median time to the detection of these abnormalities was 64 months. The most striking change within the bone marrow was the presence of many pigment-laden histiocytes which had the typical morphology of sea-blue histiocytes seen in the so-called idiopathic sea-blue histiocyte syndrome. The occurrence of sea-blue histiocytosis in the bone marrow in association with long-term parenteral nutrition for short-bowel syndrome has not, to our knowledge, been reported previously and should now be considered in the differential diagnosis of bone marrow sea-blue histiocytosis.     

Augmentation of boiling heat transfer from horizontal cylinder to liquid by movable particles

This paper presents a series of experimental results on a passive augmentation technique of boiling heat transfer by supplying solid particles in liquid. A cylindrical heater 0.88 mm in diameter is placed in saturated water, in which a lot of mobile particles exist, and the nucleate and film boiling heat transfer characteristics are measured. Particle materials used were alumina, glass, and porous alumina, and the diameter ranged from 0.3 mm to 2.5 mm. Particles are fluidized by the occurrence of boiling without any additive power, and the heat transfer is augmented. The maximum augmentation ratio obtained in this experiment reaches about ten times the heat transfer coefficient obtained in liquid alone. The augmentation ratio is mainly affected by the particle material, diameter, and the height of the particle bed set at no boiling condition. The augmentation mechanism is discussed on the basis of the experimental results. © 2001 Scripta Technica, Heat Trans Asian Res, 31(1): 28–41, 2002     

66/77-kV C-GIS using composite insulation in SF6 gas

A second-generation model of cubicletype gas-insulated switchgear (C-GIS) with composite insulation incorporating SF₆ gas has been developed. The design does not require a gas process in field assembly; it has high reliability and its installation is more rapid; and a further reduction in size is achieved. The design principles are described in detail.     

Balanced corpus of contemporary written Japanese

The balanced corpus of contemporary written Japanese (BCCWJ) is Japan’s first 100 million words balanced corpus. It consists of three subcorpora (publication subcorpus, library subcorpus, and special-purpose subcorpus) and covers a wide range of text registers including books in general, magazines, newspapers, governmental white papers, best-selling books, an internet bulletin-board, a blog, school textbooks, minutes of the national diet, publicity newsletters of local governments, laws, and poetry verses. A random sampling technique is utilized whenever possible in order to maximize the representativeness of the corpus. The corpus is annotated in terms of dual POS analysis, document structure, and bibliographical information. The BCCWJ is currently accessible in three different ways including Chunagon a web-based interface to the dual POS analysis data. Lastly, results of some pilot evaluation of the corpus with respect to the textual diversity are reported. The analyses include POS distribution, word-class distribution, entropy of orthography, sentence length, and variation of the adjective predicate. High textual diversity is observed in all these analyses.     

Preparation of ferroelectric Ba(Ti/sub 0.85/Sn/sub 0.15/)O/sub 3/ thin films by metal-organic decomposition

Ferroelectric Ba(Ti/sub 0.85/Sn/sub 0.15/)O/sub 3/ (BTS/sub 15/) thin film is newly prepared on the Pt/Ti/SiO/sub 2//Si substrate by metal-organic decomposition. The firing condition is determined by thermogravimetric and differential thermal analysis. The BTS/sub 15/ thin film with a flat surface and uniform thickness is obtained by spin coating in N/sub 2/ atmosphere that avoids moisture. The BTS/sub 15/ film has a perovskite phase and a preferential [110] texture. It is also found that the crystalline structure is cubic at 24/spl deg/C with a lattice constant of 4.01 /spl Aring/, and a grain size of about 30 nm was estimated by Scherrer equation and SEM image. From P-E hysteresis loop at 20/spl deg/C, the polarization at E=0 and the electric field at P=0 are found to be 1.07 /spl mu/C/cm/sup 2/ and 24.0 kV/cm, respectively. It is observed that the dielectric constant decreases monotonously from about 830 to 630 with increasing temperature ranging from 20/spl deg/C to 50/spl deg/C. Finally, it is found that the BTS/sub 15/ thin film shows a sufficient ferroelectricity and is an attractive material for functional ferroelectric devices, such as thermal-type infrared sensors.     

Studies on analysis of terpene resin in imported chewing gums

We have developed an analytical method for terpene resins in chewing gum. The fraction including terpene resins was prepared by means of hexane extraction and two silica gel column chromatography treatments (hexane and ethyl acetate) from chewing gum. The terpene resin fraction was analyzed with LC/MS and IR. The terpene resins are mixtures of polymeric pinene and/or limonene, which have a monomer molecular weight of 136. The MS spectrum of the terpene resin peak on the LC/MS total ion chromatogram showed protonated molecular ion (M + H)+ peaks at intervals of m/z 136, characteristic of a complex mixture of polyterpenes. IR spectroscopy is a suitable technique to identify the terpene resin type, ie., pinene or limonene. When the method was applied to imported chewing gum sold in Japan, terpene resins were clearly detected.     

The effects of point defects on transmission coefficients in two-dimensional piezoelectric phononic crystals

Based on finite-difference time-domain(FDTD) method,the wave propagation and localization in two-dimensional defect-containing piezoelectric phononic crystals are investigated when the mechanical-electrical coupling is taken into account.The characteristics of localized defect modes are studied,and the effects of the number and direction of defects on the defect modes and transmission coefficients are discussed.Numerical results of defect modes and transmission coefficients are presented for BaTiO3/polymer piezocomposite,and from which we can see that the number and direction of defects have pronounced effects on the defect modes and transmission coefficients.The results also show the existence of elastic wave localization in piezoelectric phononic crystals containing defects.     

Novel anion exchange membranes having fluorocarbon backbone: Preparation and stability

Anion exchange membranes with excellent durability were prepared by chemical modification of Nafion. The modification was achieved by transformation of the sulfonic acid group into quaternary ammonium group. Namely, Nafion membrane was first converted into an amide-type membrane. Reduction of the carbonxyl group to methylene followed by quaternarization with alkyl iodide resulted in the formation of an anion exchange membrane. The electric resistance of the resulting membranes depends on the equivalent weight of the starting membranes (4.4–6.0 Ω cm² in 0.5N NaCl). The characteristics of the membranes are the excellent stability toward chemical substances such as organic solvents, oxidizing agents, acids, etc. For example, the membranes are stable in aqueous saturated chlorine solution at 60°C for 1000 hr.     

Morphology‐dependent electrocatalytic activity of nanostructured Pt/C particles from hybrid aerosol–colloid process

An optimum nanostructure and pore size of catalyst supports is very important in achieving high catalytic performances. In this instance, we evaluated the effects of various carbon nanostructures on the catalytic performances of carbon‐supported platinum (Pt/C) electrocatalysts experimentally and numerically. The Pt/C catalysts were prepared using a hybrid method involving the preparation of dense, hollow, and porous nanostructured carbon particle via aerosol spray pyrolysis followed by microwave‐assisted Pt deposition. Electrochemical characterization of the catalysts showed that the porous Pt/C catalyst gave the best performance; its electrochemical surface area was much higher, more than twice than those of hollow or dense Pt/C. The effects of pore size on electrocatalysis were also studied. The results showed the importance of a balance between mesopores and macropores for effective catalysis with a high charge transfer rate. A fluid flow model showed that good oxygen transport contributed to the catalytic activity. © 2015 American Institute of Chemical Engineers AIChE J, 62: 440–450, 2016