Dynamic probe of ZnTe(110) surface by scanning tunneling microscopy

The reconstructed surface structure of the II–VI semiconductor ZnTe (110), which is a promising material in the research field of semiconductor spintronics, was studied by scanning tunneling microscopy/spectroscopy (STM/STS). First, the surface states formed by reconstruction by the charge transfer of dangling bond electrons from cationic Zn to anionic Te atoms, which are similar to those of IV and III–V semiconductors, were confirmed in real space. Secondly, oscillation in tunneling current between binary states, which is considered to reflect a conformational change in the topmost Zn–Te structure between the reconstructed and bulk-like ideal structures, was directly observed by STM. Third, using the technique of charge injection, a surface atomic structure was successfully fabricated, suggesting the possibility of atomic-scale manipulation of this widely applicable surface of ZnTe.     

Aging response of the young’s modulus and mechanical properties of Ti-29Nb-13Ta-4.6Zr for biomedical applications

Alloys for implant devices require improved strength but a reduced Young’s modulus, in order to become mechanically more compatible with adjacent bone tissues. In this study, a new metastable β-type titanium alloy, Ti-29Nb-13Ta-4.6Zr (wt pct), was subjected to aging treatment to produce different microstructures, and the resulting mechanical properties, including the Young’s modulus, were measured. The Young’s modulus of this alloy is found to be sensitive to microstructures generated by various heat treatments. For microstructures varying from (α + β) to (α + β + ω) and (β + ω), the Young’s modulus increases with an accompanying increase in tensile strength and hardness, but decreases in ductility. The (β + ω) microstructure has a low strength, high modulus, and poor ductility and cannot be used for biomedical applications. For an (α + β) microstructure, the volume fraction of the phases is shown to be the main factor that determines the mechanical properties.     

A 322 MHz random-cycle embedded DRAM with high-accuracy sensing and tuning

A 16 Mb embedded DRAM macro in a fully CMOS logic compatible 90 nm process with a low noise core architecture and a high-accuracy post-fabrication tuning scheme has been developed. Based on the proposed techniques, 61% improvement of the sensing accuracy is realized. Even with the smallest 5 fF/cell capacitance, a 322 MHz random-cycle access while 32 ms data retention time which contributes to save the data retention power down to 60 /spl mu/W are achieved.     

Efficacy of interferons in treating children with chronic hepatitis C

Twenty-two children with chronic hepatitis serologically positive for hepatitis C virus (HCV) were treated with interferon-alpha (IFN-alpha). Liver biopsy showed chronic active hepatitis in 13 and chronic persistent hepatitis in 9 patients. A sustained clearance of HCV was observed in 8/22 children 12 months after the administration of IFN-alpha for 26 weeks, associated with normalization of HCV core antibody. Of these eight patients six had HCV genotype III and two HCV genotype II or IV. Hepatitis relapsed in seven other patients after completion of IFN-alpha with an increase in HCV core antibody titre, five with HCV genotype II, and two with HCV genotype III or IV. A second course of IFN-alpha suppressed the reactivation of HCV in all seven patients. Three of seven responders who relapsed after the first course remained negative for HCV RNA 12 months after their second course of IFN-alpha. However, the remaining four patients with HCV genotype II again relapsed after completing their second course of IFN-alpha. Seven children with the HCV genotype II resistant to IFN, including 8 weeks of IFN-beta administration, and showed no significant reduction in HCV core antibody titre. CONCLUSION: The genotype of HCV (III) and a reduction in the core antibody titre appear to be useful parameters for predicting the response to IFN-alpha therapy.     

Mutational analysis of amiloride sensitivity of the NhaA Na+/H+ antiporter from Vibrio parahaemolyticus

The activity of the NhaA Na+/H+ antiporter of Vibrio parahaemolyticus is inhibited by amiloride. We found an amino acid sequence in the NhaA that was identical to a putative amiloride binding domain of the Na+/H+ exchanger in mammalian cells. We constructed mutant NhaAs that had amino acid substitutions in the putative amiloride binding domain by site-directed mutagenesis. These include V62L (Val62 replaced by Leu), F63Y, F64Y, and L65F. Most mutant NhaAs showed decreased sensitivity for amiloride. Among these, the F64Y mutant NhaA showed the least amiloride sensitivity, with a Ki value 7 to 10 times greater than that in the wild type. Thus, the sequence between residues V62 and L65 in NhaA, especially F64, is very important for the inhibitory effect of amiloride on the antiporter.     

Time-dependent deformation in an enhanced SiC/SiC composite

Time-dependent deformation in an enhanced SiC/SiC composite has been studied under constant load at high temperatures of 1200 °C, 1300 °C, and 1400 °C. Creep damage evolution was evaluated by a Young’s-modulus change of partial unloading and microscopic observation. The addition of the glassy phase in the matrix is very effective for protecting the composite from oxidation. The transient creep is dominant in creep life at all the temperatures. An empirical equation is proposed to describe creep behavior of the composite. It is found that creep activation energy increases with creep time at stresses lower than matrix cracking stress, but the activation energy remains constant at stresses higher than the matrix cracking stress. The creep strain rate of the composite is considered to be controlled by creep of fibers based on examining the time, strain, stress, and temperature dependencies of creep strain rates.     

Cloning of a novel signal-transducing adaptor molecule containing an SH3 domain and ITAM

We molecularly cloned a cDNA coding for a novel phosphotyrosine molecule with a 70 kDa molecular mass, named STAM (signal transducing adaptor molecule), which is tyrosine-phosphorylated rapidly after stimulation with various cytokines such as IL-2, IL-3, IL-4, IL-7, GM-CSF, EGF and PDGF. STAM contains an SH3 (Src-homology 3) domain and the ITAM (immunoreceptor tyrosine-based activation motif), suggesting that STAM acts as an adaptor molecule involved in signal transducing pathways from the cytokine receptors.     

Enhanced radiative efficiency in GaN quantum dots grown by molecular beam epitaxy

Self-assembled GaN quantum dots (QDs), grown on AlN by molecular beam epitaxy, were investigated by time-resolved photoluminescence spectroscopy. We investigate the emission mechanism in GaN QDs by comparing the carrier recombination dynamics in single and multiple period QDs. At 100 K, the PL decay time in single period QD structures is considerably shorter than in stacked QDs. Compared to single period QDs, the room temperature PL efficiency is considerably enhanced in 20 period QDs due to the reduction in nonradiative recombination processes.     

Cooperative behavior of various agents in dynamic environment

The multi-agent model is a model in which agents with limited ability cooperate each other to accomplish a goal. In this paper, we introduce a multi-agent model in which agents are created to imitate real ants. There are two different type of agents, each type of which has a particular task. We designed agents to communicate each other by using pheromone considering noise. On this model, we observed cooperative behavior of agents and evaluated conditions to make an order of behavior in the model.     

A new fabrication technology for AlGaAs/GaAs HEMT LSIs using InGaAsnonalloyed ohmic contacts

The authors studied the nonalloyed ohmic characteristics of HEMTs (high electron mobility transistors). At high integration levels, nonalloyed ohmic contacts were found to have two advantages: an extremely short ohmic length with low parasitic source series resistance and direct connection between the source/drain and gate with the same metal. The propagation delay in a ring oscillator with a single-metal source/drain and gate formed simultaneously was 37 ps/gate (L _g=0.9 μm). The very short ohmic metal contacts and just three contact holes made it possible to reduce the memory cell area greatly. The cell is 21.5×21.5 μm², one of the smallest ever reported for a GaAs-based static RAM. Using smaller load HEMTs or resistor loads in the memory cell, combined with nonalloyed ohmic technology with quarter- or subquarter-micrometer-gate HEMTs it is possible to fabricate a very-high-speed LSI such as a 64-kb static RAM with a reasonable chip size